Question about Cars & Trucks

1 Answer

I WANT TO KNOW WHERE IS THE POSITION OF OXYGEN SENSOR BANK 1

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Cars & Trucks Master
  • 450 Answers

I want to know what your vehicle is ?

Posted on Jan 12, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
txkjun
  • 409 Answers

SOURCE: check engine light come on fault codes PO165 and PO155

Yes sorry but they both should be replaced. 

Posted on Dec 26, 2008

ghassun
  • 499 Answers

SOURCE: check engine light is on...bank 1 sensor1 oxygen sensor

if u have one oxygen sensor then u need to take a deep look at the bottom of ur car it will be somewhere at the Exhaust pipe if u have a catalytic converter then u will have two oxygen sensors one before the catalytic converter & the other will be after the catalytic converter. Note: the catalytic converter is located at after a little bit of beginning in Exhaust pipe.

Posted on Jun 06, 2009

emissionwiz
  • 76164 Answers

SOURCE: Replacing bank 1 sensor 2 and bank 2 sensor 1 oxygen sensors

BANK ONE IS THE REAR BANK OF CYLINDERS AND TWO THE FRONT BANK

Posted on Jun 24, 2009

  • 1986 Answers

SOURCE: engine light on code po141 oxygen sens bank 1 sens 2

bank 1 will be whichever side cylinder 1 of your engine is and bank 2 will be the opposite side. It's named bank 1 and bank 2 so that no matter how the engine is laid out, bank 1 is always on the same side as cylinder 1. I cannot say whether the right hand or the left hand one will be bank 1 as I do not know where your cylinder 1 is. The garage should know


Posted on Sep 08, 2009

dttech
  • 4803 Answers

SOURCE: where is the bank 2 sensor 1 located.

Oxygen sensors are always numbered like this:

Bank 1 sensor 1
Bank 2 sensor 1
Bank 1 sensor 2
Bank 2 sensor 2

some manufacturers use a kind of shorthand that reads different, but means the same thing:
Sensor 1/1 or O2s 1/1
Sensor 2/1 or O2s 2/1
Sensor 1/2 or O2s 1/2
Sensor 2/2 or O2s 2/2

Bank 1 is always the side of the engine where cylinder number 1 is located and, of coarse, Bank 2 is the opposite side.
On a 4 cylinder engine, there is only 1 bank and it is always referred to as Bank 1.

Sensor 1 is always the upstream sensor (The one located BEFORE the catalytic converter)
Sensor 2 is always the downstream sensor (the one that is located AFTER the catalytic converter.

Most GM engines have #1 cylinder located on the left bank, (or Driver's Side) of the engine,

So, the answer to your question would be that you are looking for the sensor located before the catalytic converter on the right (or Passenger Side) of the truck.

Posted on Oct 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2009 oyota matrix turns over fine but wont start


code p 2238 refers to heated oxygen sensor(HO2S) 1 bank 1 positive current control --circuit low===causes --wiring short to ground --HO2S
also refers to oxygen sensor (O2) 1 bank 1 -positive current control --circuit ;ow==causes --wiring short to ground ---O2S
also refers to heated oxygen sensor 1 bank 1 ---implausible signal===causes --wiring short to positive, short to ground --HO2S---ECM
at this point I suggest changing the heated oxygen sensor in bank 1 exhaust before the cat converter using the specialist tool as the sensor wires are delicate and subject to easy damage

Feb 15, 2017 | Cars & Trucks

1 Answer

Have code P2238 - what could be the cause ?


code p 2238 has 3 references
heated oxygen sensor(HO2S) 1 bank 1,positive current control---circuit low ====causes ---wiring short to ground ---HO2S
second reference
oxygen sensor (O2S) 1 bank 1 positive current---circuit low====causes ---wiring short to ground ---O2S
3rd reference
HO2S 1 bank 1--implausible signal===causes ---wiring---short to positive ---short to ground ---HO2S---ECM
as the heated oxygen sensor is common with wiring problems indicated , maybe changing it will fix the code
note
HO2S is the sensor in the exhaust manifold in bank1 before the cat converter

Oct 13, 2016 | 2003 Toyota Tundra

1 Answer

How many o2 sensors on a 99 Cadillac catera


Four .
Heated Oxygen Sensor (HO2S Bank 1 Position 1)
Located in RH front pipe of the exhaust catalytic converter
--
Engine Controls Connector End Views in Engine Controls
Heated Oxygen Sensor (HO2S Bank 1 Position 2)
Located in RH rear pipe of the exhaust catalytic converter
--
Engine Controls Connector End Views in Engine Controls
Heated Oxygen Sensor (HO2S Bank 2 Position 1)
Located in LH front pipe of the exhaust catalytic converter
--
Engine Controls Connector End Views in Engine Controls
Heated Oxygen Sensor (HO2S Bank 2 Position 2)
Located in LH rear pipe of the exhaust catalytic converter

Sep 21, 2015 | Cadillac Cars & Trucks

2 Answers

Its not a P0300 it's P0032 and P0038


code p0032refers to heated oxygen sensor(HO2S) 1 bank 1-heater control--circuit high===causes --wiring short to positive--HO2S sensor--ECM
code p0038 refers to heated oxygen sensor(HO2S) 2 bank1 heater control --circuit high===causes --wiring shorted to positive --HO2S---ECM
It is most important that when installing /removing the sensor that the correct tool is used to prevent damage to the wiring for the sensors. Severely twisting the wires during installation/ removal will result in the causes for failure listed.

May 27, 2014 | Chrysler PT Cruiser Cars & Trucks

1 Answer

2002 toyota avalon engine check light on P0078 and P007C


P0050 HO2S Heated Oxygen Sensor -Control Circuit (Bank 2 Sensor 1)

P0051 HO2S Heated Oxygen Sensor -Control Circuit Low (Bank 2 Sensor 1)

P0052 HO2S Heated Oxygen Sensor -Control Circuit High (Bank 2 Sensor 1)

P0053 HO2S Heated Oxygen Sensor -Resistance (Bank 1 Sensor 1)

P0054 HO2S Heated Oxygen Sensor -Resistance (Bank 1 Sensor 2)

P0055 HO2S Heated Oxygen Sensor -Resistance (Bank 1 Sensor 3)

P0056 HO2S Heated Oxygen Sensor -Control Circuit (Bank 2 Sensor 2)

P0057 HO2S Heated Oxygen Sensor -Control Circuit Low (Bank 2 Sensor 2)

P0058 HO2S Heated Oxygen Sensor -Control Circuit High (Bank 2 Sensor 2)

P0059 HO2S Heated Oxygen Sensor -Resistance (Bank 2 Sensor 1)

P0060 HO2S Heated Oxygen Sensor -Resistance (Bank 2 Sensor 2)

P0061 HO2S Heated Oxygen Sensor -Resistance (Bank 2 Sensor 3)

P0062 HO2S Heated Oxygen Sensor -Control Circuit (Bank 2 Sensor 3)

P0063 HO2S Heated Oxygen Sensor -Control Circuit Low (Bank 2 Sensor 3)

P0064 HO2S Heated Oxygen Sensor -Control Circuit High (Bank 2 Sensor 3)

P0065 Air Assisted Injector -Range/Performance

P0066 Air Assisted Injector -Circuit Malfunction or Circuit Low

P0067 Air Assisted Injector -Circuit High

P0068 (MAP) Manifold Absolute Pressure /(MAF) Mass Air Flow - Throttle Position

Correlation

P0069 (MAP) Manifold Absolute Pressure / (BARO)Barometric Pressure Correlation

P0070 Ambient/Outside Air Temperature Sensor -Circuit Malfunction

P0071 Ambient/Outside Air Temperature Sensor -Range/Performance Problem

P0072 Ambient/Outside Air Temperature Sensor -Circuit Low Input

P0073 Ambient/Outside Air Temperature Sensor -Circuit High Input

P0074 Ambient/Outside Air Temperature Sensor -Circuit Intermittent

P0075 Intake Valve Control Solenoid Circuit Malfunction (Bank 1)

P0076 Intake Valve Control Solenoid Circuit Low (Bank 1)

P0077 Intake Valve Control Solenoid Circuit High (Bank 1)

P0078 Exhaust Valve Control Solenoid Circuit Malfunction (Bank 1)

P0079 Exhaust Valve Control Solenoid Circuit Low (Bank 1)

P0080 Exhaust Valve Control Solenoid Circuit High (Bank 1)

P0081 Intake valve Control Solenoid Circuit Malfunction (Bank 2)

P0082 Intake Valve Control Solenoid Circuit Low (Bank 2)

P0083 Intake Valve Control Solenoid Circuit High (Bank 2)
P0084 Exhaust Valve Control Solenoid Circuit Malfunction (Bank 2)

Mar 22, 2013 | 2002 Toyota Avalon

1 Answer

Codes 12,32,55


12 iscamshaft position timing over retarded(bank 1) 32 is oxygen sensor bank 1 55 oxygen sensor resistence bank 1 All of these could be related to the camshaft position sensor being bad.

Jul 31, 2010 | 1996 Plymouth Voyager

1 Answer

Toyota mr2 roadster 2001 engine light on code po141 oxygen sens


bank 1 will be whichever side cylinder 1 of your engine is and bank 2 will be the opposite side. It's named bank 1 and bank 2 so that no matter how the engine is laid out, bank 1 is always on the same side as cylinder 1. I cannot say whether the right hand or the left hand one will be bank 1 as I do not know where your cylinder 1 is. The garage should know

Sep 08, 2009 | 2005 Toyota MR2 Spyder

1 Answer

Engine light on code po141 oxygen sens bank 1 sens 2


bank 1 will be whichever side cylinder 1 of your engine is and bank 2 will be the opposite side. It's named bank 1 and bank 2 so that no matter how the engine is laid out, bank 1 is always on the same side as cylinder 1. I cannot say whether the right hand or the left hand one will be bank 1 as I do not know where your cylinder 1 is. The garage should know


Sep 08, 2009 | 2002 Kia Sedona

1 Answer

My check engine light has come on in my 2006 Pontiac G6 after 2 and a half years. What could possibly be wrong since I keep my car serviced and the guys had just told me that my car was in tip top shape?


P0016 - Crankshaft Position Camshaft Position Correlation Bank 1 Sensor A
P0030 - Heated Oxygen Sensor (H02S) Heater Control Circuit Bank 1 Sensor 1
P0031 - Heated Oxygen Sensor (HO2S) Heater Circuit Low Voltage Bank 1 Sensor 1
P0032 - Heated Oxygen Sensor (HO2S) Heater Circuit High Voltage Bank 1 Sensor 1
P0036 - Heated Oxygen Sensor (HO2S) Heater Control Circuit Bank 1 Sensor 2
P0037 - Heated Oxygen Sensor (HO2S) Heater Circuit Low Voltage Bank 1 Sensor 2
P0038 - Heated Oxygen Sensor (HO2S) Heater Circuit High Voltage Bank 1 Sensor 2
P0050 - Heated Oxygen Sensor (HO2S) Heater Circuit Bank 2 Sensor 1
P0051 - Heated Oxygen Sensor (HO2S) Heater Circuit Low Voltage Bank 2 Sensor 1
P0052 - Heated Oxygen Sensor (HO2S) Heater Circuit High Voltage Bank 2 Sensor 1
P0053 - HO2S Heater Resistance Bank 1 Sensor 1 (PCM)
P0054 - HO2S Heater Resistance Bank 1 Sensor 2 (PCM)
P0056 - Heated Oxygen Sensor (HO2S) Heater Circuit Bank 2 Sensor 2
P0057 - Heated Oxygen Sensor (HO2S) Heater Circuit Low Voltage Bank 2 Sensor 2
P0058 - Heated Oxygen Sensor (HO2S) Heater Circuit High Voltage Bank 2 Sensor 2
P0068 - Throttle Body Airflow Performance (PCM)
P0100 - MAF Sensor Circuit Insufficient Activity

Jun 25, 2009 | 2006 Pontiac G6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...