Question about Cars & Trucks

Open Question

2005 dodge grand caravan how to reset limp mode

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Dodge 2005 Grand Caravan water Pump replacement

JUST COMPLETED THIS JOB TODAY. MAKE SURE THE ENGINE HAS COOLED DOWN . IT TOOK APPROX 2 1/2 HRS. DISCONNECT THE NEGATIVE POST ON THE BATTERY. JACK UP PASSENGER SIDE FRONT AND SUPPORT ON JACK STANDS. REMOVE PASS. FROUNT TIRE. DRAIN RADIATOR INTO CONTAINER FOR PROPER DISPOSAL OR REUSE. USING FLOOR JACK PROVIDE SLIGHT TENSION ON OIL PAN WITH A SHORT 2 X 4 WOOD PIECE TO PROTECT OIL PAN. LOOSEN 3 ENGINE MOUNT BOLTS ON PASS. SIDE OF ENGINE COMPARTMENT. ALLOW APPROX 1" BETWEEN SHOULDER OF BOLTS AND MOUNT. LOWER ENGINE UNTILL BOLTS ARE SET ONTO MOUNT. REMOVE ENGINE SPLASH SHIELD INSIDE WHEEL WELL OF REMOVED TIRE. LOCATE WATER PUMP AND LOOSEN 3 PULLEY MOUNTING BOLTS (THIS IS WHILE BELT IS ON PULLEY) REMOVE SURPENTINE BELT AND CONTINUE TO FULLY REMOVE THE PUMP PULLEY. IT WONT COME OUT AS THE PUMP & PULLEY HAVE TO COME OUT TOGEATHER. REMOVE 5 WATER PUMP BOLTS AND CAREFULLY WORK WATER PUMP OUT BETWEEN THE ENGINE AND VEHICLE FRAME. CLEAN ALL MATING/GASKET SURFACES AND BOLTS. USING A SMALL AMOUNT OF TACKY SEALENT TO INSURE THE NEW WATER PUMP SEAL STAYS IN PLACE, THE INSTALL IS PRITTY MUCH THE REVERSAL OF REMOVAL.

GOOD LUCK, REMEMBER TO TIGHTEN ALL BOLTS TO MFR SPECS AND BLEED THE AIR OUT OF THE COOLANT AS REQUIRED.

Posted on Apr 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reset dodge magnium in limp mode


Limp mode can be reset as eaily as shutting off the car and restarting it. the computer will then retest the system, if the problem is gone you will not go into limp mode. but if the problem is still evident, you will have to have it repaired before it will work properly.

Jan 28, 2012 | 2005 Dodge Magnum

1 Answer

Would like to know what the process is to reset the TCM on a 2002 dodge grand caravan, the van while driving it stays stuck in 2nd gear was told that the TCM needs to be rest i need th precdure how to rest...


if its stay in second speed the computer put the tramission in limp mode because there a problem in the trasmission you need to get your van pass on a scanner to see the code it could simply be the input or output sensor there sensor on the transmission and to reset that simply disconnect the battery for 2 minute after you see your trams will change all speed let me no and thanks for using fixya

Mar 01, 2011 | 2002 Dodge Grand Caravan

1 Answer

2005 grand caravan 3.8. just changed the egr


About 250 miles.before they run test again.

Jul 15, 2010 | 2005 Dodge Grand Caravan

1 Answer

My 2001 dodge grand caravan went into 2nd gear and is stuck there. reverse works good. I have no other problem, fluid level is good.


Trans has one into limp mode, This was programmed into the PCM to get folks home or to the dealer for service. Something is wrong with trans. Any codes???

Dec 30, 2009 | 2001 Dodge Grand Caravan

1 Answer

Reset ''Service Vehicle'' message in 2005 Dodge Caravan


WHEN SERVICE VECHICLE LIGHT COME ON.THE DEALERSHIP HAS TO CHECK OUT EMISSION CONTROL SYSTEM.MAKE SURE ALL EMISSION COMPONENTS IS WORKING PROPERLY.THEN THEY HAVE TO RESET SERVICE VECHICLE LIGHT WITH A SPECIAL SCANNER.

Oct 16, 2009 | 2005 Dodge Grand Caravan

1 Answer

I have a 2000 Dodge Grand Caravan. Lastnight my


Darrell, The trans went into limp mode. 41te trans do funny things. The limp setting is so you can get home or to the dealer. As for the slipping , check fluid first. If ok scan for codes from trans...

Oct 07, 2009 | 2000 Dodge Caravan

2 Answers

My 1996 grand caravan will go in gear but wont shift to higher gears


I am looking for a diagram that shows were the speed sensor is located on the transmission.Of a 96 Grand Caravan.

Jun 03, 2009 | 1999 Dodge Grand Caravan

1 Answer

1997 dodge caravan wont shift out of first gear


Yep ,sounds like limp mode ,should be in second gear.
Try,key on engine off,depress accelerator to floor 3 times within 5 seconds.Should reset trans.

Dec 13, 2008 | 1996 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...