Question about Cars & Trucks

Open Question

Ipm code p0888 2005 dodge grand caravan - Cars & Trucks

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1999 Dodge Grand Caravan horn and Cruise control

I recently had the same issue, but my airbag warning lights also turned on. If this is the case, it might be the clockspring. There is a recall on clocksprings for Caravans 1998 - 2000 I believe. I got it replaced for free in the dealership. Enter your VIN in this site and it will tell you if you are covered in the free replacement warranty.
http://www.chrysler.com/webselfservice/chrysler/index.jsp?screenName=recall&country=us&emailUrl=goToEmailForm%28%27R%27%29

Hope this helps.
Sonny

Posted on Mar 06, 2009

SOURCE: Dodge 2005 Grand Caravan water Pump replacement

JUST COMPLETED THIS JOB TODAY. MAKE SURE THE ENGINE HAS COOLED DOWN . IT TOOK APPROX 2 1/2 HRS. DISCONNECT THE NEGATIVE POST ON THE BATTERY. JACK UP PASSENGER SIDE FRONT AND SUPPORT ON JACK STANDS. REMOVE PASS. FROUNT TIRE. DRAIN RADIATOR INTO CONTAINER FOR PROPER DISPOSAL OR REUSE. USING FLOOR JACK PROVIDE SLIGHT TENSION ON OIL PAN WITH A SHORT 2 X 4 WOOD PIECE TO PROTECT OIL PAN. LOOSEN 3 ENGINE MOUNT BOLTS ON PASS. SIDE OF ENGINE COMPARTMENT. ALLOW APPROX 1" BETWEEN SHOULDER OF BOLTS AND MOUNT. LOWER ENGINE UNTILL BOLTS ARE SET ONTO MOUNT. REMOVE ENGINE SPLASH SHIELD INSIDE WHEEL WELL OF REMOVED TIRE. LOCATE WATER PUMP AND LOOSEN 3 PULLEY MOUNTING BOLTS (THIS IS WHILE BELT IS ON PULLEY) REMOVE SURPENTINE BELT AND CONTINUE TO FULLY REMOVE THE PUMP PULLEY. IT WONT COME OUT AS THE PUMP & PULLEY HAVE TO COME OUT TOGEATHER. REMOVE 5 WATER PUMP BOLTS AND CAREFULLY WORK WATER PUMP OUT BETWEEN THE ENGINE AND VEHICLE FRAME. CLEAN ALL MATING/GASKET SURFACES AND BOLTS. USING A SMALL AMOUNT OF TACKY SEALENT TO INSURE THE NEW WATER PUMP SEAL STAYS IN PLACE, THE INSTALL IS PRITTY MUCH THE REVERSAL OF REMOVAL.

GOOD LUCK, REMEMBER TO TIGHTEN ALL BOLTS TO MFR SPECS AND BLEED THE AIR OUT OF THE COOLANT AS REQUIRED.

Posted on Apr 29, 2009

  • 149 Answers

SOURCE: 2002 dodge grand caravan fuse box

The fuse box is located under the hood. There is component map printed on the inside of the cover. This tells you on your model where the fuse or relay is located

Posted on Jan 19, 2010

  • 1757 Answers

SOURCE: firing order of 2003 dodge grand caravan

For the 2003 Dodge Caravan (and Grand Caravan) ALL 3.3L V6 Engines (including the Flex Fuel): Also for 3.8L V6 Engines:

Firing Order:
1-2-3-4-5-6

Cylinders:
........(back).......
|...1....3....5...|
______________
|...2....4....6...|

Ignition Coil:
.......(back)
electrical connection
...........|
..........V
5........1........3
2........4........6
.......(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

Posted on Jun 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Misfire on #5 cyl


2005 Dodge Grand Caravan 3.8L engine misfire on cylinder 5.

answers.edmunds.com > Edmunds Answers
Aug 14, 2012 - MIL on; cylinder 5 misfire; most noticeable at idle in gear ... This could be caused by an EGR valve that is sticking partly open and not closing ...

OBD-II Trouble Code: P0305 Cylinder 5 Five Misfire Detected

www.obd-codes.com/p0305
A P0305 code means that the the car's computer has detected that one of the engine'scylinders is not firing properly. In this case it's cylinder #5.

ODB Code P0305- Misfire in #5 Cylinder - 2008 Dodge ...

repairpal.com > ... > Grand Caravan > 2008 Dodge Grand Caravan
Feb 22, 2011 - ... do something with a misfire in the #5 cylinder of my V6 4.0L engine. ... ODB Code P0305- Misfire in #5 Cylinder on 2008 Dodge Grand Caravan .... My2005 dodge grand caravan jerks when it shifts into gear what could it be.

My Dodge Grand Caravan has a Cylinder 5 Misfire,? ' Yahoo An


Dec 05, 2015 | 2005 Dodge Grand Caravan

1 Answer

2001Dodge caravan 3.8L engine cranks but won't start, and dash lights and gauges go wacky


05 Dodge Caravan No Start P0688 bad wire - YouTube

? 10:49
www.youtube.com/watch?v=yshodC_crqo
Sep 22, 2012 - Uploaded by Brian Mann 2005 dodge caravan crank no start p0688 asd relay circuit ... butdoing the voltage drop on the back of the connector to the ipm to.... ECM PCM STARTER 2003 DODGE GRAND CARAVAN 3.3L V6 WONT START ... 1996, 97, 98 Dodge Caravan Starter install3.8L V6 - Duration: 8:39. by Gary O 4,364 views.

Sep 12, 2015 | Cars & Trucks

2 Answers

Where is the BCM on 2002 Dodge Caravan


The Body Control Module (BCM) is located in the passenger compartment, attached to the bulkhead underneath the left side of the instrument panel. But, have you checked for a bad brake switch first?

Jul 23, 2012 | 2002 Dodge Caravan

1 Answer

Where is the fuse box on the under dash?


There is no under dash fuse block in this vehicle, only the one under the hood. Here is the description from Dodge.


DESCRIPTION The Integrated Power Module (IPM) is a combination of the Power Distribution Center (PDC) and the Front Control Module (FCM). The IPM is located in the engine compartment, next to the battery. The PDC mates directly with the FCM to form the IPM. The PDC is a printed circuit board based module that contains fuses and relays, while the FCM contains the electronics controlling the IPM and other functions. This IPM connects directly to the battery positive through a four pin connector. The ground connection is through two other connectors. The IPM provides the primary means of voltage distribution and protection for the entire vehicle.

Jan 30, 2011 | 2005 Dodge Caravan

1 Answer

2005 Dodge Grand Caravan. Code check


Cycle the key on, off, on, off. on. Then count the flashes 12 is normal 55 is end of sequence

Feb 06, 2010 | 2006 Dodge Grand Caravan

1 Answer

When driving the gauges twitch, the brake and abs


1. Unplug, Check, and Replug the Accessories Relay located in the IPM-Relay and Fuse Box. This may be starting to fail. There should be an extra Spare Relay of the same size located within the IPM.
OR
2. There is a ground for this circuit that is starting to go bad (corrosion, oxidation and/or poor contact)
OR
3. There is a connection behind the Dash that is loose causing the flickering.
Start with #1 first.

Jan 10, 2010 | 2006 Dodge Grand Caravan

1 Answer

2007 dodge grand caravan power liftgate wont close please help!!


Try replacing the 40amp fuse inside the IPM/Fuse box. Theres a location map on the inside of the cover first.

Dec 29, 2009 | 2006 Dodge Grand Caravan

1 Answer

Power Door Lock Fuse for 2004 Dodge Grand Caravan


there are more in the interior under the dash by the steering column

Sep 23, 2008 | 2004 Dodge Grand Caravan

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...