Question about 2006 Hyundai Elantra

Open Question

Where is a Hyundai Elantra starter located on 2002

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
maklean
  • 1665 Answers

SOURCE: thermostat in a 1997 hyundai elantra

See exploded view
0d68e80.gif

REMOVAL
1. Drain the coolant down to thermostat level or below. 2. Remove the coolant outlet fitting and gasket. 3. Remove the thermostat

Posted on Jun 23, 2008

Ad
  • 1 Answer

SOURCE: location of oil filter on a 2008 hyundai elantra

It is located under the alternator. If you are looking down at the engine, it is to the far left. If you are under the car it is to the far right before the oil pan.

Posted on Feb 09, 2009

ghost45
  • 1280 Answers

SOURCE: 2002 hyundai elantra radio and dome light not working

Then 1, bulbs are burned out
OR 2, the wiring is faulty.

Posted on Nov 04, 2009

Testimonial: "thanx for the solution. took the car to a repair shop and was told that the wiring was faulty. had the car rewired."

  • 94 Answers

SOURCE: How to replace 2004 Hyundai Elantra starter

First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.

Posted on Feb 07, 2010

  • 171 Answers

SOURCE: how to replace 2002 hyundai elantra hub and bearing

With the car on ground, break loose the drive-axle nut, and the wheel nuts , than jack up the car, support it properly, remove the wheel ,remove the axle-nut.
Remove the brake caliper assembly-- support it properly.
Remove the two bolts that hold the hub bracket to the Macpherson strut assemble, remove the lower arm ball joint and remove the steering tie- rod ball-joint attached to the hub bracket. That's it.Slide off the hub /with the bracket off the drive-shaft.
Follow steps backwards to assemble back.

Posted on Apr 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2003 hyundai elantra starter removal where are bolts located on the starter


It's bolted to the outer edge of your transmission. If it's a front wheel drive, it may be near the front of the motor, where the engine and motor connect. Should only have two bolts holding it on. Hope this helps!

Oct 02, 2017 | Hyundai Cars & Trucks

1 Answer

2003 hyundai elantra starter removal


Ok, go to YouTube, and in the search box type: 2003 Elantra starter replace. It will show you a 11 minute video of a guy doing the actual job.
Good luck :)

Oct 02, 2017 | Hyundai Elantra Cars & Trucks

1 Answer

2002 hyundai elantra where is the connector located for code scannner?


it should be located under the dash on the drivers side of vehicle

Jan 06, 2013 | Hyundai Motor 2002 Elantra

1 Answer

Where is the transmission filter located in a 2002 hyundai elantra?


you have to remove the transmission pan and replace the filter and a new gasket

Jul 25, 2010 | Hyundai Motor 2002 Elantra

1 Answer

Hyundai Elantra GLS 2003 starter does not work


it can if you have the proper tools and a little patience its not very hard at all it may be a little snug i cant remember off hand where the starter is located on that car but its relatively an easy fix.

May 21, 2010 | Hyundai Motor 2003 Elantra

2 Answers

Where is the starter located on a 2006 hyundai elantra


LOOK UNDER AIR FILTER.ITS BOLTED TO SIDE OF ENGINE NEXT TO TRANSAXLE.

Apr 11, 2010 | 2006 Hyundai Elantra

1 Answer

2002 hyundai elantra gls windshild washer is not


Check the fuse box if not under the dash on the drivers side kick panel, then under the hood, look in the owners man for the location. With the key on, hold the washer switch on and have someone check for power to the pump motor located in the bottom of the washer fluid bottle if the fuse is good but not getting power to the pump then the wiper/washer switch is your most likely culprit..

Mar 20, 2010 | Hyundai Motor 2002 Elantra

2 Answers

Where is a Hyundai Elantra starter located?


check on the under, backside of the transmission...

Feb 07, 2010 | 2006 Hyundai Elantra

1 Answer

Took transmission pan off and can't find filter


2002 Hyundai Elantra has 2 trans filters. One is inside the pan which is mounted vertically. The other is located on top of the transmission case.

Apr 22, 2009 | Hyundai Motor 2002 Elantra

1 Answer

Where is the iat sensor in a 2002 hyundai elantra?


It's part of the MAP sensor. It is located on the intake manifold plenum. When looking from the front, the sensor furthest left.

Apr 05, 2009 | Hyundai Motor 2002 Elantra

Not finding what you are looking for?
2006 Hyundai Elantra Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...