Question about 2001 Toyota Sequoia

Open Question

How to remove left front fender 2001 toyota sequoia

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1348 Answers

SOURCE: DIAGRAM FOR 2002 TOYOTA SEQUOIA STARTER REMOVAL

the big red cable from the battery goes right to it.

Posted on Sep 09, 2009

  • 1986 Answers

SOURCE: replacing tail light bulbs on 2001 Toyota Sequoia

Remove the two screws holding the tail light cover in place along the edge of the tail light assembly.

After you remove the two screws in the back panel, you have to pull the assembly out towards the side of the vehicle. You cannot pull it straight back from the trunk or you will break the pins that hold the lens cover onto the side of the SUV.

There are two pins that allow the light cover to be secured against the back of the truck. One pin is towards the top, the other pin is towards the bottom.

Twist out the bulb assembly.
Pull out the bulb
Insert the new bulb
Twist back in the bulb assembly
Place the pins over the pin holes in the light cover mold on the side of the truck
Push in gently Replace screws and you are done.

Posted on Nov 02, 2009

  • 215 Answers

SOURCE: how do I replace brake rotors on a 2001 toyota

remove the tire, there should be two bolts holding the caliper on, remove these two bolts, the caliper will be able to slide off and out of the way, the rotor should be able to come off, or you will have to give it a few taps, remove the old one, make sure you have the proper rotor, and place it on the hub, the brake pads should be replaced at this time, the pads will pop out easily, now you will have to compress the piston with a C clamp and one of the old brake pads, once the piston is back in place the new pads can be snapped into place and now the caliper can go back on and tighten the two bolts, put the tire back on.

Posted on Nov 03, 2009

  • 1 Answer

SOURCE: replacing fender toyota corolla?

My Corolla's (AE100) RPM Counter does not read correctly

Posted on Mar 29, 2010

duane_wong
  • 6826 Answers

SOURCE: 2001 Toyota Sequoia is showing a P0505 and PO420

P0505 Idle Control System Malfunction

IACV or Idle Air Control Valve if equipped is malfunctioning.

P0420 Catalyst System Efficiency Below Threshold (Bank #1)
The Catalytic converter is not working up to par in Bank#1.

I think this will point you in the right direction..



Posted on Jul 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 sequoia front ac blower not working, blower motor is OK


Sounds like a Controller Issue with the Climate Control. Seeing that you applied power and it worked, then it is not the Motor.

UNLESS you try it on ALL SPEEDS and if it then does not work, you have an Input problem.

If it only works on ONE SPEED, then you have a Resister Issue for the Blower

Apr 06, 2013 | 2003 Toyota Sequoia

1 Answer

Need to remove fuel line from a toyota sequoia


Is connected to the fuel rail, under intake plenum,

Mar 26, 2013 | 2001 Toyota Sequoia

1 Answer

2001 Toyota Sequoia Oxygen sensors


No the wires won't likely be the same length

The front upstream sensors, are not the same
Part # as the rear,downstream monitor sensors

Go to Rock Auto.Com & look up your oxygen sensors
I would get the NTK or Bosch,if they have that

You do not replace the rear sensors, until they fail

You replace the front ones at 100,000 miles or sooner,
if they fail

Jun 02, 2012 | 2001 Toyota Sequoia

1 Answer

2001 Toyota Sequoia O2 sensor locations and fix


O2 sensor is mounted on exhaust system near engine before cat converter can't help with rest of question sorry

Jun 02, 2012 | 2001 Toyota Sequoia

1 Answer

How to remove the front rotors on a 2006 Toyota sequoia


On the 2008 Sequoia there are two threaded bolt holes amonst the lugnut studs. Thread a couple of bolts into those and screw in with a ratchet or wrench - walking the rotor off. Worked easily for me.

Apr 15, 2012 | 2006 Toyota Sequoia

1 Answer

Key will not turn when inserted in ignition for 2001 sequoia toyota


have you got a an answer? you just need to keep a hand on the key to turn and the other hand on the steering wheel move it both ways (left and right) gently!
if problem stays, means you need to change the switch assemb. may be a kid inserted some thing in it!! or theft trial!

Oct 22, 2010 | 2001 Toyota Sequoia

1 Answer

What is the part name for the piece under the grill assembly that wraps to the fender


that part is called the bumper guard its made of pvc plastic its rated at a crash rating of 5 mph front end collision its not the actual bumper the bumper is what its bolted to and thats made of a piece of 1/4'' plate steel.

Dec 20, 2009 | 2001 Toyota Sequoia

1 Answer

BROKEN REAR DOOR HANDEL AN WINDOW WONT GO DOWN!


using small hook tools and tack pullers shaped like mini wonder bars, you can remove the door panel. once removed, you can fish around on the bottom middle of the door and pull the cable to unlatch the door.

Apr 14, 2009 | 2001 Toyota Sequoia

1 Answer

2004 toyota sequoia front end shake


Replace the front rotors.
Refacing does not work on Sequoias. The metal removed to get the rotor "true" is usually below minimum safe thickness, and the vibration comes right back when it gets hot.

Oct 16, 2008 | 2004 Toyota Sequoia

Not finding what you are looking for?
2001 Toyota Sequoia Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...