Question about 2006 Hyundai Tucson

Open Question

How do you replace a headlight bulb in a 2006 tucson?

Posted by on

6 Suggested Answers

bunnydawg
  • 5158 Answers

SOURCE: how to replace a headlight bulb on 2006 f 150

they are replaced from inside the engine compartment at the rear of the headlight bazals. if it's the side the battery is on you will likely have to remove it first.

Robert

Posted on Jan 13, 2009

  • 1 Answer

SOURCE: 2006 Trailblazer Headlight Replacement

There are not two rods, there are two clips one under fender weild and one right above the light on top of the cover. Pull up on these two clips and pull the light forward a couple of inches and remove the dust cover. You have to take the air filter cover off to be able to reach in and replace the light. It took me about 10 min to figure these out but hope it helps out.

Posted on Jan 14, 2009

jgwhomeequip
  • 1902 Answers

SOURCE: replacing headlight bulbs on a 2006 chrysler sebring

Behind the headlight you should see a eletrical wires running to the headlight section. There will be a 2 inch round plastic ring. You grap the back of the bulb and turn it to the right which will release the bulb and the socket. You pull out the bulb and replace it the same way. If this doesnt help then get back to me.

Posted on Feb 06, 2009

bunnydawg
  • 5158 Answers

SOURCE: how do I replace a headlight bulb in a 2006 aveo

you can access the bulbs from inside the engine compartment. the socker turns about a quarter turn to remove it. do NOT touch the bulb with your fingers as that will shorten the bulb life. you may have to remove the battery to change the one on that side.

Posted on Mar 07, 2009

ghost4548
  • 776 Answers

SOURCE: how do i change right headlight bulb on a 2007

You change it like you'd change any headlamp bulb. There is an access cap behind the headlamp assembly -- remove it, then remove the connector to the bulb, then remove the retaining clip/spring holding the bulb in place. Then install/insert the new bulb in the same 'ORIENTATION' as the old one. Reinstall in reverse order... ALAKAZAM!... .done!

Posted on Jun 25, 2009

  • 1986 Answers

SOURCE: headlight aiming

on each headlamp assembly, there will be either one or two plastic nuts that you can turn.

If you only have one nut on each, that will adjust the vertical aim of the headlights.

If you have two nuts on each, one will adjust the vertical and the other will adjust the horizontal.

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

Posted on Sep 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2008 Mazda 5 minivan how do I change the headlight bulb


Headlight Change 2006-2010 Mazda 5 - CarCareKiosk

www.carcarekiosk.com/video/2009_Mazda_5_Sport_2.../headlight
This free video shows how to change a burnt out headlight on a 2009 Mazda 5 Sport 2.3L 4 Cyl.. Complete instructions for replacing a head light bulb on a 2009 ...

Low beam head light bulb replace 2000-2006 Mazda Mpv ...

? 5:11
https://www.youtube.com/watch?v=kblzMLRJrok
Jun 29, 2013 - Uploaded by hp11208
Low beam head light bulb replace 2000-2006 Mazda Mpv .... My step dad and I successfully replaced a headlight yesterday! :-) ...I've lost it trying to replace the bulb. if anyone can let me know I would really appriciate it thanks ! ..... 5:00. Cleaning your IAC to fix rough idle on 2000 or 2001 Mazda MPV ...

Nov 29, 2015 | Mazda Cars & Trucks

1 Answer

Headlight & sidelight bulbs


Yes the lights are seperately fused.

Feb 11, 2014 | 2006 Hyundai Tucson

1 Answer

I have a 2006 tucson, one headlight low beam doesn't work but the high beam does. i have changed the bulb, and relay fuse and still nothing, any ideas?


I suppose my clarification was more of a possible solution. Looking for other thoughts or ideas as well. I can live without the high beams. I can't live without my low beams!

Sep 21, 2011 | 2006 Hyundai Tucson

1 Answer

Hi, I have a 2006 Hyundai Tucson. I love my Tucson except for one thing, it keeps blowing headlights. I have never had this issue with any other vehicle. I see that it seems to be a common issue with...


Have your voltage checked. This is usually done with an alternator test at a local autoparts store. If that checks out look closely at the mounts for the headlight and make sure its not loose. Vibration can cause bulbs to blow. Make sure there is no moisture in the lens. Water will cause it to blow.. Lastly when you replace the bulb do not touch the glass. The oil from your skin will cause it to blow early.

May 20, 2011 | Hyundai Tucson Cars & Trucks

1 Answer

Headlight lense foggy


buy a replacement headlight assembly on ebay.

Dec 16, 2010 | 2006 Hyundai Tucson

1 Answer

Instructions on how to replace drivers side


Open hood, reach behind headlight. If necessary remove battery and coolant overflow tank.
Then reach in behind headlight. There will be a plastic ring on back of headlight. Turn counter clockwise and pull back and slide back out of the way. Then grab the headlight bulb, turn counter-clockwise and pull back to remove. Then unclip the wire harness from the bulb itself and reverse procedure to replace.

Nov 28, 2009 | 2005 Hyundai Tucson

1 Answer

Fog Lamp Bulb Replacement, 05 Tucson


remove headlamp assembly and you can get it from the top pretty easy

Feb 25, 2009 | 2006 Hyundai Tucson

2 Answers

Replacing headlight bulbs on a 2006 chrysler sebring


Behind the headlight you should see a eletrical wires running to the headlight section. There will be a 2 inch round plastic ring. You grap the back of the bulb and turn it to the right which will release the bulb and the socket. You pull out the bulb and replace it the same way. If this doesnt help then get back to me.

Feb 06, 2009 | 2006 Chrysler Sebring

1 Answer

Headlight aiming


on each headlamp assembly, there will be either one or two plastic nuts that you can turn.

If you only have one nut on each, that will adjust the vertical aim of the headlights.

If you have two nuts on each, one will adjust the vertical and the other will adjust the horizontal.

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

Dec 17, 2008 | 2006 Hyundai Tucson

Not finding what you are looking for?
2006 Hyundai Tucson Logo

Related Topics:

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...