Vw sharan petrol engine manegement light stays on 2000 reg

6ya staff

• 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

6ya - Get Instant Help

6ya.com

Need repair answers fast Use 6ya to...

Posted on Jan 02, 2017

Ronald Mueller

• 1263 Answers

SOURCE: vw sharan 1996 1.9 petrol

have you checked the fluid level? ther could be several reasons. #1 low fluid level.#2 engine speed sensor.# transmission control module.#4 the solenoids in transmission gummed up or malfuntioning. have these checked out

Posted on Sep 01, 2008

SOURCE: 06 vw sharan 1.9tdi exhaust warning light on

check the air flow meter as well the two are linked,if you fit a new egr it will need to be programmed to your car,..when the egr is working you should get a drop in airflow,if you dont then the egr is stuck open...when it closes your airflow should go back up..

Posted on Dec 06, 2008

yadayada

• 78289 Answers

SOURCE: The glow plug light flashes while the engine is

this means you most likely have a burnt out glow plug or glow plug timer control or both

Posted on Mar 18, 2009

Greg Bernett

• 2984 Answers

SOURCE: How do I change the alternator in my vw polo p reg

Alternator belt routing — all except VR6, with power steering, no A/C

1. Disconnect the negative battery cable.
2. Disconnect the wiring from the alternator. If necessary, mark the wires with tape or other means to ensure they are connected properly upon installation.
3. Loosen the belt tension, and remove the drive belt from the alternator. On VR6 (AAA) engines only, remove the belt tensioner from the cylinder head.
4. Remove the alternator adjustment bolt, followed by the pivot bolts.
5. Carefully lift the alternator from the bracket. To install:
   
6. Hold the alternator in position on the mounting bracket, and install the pivot bolt. On later engines with automatic belt tensioners, install the upper mounting bolt.
7. Install (but do not tighten) the alternator adjustment bolt (earlier models only).
8. Place the alternator drive belt on the pulley.
9. Adjust belt tension and tighten the mounting and adjustment bolts as necessary.
10. Connect the wiring to the alternator. If tape was used to identify the wires, make sure it is removed once the wires are connected.
11. Connect the negative battery cable.

Posted on Jul 15, 2009

SOURCE: vw sharan timing belt change?

your getting close to a change, especially if its a belt and not a chain. i know friends that had there belts changed out anywhere from 60k to 90k. Chains can go about twice as long as a belt. i you kept this car up on it servicing and dont abuse it. i"d say it"ll last till at least 70k.

Posted on Oct 04, 2009