Question about Renault Grand

Open Question

Df137 trouble code

My renault clio wont rev past 3000 revs and launch has thrown up df317 trouble code

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Richie_asg1
  • 1036 Answers

SOURCE: renault clio 1-5 dci (2002)

Hi there!

It's very likely a valve stem seal that has split. This will allow oil into the cylinder from the crank gallery.

Off with it's head! I'm afraid.

The only other thing it can be is overfueling - but then it will be sputtering and lagging on acceleration.
You can check which cylinder is affected by removing the plugs and looking for the oily one. They will all need replacing really as it's false economy to do just 1. The seals are cheap. I would get a new cambelt fitted at the same time - as it has to come off anyway.

(If this leads to a solution, please take the time to rate as Fixya! - Thank you)

Posted on Jun 17, 2008

demonram440
  • 42 Answers

SOURCE: 1997 ram 1500 5.9 wont rev past 2000 rpm

well, the timing on your ram is computer controlled. is the truck in drive when this mis-fire occurs? or at idle? youve addressed part of your ignition w/the cap-rotor-plug wires. did you examine the old cap for carbon tracking? did you install the rotor properly? i know on my '97 ram the dist is feakin' buried in the engine it would be easy to rotate the rotor while installing/removing it so the timing mark is off. does your engine have the right plugs installed? your plug wires follow the correct firing order with your dist? you did not mention anything about your ignition coil. here is how to safely remove and check your ignition coil. disconnect battery-at the coil disconnect the lead wire (TOP) and primary (BOTTOM) from the coil. label your wires, or take a pic of your ign coil before you remove it so if you forget where the wires go, you have reference point. remove mounting screws and remove coil. clean coil to remove rust/dirt and wipe coil terminals off. inspect case for damage. with a multi-meter, check coil primary resistance by selecting ohm's and then place + and - leads on the pos/neg terminals on the coil, dodge used 2 brands of coils either a "diamond" or a "denso" primary resistance for the diamond mfr'd coil will be between 0.97-1.18 ohms. secondary resistance 11,300-15,300 ohms. Denso primary resistance 0.95-1.20 secondary resistance of 11,300-13,300 ohms. to measure secondary resistance place one of the leads to one the primary terminals and the other lead attatch to the large center terminal. compare your readings to the above values. if your readings are not within range of the above values, your problem is the ignition coil. other causes you may consider is faulty: speed sensor, throttle pos sensor/trans issues like bad pressure solenoid (actuates gear changes) a fault in your overdrive system. hope i have helped!

Posted on Feb 27, 2009

  • 1 Answer

SOURCE: renault traffic 03 1.9dci low power until turbo

my trafic did the same.no power pulling away until the turbo kicked in and it turned out to be the airflow meter.Hope this helps as it cured mine.Plus non of them rev past 3800 revs its normal.

Posted on May 26, 2009

  • 40 Answers

SOURCE: showing random misfires running lean wont rev up right

http://www.kiatechinfo.com/index.asp

Good source for Kia its free to register NO STRINGS

Posted on Jun 01, 2009

  • 1129 Answers

SOURCE: engine will not rev above 3000 rpm

Inadequate fuel pressure, change the fuel filter first, make sure the car sits for at least two hours before replacing the fuel filter because these fuel lines are under high pressure during the time of operation. The pressure usually decreases over time in the lines but wear safety glasses just the same, I would recomend depressurizing the fuel system first, buy a Haynes repair manual for detailed procedure to be safe. If problem persists go to Auto Zone and ask them to check for trouble codes these codes if present may instuct you in detail to replace the MAF sensor or give you a code that must be looked up to find the problem.

Posted on Jul 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hyundai sante fe 2007 2.2crdi wont rev past 3000 rpm


If your standing still in park it wont rev past 3000 rpm as its got a limiter on it And only revs past 3000 rpm in drive on the move.

Sep 27, 2016 | 2007 Hyundai Santa Fe

1 Answer

Why mahindra scorpio rev ccount do not exceed 3000 rpm?.when diagnosed it gives diagnostic trouble codes DF022 and DF137.


We do not have this make here in the USA, we can diagnose the "P" series powertrain OBD2 fault codes but these body codes are a "no info available" Keep in mind we are in California USA.

Sep 02, 2016 | Mahindra Cars & Trucks

2 Answers

96 grand cherokee wont rev past 3000


The 4.0 and the 5.2 engines are dauntless. I expect something external to the engine such as I've listed

Have the OBD scan checked for engine error codes!!
  1. Very dirty air Cleaner/Mouse nest in air box
  2. Dirty fuel filter -starving for gas
  3. Failing Fuel Pump
  4. In tank fuel filter
  5. Plugged catalytic converter
Have the fuel pressure checked

Jan 17, 2016 | Cars & Trucks

1 Answer

2002 jaguar xj8 when I drive it won't go over 3000rpm


Jaguar wont rev 3000 rpm Questions & Answers - Fixya

www.fixya.com > Forum > Tags > wont rev 3000 rpm
1998 Jaguar XJ8 won't rev over 3000 rpm ... Wont go beyong 3000 Revs s type 2001, wont go beyond 3000 Revs and it' in limp ... Question about 2002 X-Type ... My jaguar xjr8 year 2000 battery went dead started car went for short drive back ...

Jaguar engine cuts 3000 rpm Questions & Answers - Fixya

www.fixya.com > Forum > Tags > engine cuts 3000 rpm
1998 Jaguar XJ8 won't rev over 3000 rpm ... engine cuts out and shudders at 3000 rpm won't accelerateobd code p0332 2002 jaguar x type 3.0 l P0332 - Knock ... Car is boging out in park and will not go over ... driving, don't worry about it.

Rev Won't go up

www.jaguarforum.com/showthread.php?t=14662

Dec 15, 2015 | Jaguar Cars & Trucks

1 Answer

Rev counter bouncing when car is in idle


this is indicative of faulty crank sensor as that where the rev's are counted from , have the OBD codes read , Renaults are notorious for this and will need the updated wiring loom as well as the sensor to do the job properly

Oct 15, 2014 | 2005 Renault Clio 1.5

1 Answer

98 slk 230 komppressor revs smooth through to 3000 revs then stutters as if its hitting a rev limiter and won't rev anymore, i have been told it may be an air intake issue can you help?


it going into limp mode the most common problem is the air mass sensor it sends message to your ecu this is why it wont rev past 3000 the sensor is in the airfilter and intake pipe hope this helps

Feb 03, 2010 | 1998 Mercedes-Benz SLK

1 Answer

Clio wont 'rev up'


This is quite often due to the throttle potentiometer which is the electronic  version of the throttle cable.

It comes as a unit and is a d-i-y job to replace if you are mechanically minded

Sep 24, 2009 | 2006 Renault 181

1 Answer

Engine cut out on clio 172


some rev limitors have a reset.check owners manual for location

Aug 05, 2009 | 2000 Renault 181

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

788 people viewed this question

Ask a Question

Usually answered in minutes!

Top Renault Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

xxxxxx xxx

Level 3 Expert

4836 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Are you a Renault Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...