Question about Chevrolet Silverado 1500

Open Question

Chevy silverado seat belt won't fasten

Seat belt won't fasten

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 840 Answers

SOURCE: All the back seat belt stuck, and you can not fasten them?

pull the back seat bottom up. should be able to pull forward and up

Posted on Jan 24, 2009

  • 462 Answers

SOURCE: seat belt retractor stuck, will not come out more than 8 inches

THERE IS A COUNTER WEIGHT INSIDE OF THE RETRACTOR THAT IS CAUSING YOUR PROBLEM. UNFORTUNATELY YOU WILL NOT BE ABLE TO FIX IT, UNLESS OF COURSE THERE IS SOMETHING STUCK INSIDE OF THE RETRACTOR.

Posted on Jun 02, 2009

  • 1382 Answers

SOURCE: Seat belt stuck

Open small plastic access panel located between front and rear doors a few inches above floor. Disconnect the two wire connector (usually attached to car frame) and locate the male pin connector, usually 1 red and 1 blue wires. Run two long wires from a car battery negative post and positive post (battery on the car or separate.) Hold one wire against one pin of the connector and quickly touch the other wire against the remaining pin. This will cause the motor to turn in one direction. If motor turns in wrong direction simply reverse the wires until motor brings belt to desired position then quickly remove the wires. Reattach connectors to resume 'normal' operation after 'CAUSE' has been repaired.

Posted on Aug 27, 2009

  • 11 Answers

SOURCE: Disabling seat belt chime in a 2007 Silverado

Unfortunately if you take this to a shop they can get into alot of trouble doing this for you. Some are controlled by the body control module and others are just simple circuits. Look at you seat belt female end and look for a harness that goes to it. If it's just 2 wires connect those two wires together to trick the system! You should always wear your seatbelt by the way.

Posted on Sep 03, 2009

  • 543 Answers

SOURCE: seat belt won't buckle

sounds like you need a new buckle assembly

Posted on Oct 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace seat belt on 10 chevy silverado


Buy the GM Seat Belt Driver tool from
Snap-On & remove the bolts

Mar 02, 2013 | 2010 Chevrolet Silverado 1500

1 Answer

I have a 99 Silverado and the passenger side seat back will not lock back into the upright position. Locks fine into reclining positions. What could be the problem?


i had this problem on my 96 chevy, basically theres a set of ratcheting gears that lock the seat in place in the various positions. sometimes over time or due to abuse one side or the other gets stripped out and the seat will no longer lock into place. i found a ripped up seat on Craigslist that was in a part out truck and bought it cheap then took both seats in the an upholstery shop, between the junked out seat (15 bucks) and the labor at the shop (50bucks) it cost me 65 bucks to fix, hope this helps

Mar 13, 2012 | 1999 Chevrolet Silverado 1500

1 Answer

Seat belt pasenger seat


Are you trying to say the seat belt retractor is stuck? This is in the front seat?
If it's anything like my Tahoe, you need to remove the plastic panel that covers the retractor (carefully - don't break the clips or you won't be able to put it back on). Take a large flat head screwdriver and slide it under the part where the seat belt coils up, and find a little tab - push it with the screwdriver. As long as the seat belt is not twisted up, it should retract.

Nov 30, 2011 | GMC Cars & Trucks

1 Answer

Remove the back seat from chevy celebrty 1987


Push lower end of rear seat back to unlock clips (takes a bit of effort)
Lift bench out
Should be clips or bolts holding the top of the rear seat - release these
Push up on the upper section of seat to release top clips.
in some car models
Remove the 10mm bolt behind the bench near the seat belt fastening sight and then lift the seat up from the back to the front..towards the front seats. The clips are angled down and in so that the back has to lift up first.
This will help. Thanks please keep updated. please please do rate the solution positively .thank you for using fixya

Mar 18, 2010 | 1987 Chevrolet Celebrity

1 Answer

2005 chevy 2500 How Do I remove the rear seat


there must be one hidden bolt left check that the seat belts aren't holding you back

Nov 18, 2008 | 2005 Chevrolet Silverado 2500HD 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...