Question about 1998 Ford Windstar

1 Answer

02 oxygen senosor

How do i change it

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 74 Answers

There is more then one 02 sensor on this car witch one you need to replace? Most you can change with a 7/8 wrench

Posted on Jan 12, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 toyota alvalon check engine light keeps coming on for code p0171 after replacing 02 oxygen sensor in bank 1


code p 0171 refers to system too lean bank 1===causes ---intake /exhaust leak---AIR system---MAF/VAF sensor/s---fuel pressure/ pump---injector/s---heated oxygen sensor (HO2S) the one in the exhaust manifold for bank 1 nearest the firewall

Apr 15, 2017 | Toyota Cars & Trucks

1 Answer

Po136-o137 says change 02 sensor on bank 1 sensor2 I did but engine light is still on 2004 chevy tahoe


code p 0136 refers to heated oxygen sensor (HO2S) 2 bank 1 ---circuit malfunction===causes ---heating inoperative ---wiring---HO2S--- ECM
also refers to oxygen sensor (O2S0 2 bank 1---circuit malfunction===causes --- wiring---O2S ---ecm
it also refers to heated oxygen sensor (HO2S) 2 bank 1 ---no signal===causes ---wiring --- HO2S---
code p 0137 refers to HO2S 2 bank 1 ---low voltage -===causes --exhaust leak---wiring short to ground ---HO2S--- ECM
it also refers to O2S 2 bank 1---low voltage ===causes exhaust leak---wiring short to ground ---O2S ---ECM
to set you up here-- there are 4 oxygen sensors in the system
2 are heated oxygen sensors (HO2S) on in each exhaust manifold or exhaust pipe before the cat converter and
2 oxygen sensors (O2S) -- one in each exhaust pipe after the cat converters
heated oxygen sensors have 4 wires and O2S sensors normally only 2 wires
it is more that possible that you changed the wrong sensors and in the process damaged the delicate wires with the incorrect spanner being used

Jul 25, 2016 | 2004 Chevrolet Tahoe

1 Answer

How to change an oxygen sensor on a 2006 Buick rendezvous


The trouble code should tell you which 02 sensor? The 02 sensors are in the exhaust, sensor 1/sensor2, whatever, bank 1/bank2, whatever, before the cat, after the cat. You have several 02 sensors in the exhaust, don't know which one?
You should be able to remove/install with proper size wrench or deep socket. They do make an 02 sensor socket that has that slot in it, not sure if you need that, though.

Jan 25, 2016 | 2006 Buick Rendezvous

1 Answer

My Dodge Stratus (1998 4 cyl) check Engine light is on. The error code says oxygen sensors were bad. Both oxygen sensors have been replaced. After resetting the check Eng light. The oxygen sensor


the upper 02 sensor is for air fuel mix while the secondary 02 sensor is for the operation and status of the catalitic converter are you sure the catalitic converter is not plugged. Could be if you have had a loss of power

Sep 16, 2014 | 1998 Dodge Stratus

1 Answer

What is an 02 sensor upstream 98 astro van


02 sensor is your oxygen sensor, 98 chevy astro carries 3 oxygen sensor. i belived your bad sensor is on the passenger side by the exhaust manifold but if not try the drivers side all the oxygen sensor for this van are the same. you need to go under the van to replace it, if is to hard to get it out turn your van for five minutes then turn it off and try again, be carefull not to burn your self. the one close to the catalytic converter is the downstream oxygen sensor ok, good luck!!!!!!

Jun 28, 2014 | 1998 Chevrolet Astro Van

1 Answer

Iam lossen power when i push on the gas dosent want to go, I replaced the Throddle postion sencor and the code for that went off, now the code P0038 is on and that is heat senosor, that wouldnt caues the...


I will say no to your question

But you do have a possible failed oxygen
sensor heater,google the code & read up

Any time you get codes you don't change parts
Code only point you to a system that reported an
out of range condition
You use codes to component test & only replace
a fail part when you know how to test for one.

The front or upstream O2 Sensors are probably old
& close to 100,000 miles,so you can change them

The O2 issue will effect fuel trim or proper fuel delivery
but not cause your problem by itself,you have a second
issue to find.

Maybe old spark plugs,ignition misifres,old partially blocked
exhaust converter,maybe all of that

Aug 27, 2013 | 2002 Kia Rio

2 Answers

I have a 2000 chevy suburban with codes p1133 and p0131 what is the pooblem


P1133 indicates heated oxygen sensor insufficient switching bank #1 sensor #1. P0131 indicates voltage from that sensor is staying low more than 2 minutes. That sensor could be bad or it could indicate a rich condition.

May 10, 2011 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

I have a 1993 pontias sunbird that needs an oxygen sensor. what is that and how many would i need to purchase?


there is only one oxygen(02)sensor on this car.it is located in the front exhaust pipe,it measures the amount of oxygen in the exhaust so the computer can change the amount of injector on time for fuel control.it is a single wire sensor that is threaded in the pipe.

Mar 28, 2011 | 1993 Pontiac Sunbird

1 Answer

P1176 2000 VW JETTA ALREADY CHANGED THE 02


17584/P1176/004470 - Bank1: O2 (Lambda) Correction Behind Catalyst: Control Limit Reached Possible Causes
  • Intake Air System leaking
  • Oxygen Sensor(s) and/or Oxygen Sensor Control faulty
Possible Solutions
  • Check Intake Air System for Leaks (False Air)
  • Check Oxygen Sensor(s) and/or Oxygen Sensor Control (all of them!)
This is the pre 02 sensor located before the catalytic converter.

May 10, 2010 | 2000 Volkswagen Jetta TDI

Not finding what you are looking for?
1998 Ford Windstar Logo

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...