Question about 2000 Dodge Caravan

1 Answer

2000 ford f150 no heat change heater core and thermostat cold air help!!

Y no heat is coming out

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 4 Answers

Sounds like you may have a blend door issue in the heater box. Ford had a replacement inner box to help with the problem. The door was hinged on a plastic pivot which would break. Some also had electric motors that would strip the gears inside the unit and not move the blend door to the heat position.

Posted on Jan 12, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 7 Answers

SOURCE: i have a 2000 dodge caravan, no heat

Sounds like the air "blend" door might be inoperable. This door opens and closes a specified amount to regulate the amount of either cooled or heated air, as requested by the climate control unit. If the door is continually in the position which is bypassing the heater core (cold setting), the air will not get warm regardless of the condition/operation of the heater core. I'd suggest having this component checked.

Posted on Nov 28, 2008

  • 651 Answers

SOURCE: heater blowing cold air

squeeze the hoses to get any air bubbles out and refill coolant as necesary. are you sure you put thermostat in the right way? may be backwards. also may be your sensor.

Posted on Jan 04, 2009

  • 7353 Answers

SOURCE: 2002 dodge 1500 Changed radiator, thermostat, and hoses. No heat

Why was radiator replaced?Did it have heat before ? If it was plugged, the heater core may also be plugged. Try flushing it with a water hose in both directions. I dont know why the botton radiator hose would be cold, the radiator should be a uniform temp and the air coming through the radiator should be HOT, when the engine is at operating temp. What condition was the old coolant? if it was rusty, the water pump may have lower flow than normal.

Posted on Nov 19, 2009

  • 55 Answers

SOURCE: 2000 dodge stratus why does heater only blow only

heater core. or air lock

Posted on Dec 06, 2009

  • 3 Answers

SOURCE: Low to No Heat in 1998 Dodge Durango

I'm going to try that tomarrow after I get up.hope it dose the trick

Posted on Feb 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My jeep cherikee is over heating and the trans over heat message comes on


when it comes to overheating theres too many things to list. first is your coolant overheating causing trans to over heat or is it the trans overheating causing the coolant over heating. is the fan working correctly? full of coolant and not just water?

Sep 14, 2014 | Cars & Trucks

1 Answer

Heat comes tru passengers side console vents and normal thru drivers side


look under dash to make sure vent door is working proper

Apr 20, 2014 | 2010 Ford Flex

1 Answer

Heat does not work in 96 gs300 . when u turn heat on cold air comes out


the heater core may have gone bad or is cloged. if you can find the return line of the core pull off the hose and see if any thing comes out

Dec 19, 2013 | 1996 Lexus ES 300

1 Answer

No heat turned on but no heat coming out


Try turning on the heat and see if heat comes out? If you turn on the heat and cold air blows you may have a bad heater core. More than likely a repair shop would need to fix it.

Nov 26, 2013 | 2001 Hyundai Sonata

1 Answer

Jeep liberty heater


check the blend door actuator.

Nov 06, 2013 | Cars & Trucks

1 Answer

My 1998 Subaru the heat comes on and off gauge goes up to high then back down but doesn't over heat?


need a drive to be honest so i would know whats wrong ,ask a local mechanic to have a look as it could be a cooling fan or a thermostat maybe even the water pump drive shaft to impeller come loose

Jan 03, 2013 | Subaru Cars & Trucks

1 Answer

Soon as i turn on my heat my cooling fans come on first


It sounds like you do need a thermostat with your heat shut off and the gauge will raise a little then the car doesn't have that heat drawn from it indicating that you most likely do need a thermostat. As far as the fans coming on immediatly that could be a different problem it is most likely the coolant temperature sensor that tells the fan's when to come on. If this sensor says the coolant is hot the fans will come on immediatly. These are seperate problems as the coolant temperature sensor does not have anything to do with the cabin heating system. You should first check the level of your coolant is full, This could also cause your cabin heating system to perform poorly, and may have adverse effects to the engine cooling system. (fans)

Dec 31, 2009 | 1995 Nissan Maxima

1 Answer

Heat light switch comes on..but the heated seat is


MORE THAN LIKELY THE HEATING ELEMENT HAS MALFUNTIONED. ITS A PRETTY COMMON PROBLEM IN HEATED SEATS

Nov 29, 2009 | 2003 Ford Expedition

Not finding what you are looking for?
2000 Dodge Caravan Logo

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...