Question about Chrysler Concorde
Car shakes when 45 mph is reached. Goes away when I take my foot off the gas pedal. Reaccurs at 60 to 65mph. I put wrong tranny fluid in right before this problem started?! Stumped!!
Sounds exactly like a balancing issue. Check condition of tyres (including side walls) and get the wheels balanced. what fluid are you refering to and what's the difference between what you used to what you should've used?
Posted on Jan 11, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
My Death Wobble started immediately after I installed a set of Coil Spring Spacers (to lift 1.75 inches). Turned out, the DW was because while changing the height, I also lowered the CASTER angle in the front end. So, to fix it, I could have purchased a set of eccentric bolts for $50+. Instead I went out and purchased a piece of 1.5 inch flat bar for $10 from OSH. I cut out 4 1.5 inch squares. Then i drilled 7/16 inch holes centerline, but close to one side (in exactly the same place) on all for squares. I then removed the lower control arm bolts, nuts and washers. I installed these square offset washers I made so the front axle would be pushed forward (to increase the Caster angle). The toe setting changed a bit, so I reset them to about 1/8 inch toe in. After driving my Jeep, I noticed there is no more DW. The steering wheel was off center, but after 3 attempts, I have that perfectly centered. I have every intension of having the alignment checked, but not till after I find the new tires I want. If anyone is interested, I can draw out and photograph the cure and send it to you. My e-mail is bb62471(at)yahoo(dot)com.
Posted on Feb 13, 2009
spark plugs wires needs complete tune up also synthetic oil change not designed to run on regular oil then check bearings
Posted on Mar 18, 2009
it could be a number of things. check your ball joints. i had the same problem with my dodge, i replaced the ball joints and it stopped. your wheels could also need alignment.
Posted on Apr 03, 2009
you are apply torque to the engine upon pushing on the gas pedal so the law of nature states the engine mount maybe broken
Posted on Feb 03, 2010
Tips for a great answer:
Jun 08, 2012 | 1998 Mercury Sable
Jan 19, 2011 | 2006 Volkswagen Passat
Oct 31, 2010 | Jaguar S-Type Cars & Trucks
May 16, 2010 | 2005 Volkswagen Golf
Jun 02, 2009 | 1994 Pontiac Trans Sport
333 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: