Question about Cars & Trucks

1 Answer



Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert that has over 500 points.


    An expert whose answer got voted for 20 times.

  • Expert
  • 176 Answers

Im not sure what kind of vehicle you have but if it has a distributor cap i would replace it. if it is a newer car this wont work

Posted on Jan 12, 2013


5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


SOURCE: Windstar stalls when it rains and gets wet

this is from a different post

Posted on Jul 21, 2008

  • 40 Answers

SOURCE: jeep stalls

I'm with solution #2

Posted on Jan 24, 2009

  • 6 Answers

SOURCE: 91 wrangler when it gets wet it stalls out and

Possible water getting in the connection at the tpms sensor. Very common on these vehicles.

Posted on Feb 28, 2010

  • 101 Answers

SOURCE: why car will not crank up after engine gets hot until engine cools

Check the starter

Posted on Jul 30, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

04 dodge durango slt. Every time it rains my car stalls and check engine light comes on. Went through car wash also and it died. I can wash myself and don't have this problem. Maybe under engine??.

Something is getting wet. Check the codes with a code scanner to see if you can isolate the problamatic area. The code/s may point you to what circuit is causing your trouble

May 10, 2015 | 2004 Dodge Durango

1 Answer

I power washed my 89tercel engine when i tried to drive it .at 2400rpm it bauged down till it reacjed 2000rpm then ran agin tell it reached2400rpm agin can you help

Open your hood and let it sit in the sun. You probably need a new coil or ignition. Never ever do that again...high pressure can blow gaskets and destroy electric components. Once it drys it should run fine until it gets wet again...then you may be stranded in the rain. Look at your coil and ignition for swelling, cracks or other signs of damage or ware. If you don't see any, you can try using a spray bottle with water once its dry and spray specific areas to see if it affects running. Also check your plug wires, at night open your hood in the dark, look for sparks...look around coil also...

Jun 06, 2014 | Cars & Trucks

1 Answer

Drain plug

Check the rubber grommets on the firewall to make sure the are sealed. Lift the rug to make sure it is not rotted underneath, the seal on your windshield may not be good allowing water to get inside.

Jun 02, 2013 | 1996 Ford Crown Victoria

1 Answer

I washed down the engine, shortly after I went to pick up my paycheck, drove five miles, everythings ok I drive .3 miles stop at stop sign, take off and the car stalls and cel comes on.I restart the car...

.with all the sensors and electronics made of plastic,if they are hot and you put water on them they can crack and get water in them. They might send the wrong message to your engine control module (computer)

Aug 04, 2011 | Acura TL Cars & Trucks

1 Answer

When my 95 Lincoln is parked on the sightest grade (front facing down), water gets into the floor of the trunk. Gasket is still flexible. Underneath is also dry? Any ideas? Thanks

Had a similar situation in my service station wherein the gasket was flexible, however it was not affixed was loose. We loosened it a little more in the suspect area, cleaned it and used gasket sealant (Part 8001 -Yellow comes to mind but there is a black one as well as others) to re-adhere it. Check to see exactly where the water is leaking in by parking it downhill and using a hose or such to wet it, while continually opening the trunk until you can determine where the water enters the gasket area. Also clean the channel immediately around the gasket to facilitate this process. Also, if need be, check to make sure that the water is not leaking in from the rear window mounting area. Check for even minute tears in the gasket as well. I'm not sure what you mean by "underneath is also dry" though.

Mar 13, 2010 | 1995 Lincoln Town Car

2 Answers

AC blows warm air when it rains

It sounds as if you have an ambient temperature sensor that is either shorting out when it gets wet or either the water is acting like an insulator and sends an incorrect reading to the body control module. You may want to contact BMW to the specific location on your particular year and model. As location will vary with model and year.

Jul 02, 2009 | 2002 BMW 5 Series

1 Answer

I have a 1986 Dodge 600, With a 2.4L I have done a complete tune up on the thing a new fuel pump, timing set on the car and I still have a problem. When you start the car when the car is cold it runs like...

make sure choke on carburetor is open when engine is warmed up.if all is good .carburetor is lean float bowl is fuel .because the fuel pump weak or fuel filter stopped up.make sure idle speed is correct.

Apr 25, 2009 | Dodge W150 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides