Question about 2001 Chrysler Town & Country

Open Question

Locaton of crank sensor for 2001 chrysler town and country 3.3 liter

Picture of location of cranksensor

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

garyq1970
  • 73 Answers

SOURCE: changing fuel filter on 2004 chrysler town and country

  1. Remove or disconnect the following:
    • Negative battery cable
  2. Raise the vehicle and support the fuel tank with a transmission jack.
    • Fuel line from the front of the tank
    • Ground strap
    • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
    • Fuel lines from the fuel pump module
    • Fuel filter
  3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
  4. Start the engine and check for leaks.

Posted on Aug 24, 2008

emissionwiz
  • 75822 Answers

SOURCE: i have a problem with power sliding doors on 2001 Chrysler Town and Country limited

do you mean they are sticking?

Posted on Oct 20, 2008

  • 323 Answers

SOURCE: locassion of output speed sensor on 2003 Town and Country

The input and output speed sensors look identical on the connector side. The one over the solenoid pack is the input, the one closer to the left frame rail or left front wheel is the output sensor. I hope this helps.

Posted on Apr 26, 2009

keemo68
  • 1263 Answers

SOURCE: radiator fan relay,2001 chrysler town country

the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays

Posted on May 08, 2009

  • 117 Answers

SOURCE: 2005 crank position sensor location

The crank shaft sensor on that model should be on the driver side towards the back of the tranny its not hard to get to.

Posted on Jun 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How to replace speed sensor on 2001 Chrysler Town and Country?


output speed sensor is the same thing. Sending a picture. It unscrews. Look straight down between the radiator and transmission.
25657330-cjo2jczcqc4pn4ns3k2s1t1v-3-0.gif

Apr 20, 2015 | 2001 Chrysler Town and Country

1 Answer

Where is crank position sensor on 2002 chrysler town andcountry


the sensor is located in the trans bell housing were the trans bolts to the engine, there is a 3 wire electrical connector. I believe its on the top of the bell housing on the firewall side.

Aug 28, 2014 | 2002 Chrysler Town & Country

1 Answer

Cranksensor


depending on the engine size, the sensor is usually mounted on the block near the crankshaft pulley

Jul 01, 2012 | 2005 Chrysler Town & Country

1 Answer

How do you locate the upstream o2 sensors on a 1996 chrysler town & country with a 3.8 liter engine?


upstream means above or before the catalytic converter, check this link for Chrysler and Dodge 3.8 locations, the have a diagram for you too look at http://autorepair.about.com/library/images/bl341lib.htm

Sep 01, 2011 | 1996 Chrysler Town & Country

1 Answer

How can I check to see if my distributor is bad on my 2001 Chrysler Town and Country?


A 2001 town and country does not have a distributor.

It uses a coil pack (three coils with 6 terminals in one assembly) that supplies spark to each cylinder through the ignition wires. The coil recieves its signal to spark from the computer which looks at various inputs like the crank sensor, throttle position, etc.

Can you describe the problem you are having?

If you have no spark out of any of the coils than the first thing I would check is for power at the coil pack. If there is power the next thing to check is the crank sensor.\

I can give you more info on this if you want to check into it further, just let me know.

Jun 28, 2011 | 2001 Chrysler Town & Country

1 Answer

Picture of bank1 sensor1 o2 sensor location on 2001 chrysler town & country


I do not have a diagram but, bank 1 is the bank where #1 cylinder is at. other side would be bank #2. so bank #1 o2 sensor is just before convertor.

Aug 29, 2010 | 2001 Chrysler Town & Country

1 Answer

Need location of crank sensor on 1996 chrysler town and country


You did not mention the engine size you have, but the sensor is mounted on the trans housing and will look like this on a 3.8 liter engine.

53001aa.jpg

Jul 08, 2010 | 1996 Chrysler Town & Country

1 Answer

Cranksensor where is it location at 2005 town and country


Hello melvin453: My name is Roger and I will help you. The crank position sensor is located on the rear of the transmission housing above the differential housing. The bottom of the sensor is located next to the drive plate (flywheel). Should you need further help please just ask.Please rate the answer. This way i know it was helpful. Thank You for using Fix Ya.

Nov 18, 2009 | 2005 Chrysler Town & Country

1 Answer

Where is the oxegen sensor located on a 2000 chrysler town and country 3.8 liter. does the oxegen sensor have a fuse


the oxygen sensor is located in the exhuast pipe,there could be more than one sensor, maybe 4 sensors on a 6 cylinder car and 2 sensors on a 4 cylinder car,so youre gonna have to know which one is bad,if the check engine light is on it will tell you which position sensor is bad like bank 1 sensor 2 something like that,also there is NO fuse for the o2 sensors

Oct 19, 2009 | 2000 Chrysler Town & Country

Not finding what you are looking for?
2001 Chrysler Town & Country Logo

Related Topics:

173 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...