Question about 2004 Chrysler Pacifica

Open Question

Chrysler pacifica gas pedal sticking

Gas pedal is sticking

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

01fordeb
  • 1033 Answers

SOURCE: Accelerator pedal sticking - 2005 Pacifica

Buy throttle body cleaner at your local parts store. Take the big intake hose off that is connected to the throttle body and air filter housing. Open up the butterfly (like you're controling the throttle at the engine). Spray this cleaner inside the throttle body, around the butterfly, where it motions back and forward on the pin. You will see a lot of carbon build up run out. Do this 2-3 times. It doesn't take a lot to clean it, just a couple of quick sprays. Wipe it clean with a clean cloth or rag. Put it all back together. It will seem hard to start for a few turn overs, but this is from the cleaner and it will dry out quick. What happens is, over time this carbon builds up where the butterfly closes and it gets (stuck) on this build up, which causes you to push harder on the gas pedal or it will not close completely. They charge will charge you like $250+ to do this and usually it's just build -up. Try it and let us know how it works for you. The cleaner $5

Posted on Jan 27, 2010

  • 1 Answer

SOURCE: 2006 chrysler pacifica accelerator pedal sticking

carbon buildup in the throtle body is most likely the problem you need to remove the air cleaner and buy some card cleaner. there ia a butterfly valve in the throat of the assembly that will have a carbon ring built up around it use the carb cleaner and a tooth brush to remove it this happened to my pacifica I could not believe it was something so simple I went through lubricating all the cables before I found the real problem

Posted on Mar 20, 2010

Testimonial: "I replaced the air filter and cleaned the butterfly valve and seat.It seems to be working just fine.Time will tell if the fix is permanent.THANKS!!!!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2005 chrysler pacifica is making a light hurling sound coming from the engine and gets louder when i step on the gas pedal


My personal feeling if this persists then you should ask a good mechanic as it could be the start of bad things to come. But too
also might be nothing to worry about. I would ask a mechanic who would know his stuff. Should be no charge to ask.

Sep 02, 2016 | 2005 Chrysler Pacifica

2 Answers

Why does my 07 Chrysler Pacifica feel like its going to vibrate off the road with acceleration at 40 - 60 Mph?


2007 Chrysler Pacifica Problems, Defects & Complaints

www.carcomplaints.com/Chrysler/Pacifica/2007/
5 days ago - The 2007 Chrysler Pacifica has 97 problems & defects reported by Pacifica owners. The worst complaints are engine, transmission, and ...‎Engine - ‎TSBs 13 - ‎Crash Tests 2 - ‎Defect Investigations 2

Aug 03, 2015 | 2007 Chrysler Pacifica Touring

1 Answer

Why noise in car when pressing on gas pedal grinding


It's the car pulling to that side? Sticking brake pad possible. When did you have brakes done last off at all? Front brakes go out twice as fast as rear brakes. If you can Charlie jack up that side put car in park, set emergency brake and chock rear tires. Pull off that tire and see if rotor is grooved or scored badly. It may have been sticking and wore down faster. Also check CV BOOT. If torn u joints get dirty and will grind. Hope this was some help.

Feb 05, 2015 | 2005 Chrysler Pacifica

1 Answer

2002 Toyota Avalon Gas pedal sticks in the up position when attempting to accelerate.


there is a sensor on the top of the gas pedal. in 2002 toyota replaced the gas pedal cable with a sensor . have it checked

Aug 27, 2013 | Cars & Trucks

1 Answer

2007 Pontiac G5 Base Coupe gas pedal sticking at times


Check the pivot point of the accelerator pedal and lubricate if possible. Check for freyed (broken) wires at the cable ends and check for kinks if you have a cable

Feb 06, 2013 | Cars & Trucks

1 Answer

Why does my gas pedal sticks, even if it's only pressed half an inch?


Thorttle body could be dirty causing it to bind. Or cable to foot pedel is binding up.

Jun 13, 2012 | Chrysler Sebring Cars & Trucks

1 Answer

My pacifica idles rough and when you press gas pedal it stalls then goes then stalls and goes again over and over.


Need to know what codes it has. Could be a simple O2 sensor but if you keep driving it running bad the converter will over heat and melt and they are not cheep

Aug 20, 2011 | 2005 Chrysler Pacifica

Not finding what you are looking for?
2004 Chrysler Pacifica Logo

Related Topics:

418 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...