Question about Jeep Patriot

Open Question

2007 jeep patriot DTC C121C - Patriot Jeep Cars & Trucks

Posted by Anonymous on


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 277 Answers

SOURCE: 2007 jeep patriot door ajar warning light keeps

SOAK all the switch and latches on the doors with WD40 one is probably stuck inside

Posted on Jan 28, 2011

  • 36 Answers

SOURCE: How do you change the 2007 Jeep Patriot turn

You might have to remove the headlamp assy to get to it.

Posted on Jul 07, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Fault code c 1044

Think I found the solution or a thread discussing your Fault Code at Jeep Forum (Jeep patriot abs,4wd,esp,Trac control lights on after replacing rear wheel bearing) Jeep patriot abs 4wd esp Trac control lights on after replacing rear wheel...

Jan 07, 2016 | 2007 Jeep Patriot Limited

1 Answer

What are the probable causes of DTC C2116?

Wheel speed sensors or wiring connections likely culprits.

Jul 14, 2015 | 2007 Jeep Patriot

1 Answer

I have a 2007 jeep patriot. The check engine keeps coming on with the code p2008. Mechanic say fixed but check engine light keeps coming on and off. How do I fix problem

but you never scanned it the 2nd time, maybe the gas cap is loose.
p2 is jeep factory only code (unlike p0,1)
so only jeep books get this correct .
2007 MK Jeep it is.
is P2008 a rumor or did you see it with YOUR EYE and on what a real scan too?
P2008 Intake Manifold Runner Control (IMRC) Solenoid Control Circuit

so what did he do? replace it , clean it? what?
if you clean it and it dont work, then its bad. replace it.
as for why the CEL glows now, you'd have to scan it again
mine has like 300 DTC's possible. so ID NEVER ASSUME its still P2008- not me , id scan it, any shop or store can scan it,
why wait, or guess or worry.?
or ask him to help, see if it is something new, or just the gas cap loose.

How do i fix it.
i dont know what you can do.... personally?
buy the FSM and read?
buy a scan tool and scan.
be clear as to all DTC thrown, and post them all.

Apr 22, 2015 | 2007 Jeep Patriot

1 Answer

Why is a blue light flashing on the dash of my 2007 jeep patriot

3 posts do we get 4?

read the manual first, and then ask a question.
that is what we do, read then ask.
as we can never guess lamps. sorry, its not going to happen

Mar 23, 2015 | 2007 Jeep Patriot

1 Answer

My 2007 jeep patriot battery full charge starter solonoid just clicks

You probaably better make sure the engine actually spins, if it died while driving, the starter is not the issue. Put a socket on the crank bolt and see if you can move it

Mar 01, 2015 | Jeep Cars & Trucks

1 Answer

What does c121c mean?

C121C- Torque request signal denied....Do you have any drivability symptoms or other codes? Camshaft sensor failures are common on this engine.

Aug 19, 2014 | 2008 Jeep Patriot

1 Answer

U0423 jeep patriot no other codes

using a real scan tool

if not you will miss most DTC errors.

use a real tool not just the silly dash bs VFD codes.

the dash is like the tip of an iceberg. see?

Jul 05, 2014 | 2010 Jeep Patriot

1 Answer

Can't Locate a Haynes manual for my 2007 Jeep Patriot , Do you know of any other manuals which I could substitute for the Haynes.? thanks.

Doing this search on ebay gives 5 hits. 2007 Jeep Patriot (shop, repair) manual
If you take out Patriot, there are 84. The hits for a google search are endless.
This is something you can do yourself.

May 09, 2011 | 2007 Jeep Patriot Sport

1 Answer

Remote key for 2007 jeep patriot

Should say in your manual. If not most can be reset by standing within 2-4 feet from engine compartment and depressing two buttons on remote. Should hear an audible beep or doors should lock. Hope this helps!

Mar 30, 2009 | 2008 Jeep Patriot

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

317 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides