Question about 1990 Peugeot 405

1 Answer

Location of relay

On my 206 heater blower is not working need to locate the relay ny ideas

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

The heater blower does not have a specific relay. You need to replace the resistor located near the blower under the dash. It has a plug and a couple of screws.it may be a little difficult to get to .

Posted on Jan 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHERE on a 1990 FORD TEMPO location is the RELAY that controls the switch to the heater blower ???


IT BE NEXT TO THE BLOWER MOTOR WITH WIRES GOING INTO IT HELD ON WITH TWO SCREWS CALLED A BLOWER MOTOR RESISTER.

Dec 16, 2015 | 1990 Ford Tempo

1 Answer

Where is the resistor located for the rear A/C/heater blower?


there is not resistor, you should have 3 relays on electrical panel in rear on the left side by the blower, each relay control the speed of the motor

Jun 21, 2014 | 1997 Chevrolet Express

1 Answer

1998 buick century my heater and ac fan only work on high i'm told it's the blower relays where are they located


they are not relays its a blower motor resistor a one piece unit usually held in by two bolts and an electrical connector either under the passenger side dash or behind glove box

Aug 03, 2012 | 1990 Buick Century

1 Answer

My heater in my peugeot 206 gti is on constantly..tried changing the climate control unit but it has made no difference...any ideas?. thanks :)


According to the Peugeot dealer the 206 gti thermostat resistor is embedded in the heater blower fan, so the blower fan must be replaced ( Supplied VIN # for confirmation). However the how to remove the blower is the subject of many discussions on every 206 site. Some say turn blower clock wise, anti clock wise, remove hex screw, don't remove screw. So I am still waiting for a sure answer, I picked up a blower (second hand) but the old blower wont budge, clock or anti , someone suggested to try brute force like with a hammer, I am not game to do that, but I may have to.

Jul 11, 2012 | Cars & Trucks

1 Answer

2006 tacoma heat/air blower fuse location


Hello! Coil of Heater Relay is supplied through Fuse "IG1 2" (10A)...Located in the Drivers Side Box...Contacts of Relay are supplied through "Heater Fuse (50A)...Located in Engine Relay Box...Blower Motor has a 2 wire connector with wire colors: Black/Yellow (Pin 2)...And White/Blue (Pin 1)...Pin 1=Ground and Pin 2=Battery when Relay pulls and contacts close...
The Blower Resistor Pack (Which fails often) controls the fan speed...BUT, there is a fuse inside the assembly...If it blows = No Fan...Located on the top of the heater/AC box and can be accessed through the Glove Compartment...Guru...Saailer

Jun 01, 2012 | 2006 Toyota Tacoma

4 Answers

Heater on my envoy only works on 3-4 setting, could that be the switch.


Thanks for the opportunity to let me help. The blower control switch in your vehicle also uses a blower relay. This relay is generally located on the firewall on the passenger side near the heater fan. You can also look in you vehicle owners manual for the location of the blower relay, it may be also be located in the fuse and relay box under the hood. Generally speaking if the highest setting doesn't work on a GM vehicle it is a high blower Relay. This item is not expensive and can be purchased at most all you local Auto parts stores. If you have a Napa, Orielly's, or AutoZone these stores will also likely help you in the location if you are unable to locate this relay. Here is a general picturepepsiman1967.jpg The installation of this relay is either to remove from the fuse box, or if located near the heater fan housing then you will need to remove the mounting screws, remove the wiring clip, then reverse to install. I hope that this has helped you. D.R. Wilkins

Nov 05, 2010 | 2004 GMC Envoy

1 Answer

Heater control for fan blower not working. stopped working for about a day then started working again for a day then stopped altogether dead since.


check the blower motor relay, located under the hood fuse/relay box. turn the system on and tap the blower motor see it works. The blower motor located under the glove box.

Apr 19, 2010 | 1992 Honda Civic

1 Answer

Where is my heater fan relay located on my 92 Toyota 4runner?


where is the heater \ blower fuse located on a toyota 4runner 1992?

Jan 10, 2010 | 1992 Toyota 4Runner

2 Answers

1983 Chevrolet Suburban Heater fan not working


Heater blower motor resister is bad, replace, located under dash above heater motor.

Mar 15, 2009 | 1983 Chevrolet Suburban

Not finding what you are looking for?
1990 Peugeot 405 Logo

661 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...