2006 Chevrolet Aveo Logo

Related Topics:

Bety Posted on Jan 11, 2013

Replace vacuum hose on 2006 chevrolet aveo - 2006 Chevrolet Aveo

5 Related Answers

steve noel

  • 750 Answers
  • Posted on Jun 22, 2009

SOURCE: 2006 Chevrolet Aveo Car Horn not working, I

check fuse or ground wire, if ok, replace unit

Ad

Anonymous

  • 56 Answers
  • Posted on Sep 11, 2009

SOURCE: 2004 Chevrolet Aveo Brake lights not working

A couple of days ago my brake lights on my 2004 Chevy Aveo wouldn't work, so I attempted to remove the lamp covers to check the bulbs. Also, before this my shifter would get stuck in park and could only be released by pressing the unlock gadget next to the shifter. Back to the brakes...Well, you open the trunk and remove the two screws just like the manual said, but it was very hard to pull off. There's 2 prongs holding the other half of the light on. The lamp will come loose by prying it (very hard). You think the cover will break, but it'll come loose. The bulbs were all OK.

After much frustration and internet info, the STOP LAMP SWITCH, GM#96436331 ($9.30 at Chevy dealer), which is located under the dash and has contact with the brake pedal, was defective. Once replaced, both my brake lights AND SHIFTING problems were cured. So if the brake lights suddenly don't work or you have problems getting the vehicle out of park, check the switch by pushing the prong (end that has contact with brake) of the switch in and out. If it doesn't retract smoothly...that's the PROBLEM. Good Luck.

Anonymous

  • 1986 Answers
  • Posted on Sep 23, 2009

SOURCE: 2006 Chevrolet Aveo engine dash light on/off intermittently

If the light was flashing when it came on, then it means your engine is misfiring.
A solid light can mean anything.

This light comes on when the computer detects a fault of some sort in its diagnostic tests. If it keeps detecting this issue, the light will remain off. If the light turns off, then it has detected that the issue may no longer be present.

In order to find out what the exact reason was for your light, You need to have your car computer scanned to retrieve the code that the computer would have stored when the light triggered. Most garages will do this free of charge. The code will tell you what may have caused the light to initially go on

Testimonial: "Yes. It was very helpful. Thank you."

Anonymous

  • 1 Answer
  • Posted on Nov 26, 2009

SOURCE: remove a cd player from a Chevrolet Aveo

on the 08 aveo you simply remove the trim pieces on the left and right of the cd player there you will find 2 mounting screws per side undo cd player slides rate out i replaced mine with 2 din touch screen dvd w\ gps 2 10 inch subs 1000watt amp in band pass audio box and 600 watt amp and 2 5 1\2 inch lanzars lotta boon im my vroom vroom

Anonymous

  • 57 Answers
  • Posted on Apr 27, 2010

SOURCE: 2004 Aveo Clock Repair/Replace

You will need to remove the dash board of your car.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to replace the heater hose for a 2006 chevy aveo?

Just follow it both directions and remove.
tip

2006 Chevy Aveo

My Aveo was throwing codes. They were pointing to O2 sensors or fuel filters. Went back to the basics and replaced plugs, wires, and found out there is no fuel filter to replace. Once the cover was off to work on the plugs, we ran the car and heard a vacuum leak on one of the molded right angle lines. You could move the vacuum line and make it run worse. Replaced the line and cleared the codes - car runs fine.
0helpful
1answer

What is the 2007 chevy aveo engine number

PDF]2006 Chevrolet Aveo - GM Heritage Center

https://www.gmheritagecenter.com/.../gm.../Aveo/2006-Chevrolet-Aveo....
2006 Chevrolet Aveo: Refinements Enhance Value and Safety . ..... Engine NumberLocation . ... Manual Transmission Identification Number Plate (Y4M) .
0helpful
2answers

How do I check Throttle Body and Vaccum leaks?

Find and remove and clean your IAC valve..use MAF cleaner...you need to remove two torque screws..takes 10 minutes...spray the valve to remove all carbon...reinstall and drive car for 10 minutes to adjust..do not run lights, radio or anything else until you return and park..valve had what is called a pintle with spring around it...make sure to spray every part of the pintle and wipe in a straight motion with clean rag...cheers
2helpful
1answer

Hi,need your help, my 2006 Chevrolet Aveo (manual) when shifting the gear from low to higher gear , the rpm remain high or even higher, I have the mechanic to clean out the Throttle Body, the problem...

about all you can do is have the throttle body replaced, unless you have some kind of a vacuum leak, their is no adjustment or even a throttle cable on these cars..
3helpful
1answer

Just replaced throttle body on 2006 Aveo. Engine idles rough and will not acccelerate over 20 MPH. Any suggestions?

Hello angel 003801, if the car was running rough, and had acceleration issues before you changed the throddle body, I strongly recommend you get a new air filter. Many people are unaware that the air filter is like lungs to your engine, your engine needs a good mix of fuel and air to perform at it's peak. Also, most 10 minute oil change companies do not change the air filter, at best, some of them may take it out, hit it against something to clean some of the dirt out, and then put it back in.

If the engine seems to run better after putting in the throttle body I would still change the air filter if you haven't done that in a while. Also, make sure that the throttle body is mounted securely with no leaks, look around the area of the throttle body and make sure you didn't accidently knock of a vacuum hose, ( vacuum hoses are very small, usually black hoses, and there are several in the general area of the throttle body. If you should find a small hose that has one end that is not hooked to anything, look around for a small nipple that it may have come off of.

My goal was to provide timely and accurate information. If this has been helpful to you, please consider taking a second to click on the, " this was helpful ", button.
Thank you!
1helpful
1answer

Check engine light came on and is giving codes P0171,P0106,P0172,P2188, P2187. What do these mean?

check for a broken vacuum hose or vacuum fitting(s). you can use a can of spray carb cleaner. while running the engine use the spray to test hoses and fittings. give a little squirt to suspected areas. The idle speed will change when you find a vacuum leak. pay particular attention to the hose to the MAP sensor. There may be a problem with the elelctrical connection to the map sensor, or the sensor itself may be bad.

Manifold Absolute Pressure Sensor printpage_icon.gif



0996b43f80202e93.jpg
2helpful
1answer

'06 chevy aveo vacuum leak at the intake manifold. Is this a common problem with the aveo's? Can it be sealed without removing the manifold? Also, are throttle position sensors a common problem with aveos?

Proper resealing and problem resolution (warpage, etc.) cannot be done without removing and inspecting...
TPI sensors are problems on many cars, not a huge deal....
0helpful
1answer

Low pressure hose

the high pressure andlow pressure arerightnext to each other. at the top of your engine by the throttle body
Not finding what you are looking for?

254 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...