Question about Cars & Trucks

Open Question

Ultralux UL559155 replacement in the uk

Am looking for a UK supplier of a replacement Ultralux UL559155 X528 light bulb

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Passenger front headlamp bulb replacement required

Remove the carpet covering the inside near the headlight. Remove round rubber plug. (pull hard, the plug has NO WIRES coming out of it) Use the 5mm wrench that is in the toolkit. (toolkit is behind the spare tire). Turn the wrench 180 degrees and the whole headlight assembly will loosen. Pull out the whole assembly. Remove plastic end cap. The high beam, low beam and parking bulbs are all right inside that cover. Just did my 2002 for the first time. This is also covered in the manual if you have one. Thanks, max327@aol.com

Posted on Feb 23, 2009

alicantecoli
  • 22156 Answers

SOURCE: changing side light passenger side front bulb on

its inside the headlight unit ,take the cover off and just turn the holder and it will come out

Posted on Nov 22, 2009

bluebirdmate
  • 1190 Answers

SOURCE: hi can u help me

Hello: There isn't any repair kit for this pump. You will have to replace it.

Posted on Feb 05, 2011

  • 456 Answers

SOURCE: I have a 1998 Z3

hi.
the side light and the high beam will be different bulbs. they may appear to be the same, but if you look carefully, there is a smaller bulb, normally just below the main bulb. the sidelight will usually be a small 5watt bulb where the main beam bulb will be much larger, and anywhere between 45 and 65 watts. look for the smaller bulb and replace that first..

Posted on Aug 03, 2011

Testimonial: "Thanks... I'm blind! spotted the "extra" bulb straight away when I knew that there should be one hidden away..."

bensriver
  • 1 Answer

SOURCE: I have a 2002 Hyundai Accent (UK RHD). I've had a headlight go out, side lights and full beam still work. I've changed the bulb and fuse but its still dim. Ran out of ideas...

Hi ,Check the light bulb,see if its seat in the seats properly 'for earth' and the light terminals for dirts ,grease,or corrosion.clean if needs to.I think its a Earth problems

Posted on Dec 17, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What wrong with .my 2004libertyt lleft tail light cchanged b uk


could be a fuse or you need to change both taillight bulbs. make sure you replace it with the correct bulb

Dec 02, 2014 | 2004 Jeep Liberty

1 Answer

I have a 2002 Hyundai Accent (UK RHD). I've had a headlight go out, side lights and full beam still work. I've changed the bulb and fuse but its still dim. Ran out of ideas...


Hi ,Check the light bulb,see if its seat in the seats properly 'for earth' and the light terminals for dirts ,grease,or corrosion.clean if needs to.I think its a Earth problems

Dec 17, 2012 | 2002 Hyundai Accent

1 Answer

I have a 1998 Z3 1.9. The nearside (UK) sidelight does not come on, but the high beam does (same single element bulb). Checked sidelight fuses after replacing bulb... neither seems faulty. Any help as to...


hi.
the side light and the high beam will be different bulbs. they may appear to be the same, but if you look carefully, there is a smaller bulb, normally just below the main bulb. the sidelight will usually be a small 5watt bulb where the main beam bulb will be much larger, and anywhere between 45 and 65 watts. look for the smaller bulb and replace that first..

Aug 03, 2011 | BMW Z3 Cars & Trucks

2 Answers

Replacing brake light on a subaru outback limited wagon 2000


How To Install Replace Change Taillight and Bulb 2000-04 Subaru Outback

Apr 07, 2010 | 2000 Subaru Outback

1 Answer

I own a 1995 honda odyssey minivan and the drivers front head light is not working because of the wire connection? what do i do to fix this problem because I got stop for having only one headlight? thank...


hello annette from uk you think it may be connection ?? is head light not working on dipped beam? but high beam ok ? if so it may well be the low beam element in h/light bulb has blown however you could also check the fuse as each side head and sidelights have their own fuse check handbook for position of fusein box if ok then you can try the other head light bulb from other side into the plug connector of drivers side and if this works on high+low beams ? your old bulb is blown feel sure you can do these checks !? approx price of new bulb in uk £4 -50 but carry out above checks !st b 4 you buy bulb ? if it is a bad connection on plug ? another bulb will have same problem hope you understand all above ? and wish you good luck from n/west uk

Oct 30, 2009 | 1995 Honda Odyssey

1 Answer

Three brake lights went out. Replaced little bulb and it works


hi from uk if all bulbs ok? and ou have checked fuse then the problem is most probably the brake light switch that is stuck in the off position ie the plunger which is supposed to come out and put light on being plastic they do sometimes stick the switch is just above the brake pedal and has a 2xpin plug attached if you unplug and connect the 2 terminals using a wire or paperclip ? then have an assistant check if lights work? if yes then check to see if the plunger on switch is failing to come out when you press pedal ? if yes ? then switch is faulty but if plunger is stuck use wd 40 and work the plunger by twisting and pressing in/out to free it ? then recon the plug and try lights ? if switch is faulty ? easy diy to replace it simply screws out from pedal box assy ten fit new switch and adjust by screwing so lights are off with pedal off and on as pedal is pressed approx 1/2 " to operate lights to on ! this is simply trial/error untill you are happy ? hope this helps best wishes from n/west uk

Oct 13, 2009 | 2002 Hyundai Accent

1 Answer

Centre brake light works but no outside lights


Hello,
From your very brief description I would purchase two replacement bulbs for the lights that aren't working, although you may have looked at them and they seem o.k. the filiaments on the brake light side are heavier than sidelight ones so if fused sometimes you can't see the break in them.
As your third brakelight is fully functional this is the reason I would be looking for replacement.
I hope this helps? please remember to appraise my FREE effort and press that Blue button if sorted, Thank You!
Paul 'W' U.K.

Jan 30, 2009 | 1998 GMC Jimmy

1 Answer

How to replace rear lights


hi sushil from the uk try this ? if you check inside boot directly behind the lights you may find either a clip in inspection cover ? or carpet lining ? covering the lamps? pull/remove the cover to gain access to rear lamp/s then look at where bulbs fit? they will be either on their own bayonet plug for each bulb or all on a master plate of plastic which is removed complete with all bulbs by pressing a clip and withdrawing the assy? re assemble in reverse most uk cars and foreign cars have this type of rear light clusters please come back with update hope fully success? or if you req more help? merry xmas from UK

Dec 12, 2008 | 2002 Mazda Protege

1 Answer

Rear running lights don't work


hi from uk have you checked the bulbs? as these bulbs have 2 elements in each bulb ie tail light and the other element is brake light you do not mention whether license plate light/s are working? as they are on same circuit as tail lights hope this helps? please keep us updated on what you discover or you req further assistance ? best wishes from uk

Nov 19, 2008 | 1992 Honda Accord

2 Answers

Brake lights


hi from uk not too sure on elantra but will try to help? if car is hatchback ? lift up hatch and look at the water drain channel alongside lamp? if there are 3x screws? unscrew and lift lamp off then unclup bulb/lamp board from lens bulbs are bayonet fitting if saloon then open boot look to rear of lamp in boot for either clip on panel or carpet covering lamp rear remove and look for some kind of nylon head screw bolt/s or 10 mm nuts? that my hold the lamp in place to body? or you may ?find the bulb/lamp board is simply a clip in to the lens assy as 1st example ? in that case just unclip and change bulb/s with no need to remove lens assy with a little patience you will succeed hope this helps

Nov 01, 2008 | 2006 Hyundai Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...