Question about 2004 Toyota Sequoia

Open Question

My 2004 sequoia- The alarm went off, causing my battery to die. With the new battery the radio, headlights, and air condition come on when truck is off.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2004 Toyota Tundra 4.7v8 will not stay idle'd

Take the battery to autozone and have it checked.It could have a dead cell.

Posted on Feb 04, 2009

  • 154 Answers

SOURCE: low air flow out Aircondition vents

NO IT DOESN;T HAVE ONE

Posted on Jul 25, 2010

  • 39 Answers

SOURCE: how to adjust headlights on 2004 sequoia cannot

review this and let me know if you need more help?!
home578.jpg

2. ADJUST HEADLIGHT AIM ONLY

(a) Place the vehicle in the following conditions.

 The area around the headlight is not deformed.

 The vehicle is parked on a level surface.

 Tire inflation pressure is the specified value.

 A driver is in the driver's seat and the vehicle is in a state ready for driving (with a tank full).

 The vehicle has been bounced several times.

(b) Check the headlight aiming.

(1) Prepare a thick white paper.

(2) Stand the paper perpendicular to the ground at the position 3 m (9.84 ft) away from the headlights

bulb center.

(3) Ensure that the center line of the vehicle and the paper face forms a 90-degree angle as shown

in the illustration.

(4) Draw a horizontal line (H line) on the paper, showing where the headlights should strike.

(5) Draw a vertical line (V line) at the position where the extended center line of the vehicle strikes.

(6) Draw 2 vertical lines (by connecting the low and high beam center marks) to where the both headlights

should strike (V RH and V LH lines).

(7) Draw a horizontal line (by connecting the both low beam center marks) at the position where the

headlights should strike (H RH and H LH lines).

HINT:

The H RH and H LH line is 0.4° below the horizontal line (H line) of the light axis.

(8) Start the engine.

(9) Turn the headlights ON.

(10) Check that the headlights properly strike the position shown in the illustration.



home578_0.jpg

Posted on Jan 01, 2011

mariolands
  • 2296 Answers

SOURCE: how to change a headlight bulb in a 2004 toyota

Follow the instructions from here http://www.fixya.com/cars/r7610955-change_headlight_bulb_toyota

Posted on Jan 04, 2011

taran_2005
  • 10515 Answers

SOURCE: The car alarm keeps going off in my 2006 Toyota

Hi,

Something you need to be aware of here is that the factory alarm on your prius only detects doors, this meaning if any of the 4 doors, the hood or the back hatch are opened then it detects this and monitors the door positions, if the alarm is armed and a door is either unlocked or opened unauthorized then it sets this alarm off. You can jump on the roof or ram the car with a dump truck and it will not set the alarm off, the factory alarm does NOT detect impact, it only detects door lock/unlock and door open/close. The only way this alarm will go off (other then if you press the red panic button on the remote) is if a door is either unlocked or opened without the use of a key/remote.
The door entry switches would need to be played around with here and a scan tool with data lists are needed, I have seen some cases where the bolt that holds the door switch to the body is loose and causes this.
The Factory Security system has many customizable features that can be turned on or off or adjusted. The Dealer has the ability to do this for you. I would first have them diagnose why it is setting prematurely. Perhaps the sensitivity is set too high. Have them make the adjustments and see how it goes.


Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Posted on Jan 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Low battery alarm


Sounds like you spiked/damaged the aftermarket alarm module.

Oct 24, 2013 | Chevrolet Cavalier Cars & Trucks

1 Answer

2004 trailblazer ext high beam headlights wont turn off and the relay makes high pitched noise


Need to check the ground path on the squealing relay. A poor ground will cause this condition.

Feb 27, 2013 | 2004 Chevrolet Chevrolet TrailBlazer EXT

1 Answer

Headlight wiring low voltage


A battery's voltage is properly tested under load. This sounds like your battery is low on fluid or has not been charging properly. Not charging properly could be from low battery fluid, poor cable connections or a failing alternator. You did not state whether you tested this voltage issue with the vehicle running or not. If the vehicle was running when you observed this change in voltage upon turning on the headlights, then a bad alternator is most certainly suspect.

Aug 26, 2012 | 2004 Toyota Sequoia

2 Answers

My Sequoia keeps losing power temporarily on inclines and sometimes on flat road. The VSC Trac light flashes when this happens. There's nothing slippery about the roads. It'll even happen in a parking...


If you have good spark plugs replced, New/ clean Air filter and using the proper gas! you need to check with a good workshop, cause propably you have an issue with the Torque coverter in your transmission! Good luck

Nov 12, 2010 | 2006 Toyota Sequoia

1 Answer

Installed driver side headlight worked, an hour later both main headlights went out, when I went to check lights noticed that there was another headlight behind a little chrome cover that was out, could...


reasons bulbs keep blowning.your head light bulbs is halogen bulbs.dont touch with bare hands.the oils on your hands will make them over heat and blow.so use clean gloves on your hands when replacing the head light bulbs.if all is good.check alternator out put.it could be overcharging causing too much current flow through electrical circuit blowing out bulbs.use a digital volt meter hook it battery with car running battery voltage should be 13.5 to 14.5 volts. if it is 15 to 16 volts too many volts.alternator is faulty.due to lock out features turn off radio before disconnecting battery cables so you wont lose radio playing code.

Nov 24, 2009 | 2004 Honda Accord

1 Answer

2003 Toyota Sequoia won't start.


Have you gotten this problem fixed yet? If not what is the condition of the battery cables( corrosion free)? Also how old is the battery? One dead cell could possibly cause this problem.

Feb 03, 2009 | 2004 Toyota Sequoia

Not finding what you are looking for?
2004 Toyota Sequoia Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...