Question about 2004 Isuzu Rodeo

Open Question

How to remove grill on 2004 rodeo - 2004 Isuzu Rodeo

Posted by Anonymous on

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to find & remove thermostat 2004 isuzu rodeo

in the thermostat housing at the motor end of the upper radiator hose .

Feb 21, 2015 | 2004 Isuzu Rodeo

1 Answer

How to remove fuel pump from the 2004 isuzu rodeo

Remove the fuel tank & take out the pump

Should be You Tube Video on some vehicle
close to yours

May 02, 2014 | 2004 Isuzu Rodeo

1 Answer

Should there be pressure when i remove the fuel filter from my 2004 rodeo

Yes, the fuel system (lines, rail, filter, etc) will be pressurized. It's perfectly normal.

Aug 24, 2011 | 2004 Isuzu Rodeo

1 Answer

Where do i locate the camshaft position sensor on 2004 isuzu rodeo v-6, 3.5lt.

it is located on the inner rear section of the left hand head (left side of vehicle) under inlet manifold dont need to remove inlet manifold
and connector must face rearwards to work correctly


Feb 01, 2011 | 2004 Isuzu Rodeo

1 Answer

How remove the starter on a 2004 isuzu rodeo 2wd 3.5L v6

where is the starter located at on my 2004 izuzu rodeo

Dec 03, 2010 | 2004 Isuzu Rodeo

1 Answer

Need to adjust front headlights

Park the vehicle in front of a wall, at night. Turn on your low beams, and from there, you can adjust it, by, if your Rodeo is like most of the newer vehicles, there are some screws right on top, two up at the front of the grill, one at the back of the headlight, turn them, mostly the back one will be the one you need, until the light hits right where you will need it.

Oct 31, 2010 | 2004 Isuzu Rodeo

1 Answer

How to replace rear speaker grills on 2004 Toyota Camry

Remove the rear seat, pull up and out on the bottom half, remove the sides of the back- one bolt on bottom of each side,remove the backrest, then remove the whole deck lid with speaker grills in it , then you can replace the speaker grills.

Mar 17, 2010 | 2004 Toyota Camry

2 Answers

Replace highbeam 1996 rodeo

Fig. 1: Replacing a sealed beam headlamp

  1. Disconnect the negative battery cable.
  2. Remove the front grille and/or headlight bezel.
  3. Remove the headlight bulb retaining rim, headlight and disconnect the wiring.
  4. Before installing, spray some silicone grease into the bulb socket.
  5. Connect the wiring and install the bulb.
  6. Install the retaining rim and grille.
  7. Adjustment: turn the adjusting screw (A) for vertical adjustment. Turn the screw (B) for horizontal adjustment.

Fig. 2: Replacing a headlamp bulb


Jul 24, 2009 | 1996 Isuzu Rodeo

1 Answer

1995 isuzu rodeo hood release broken under the hood

if the grille screws are accessable remove the grille which should give you access to the underside of the lock, you may need a screwdriver to push the lever aside to release the hood
Hope this helps

May 23, 2009 | 1995 Isuzu Rodeo

Not finding what you are looking for?
2004 Isuzu Rodeo Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

75817 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides