Question about 1995 Toyota 4Runner
Am tryi;ng to locate the ECU on my 4-runner. 1995. Where should I look on my care????? Thanks Teri
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: electrical diagram
Might this help?
here and here.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards. Thank you for using FixYa.
Posted on Aug 16, 2008
Diagram is unnecessry.
Pull both front wheels
Work one at a time leaving the other for reference
Find the retention spring ... its a paperclip thickness wire spring... dislodge center retention loop and undo from both ends which engage brake pad retention rods.
Pull the rods out
Pull the old pads out... laying everything on the ground
Use scrap wooden wedges to pry between the rotor and the caliper ...inside and out until the calipers are fully withdrawn. Use the new pads to measure if they are far enough back.
Note... the brake fluid will have dropped in the master cylinder over many months of wear... do not fill it. When the calipers are pushed back they will fill the reservoir again... one wheel at a time.
Be sure to identify the correct pad based on what you took out and what is on the other side (if you screwed up the layout)
Make sure to take the old antisqueek backing plate from the old pad and place it on the new pad. They don't use lubricant on these anymore.
Replace the pads... the retention rods... then the retention spring
Do the other side
Then progressively step on the brake peddle until full tension is felt
Check the master cylinder reservoir... probably needs no additional fluid.
New pads will register in existing ridges in each disc in no time at all.
You should check the discs to see if they need to be replaced during this operation...using some calipers
Posted on Mar 25, 2009
There is a heater core bypass pipe that runs from the block (under the manifold) to the bacl of theengine where you will see a flat rectangular "sheet metal" thing with a pipe coming out of it. The a rubber hose connects. You need to pull the top air plenums and intake to get to it. The p[ipe flange bolts to the block with silicone rtv as a sealant.
Posted on Nov 27, 2009
Tips for a great answer:
Feb 24, 2015 | 1995 Toyota 4Runner
Nov 11, 2014 | 1995 Toyota 4Runner
Jul 31, 2012 | 1995 Toyota 4Runner
Aug 24, 2011 | 1993 Toyota 4Runner
Aug 13, 2010 | 1995 Toyota 4Runner
Apr 14, 2017 | 1989 Toyota Camry
Sep 14, 2009 | Toyota 4Runner Cars & Trucks
May 19, 2009 | 1986 Toyota 4Runner
Dec 08, 2008 | 1995 Toyota 4Runner
Aug 16, 2008 | 1992 Toyota Celica
20 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: