Question about 1988 Cadillac Sedan DeVille

1 Answer

'88 toyota camry rear window stuck in down position

My 1988 toyota camry has power windows and i've tried just about everthing except removing the door panel and manually putting the window up. i do not know how to take the door panel off properly -- can anyone help me?

other ideas would be helpful as well -- do i have to take the door panel off?

Posted by on

  • shalb Apr 14, 2009

    I have a similar problem other than it's the driver's window that can't move. The panel controlling the other windows on the driver's door doesn't work either (it can't open its window or any other window), but the door lock and window lock does work despite being a part of the same panel. I tested all the fuses and they all are fine. I've taken out the panel, but I'm not sure how to test it. Can anyone help?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Have you tried to remove the doors window switch and ensure that you have a good 12 volts at the switch? I assume when you said you've tried everything that meant you checked the fuses. You can check with a voltmeter but a test light will actually ensure good voltage.

Posted on Feb 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Diagram for 1988 Toyota camry power window switch


I have the same issue, I can't find anything online for the location of the power window relay or the circuit for the power windows.on a 1988 Camry. Either the internet is lame or the 1988 Camry is truly bullet proof, where there are no people that ever had the same problem where it would be posted online and we could find it with ease

Aug 07, 2011 | 1988 Toyota Camry

1 Answer

I have a 88 bronco and my rear window will not go down. i have tried running a wire from battery to motor for hte rear window and it wont work i just want the window down right now and will replace motor...


take the window regulator out and see if you can manually move it to the down position, if you cannot them try and connect that regulator to another window motor, and get it to the down position that way. then reinstall the regulator and window, good luck

Aug 08, 2010 | 1988 Ford Bronco

1 Answer

88 Toyota Camry... windows wont let up.i checked fuse box on drivers side, none were blown, so i bought a used one... still not working.


poss window motor is shorted out or have abroken wire do u hear ur window motor working? if not hten u have a bad window motor

Apr 04, 2010 | 1988 Toyota Camry

1 Answer

1995 Toyota 4 Runner rear window will not open, on


check to make sure that the wiper is not stuck in the window seal. Pull it out if it is and then try. The window will not roll down if the wiper is in that position.

Nov 19, 2009 | 1995 Toyota 4Runner

3 Answers

'88 Camry Power Windows and Locks Won't Work


at the drivers side panel there are 2 relays with metal tops on them.Push the little holes on top of the with a paper clip and reset them.This may help

May 26, 2009 | 1988 Toyota Camry

1 Answer

The window motor keeps going out.


maybe it's the switch not the motor

Apr 05, 2009 | 1999 Toyota Camry

1 Answer

'88 toyota camry rear window stuck in down position


To get to the Window:

Remove Door Inside Handle:
remove screw, slide the handle forward.
Disconnect the control link and remove the handle.

Remove Door Trim with Inner WeatherStrip:
Remove the two screws from the armrest.
Insert a screwdriver between the trim retainers and the door panel to pry it loose.  Eight hidden fasteners. 1 top left side of door.
1 right side about same height as top of armrest. 1 (each side) about same height as bottom of armrest. 1 on each corner bottom. 1 bottom in middle.  1 on left side between bottom corner and the previous at about lower armrest height...

Remove Service Hole cover.
Remove Door Glass Run.

Remove Division Bar (upper window section divider):
Remove the two screws under the weatherstrip
Remove the bolt.
Pull out the division bar.

Remove the Window Glass:
Place the glass in the door cavity.
Remove the two glass channel mounting bolts.
Remove the window glass by pulling it upwards.

You now have access to the Power Window Regulator; possible replacement of motor etc.

What type of 'things' have you tried for fixing the window and restoring operation?

Jan 22, 2009 | 1988 Toyota Camry

1 Answer

Trying to remove driver side interior door panel on '88 Toyota PU


There is a cotter pin in the window crank, a pair of needle nosed pliers should be able to grab it

Dec 02, 2008 | 1988 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...