Question about 2002 Ford Explorer

Open Question

How to remove steering wheel on 2002 ford explorer

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 24 Answers

SOURCE: Remove the Passenger side door frame on a 2002 Ford Explorer

    Lift up on the switch plate until it snaps out ,remove the bolt from under there and the bolts along the bottom of the panel. There may be a few others so look around. When all are removed lift up on the door panel(DO NOT pull towards you it will destroy the panel). Your mirror is now accessible.

Posted on Nov 29, 2008

Ad
fknstart
  • 404 Answers

SOURCE: removal of rear brake drum 2002 ford escape

make sure handbrake is off take wheel off hit the drum with a mallet not steel,as it will brake,hit on outter diametter face of drum, try and rotate as you twist off

Posted on Jan 05, 2009

alicantecoli
  • 22246 Answers

SOURCE: 2002 ford explorer front wheel bearing assembly

remove hub ,take retaining circlip out and knock it out with a big big hammer supporting it on an old wheel rim and a tree trunk.this job is easy to do but unless you have the right tools entrust it to a garage who will have a nice press .

Posted on Feb 02, 2009

  • 27 Answers

SOURCE: replace rear wheel bearing 2002 ford explorer 4x4

you must remove brakes, then remove axle nut, then remove upper control arm and finally tie rod stabilizer, remove axle from car then bearing can be accessed. this is a difficult job that requires special tools so be careful

Posted on Aug 15, 2009

mitchbtu
  • 121 Answers

SOURCE: 2002 ford explorer rear wheel bearing removal

Rear Wheel Bearing
REMOVAL AND INSTALLATION

1. Remove the wheel knuckle.

Wheel Knuckle
REMOVAL AND INSTALLATION

CAUTION: Do not loosen the axle wheel hub retainer until the wheel and tire are removed from the vehicle. Wheel bearing damage will occur if the wheel bearing is unloaded with the weight of the vehicle applied.

1. Remove the wheel and tire assembly.

NOTE: Have an assistant press the brake pedal to keep the axle from turning.

2. Remove the nut and washer and discard the nut.

3. Remove the parking brake shoes.

CAUTION: Do not damage the boot while separating the toe link from the knuckle.

4. Remove the nut and bolt and separate the toe link from the wheel knuckle and discard the nut.

CAUTION: Do not damage the boot while separating the ball joint from the knuckle.

5. Remove the nut and bolt and separate the upper ball joint from the wheel knuckle and discard the nut.

CAUTION: Do not use a hammer to separate the outboard CV joint from the hub. Damage to the threads and internal CV joint components may result.

6. Using the special tool, press the outboard CV joint until it is loose from the hub.

7. Remove the nut and bolt and the wheel knuckle, hub and bearing as an assembly and discard the nut.

(Return to)
Rear Wheel Bearing
REMOVAL AND INSTALLATION

2. Remove the three bolts.

CAUTION: Make sure that the press adapter outside diameter is slightly smaller than the hub outside diameter or damage to the knuckle will result.

3. Using a suitable press, remove the hub from the bearing and discard the hub.

NOTE: The retainer ring is tapered and must be installed flat side down.

4. Remove and Discard the retainer ring.

5. Using a suitable press, remove the bearing from the wheel knuckle and discard the bearing.

CAUTION: The hub and bearing cannot be reused after disassembly.
To install, reverse the removal procedure.

Posted on Jan 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford Explorer 2002 grinding and vibration under 60 mph


you have wheel bearings failing
the random abs light is the rotor for the sensor touching the sensor head because the wheels are loose on the shaft

Apr 15, 2017 | 2002 Ford Explorer

1 Answer

My horn on my 2002 ford explorer went off and would not stop honking until we hit the middle of the steering wheel.....is the horn connected to the air bag or seperate. is it a censor in the steering...


If you have an aftermarket burgler alarm in it i would check wiring where it was installed. If not it is probably a malfunction in the contacts in the steering wheel. If checking the steering wheel unhook the battery and let it sit for a few minutes. It is always good to do this so the air bag will not deploy.thanks

Feb 28, 2011 | 2002 Ford Escape

1 Answer

What would make the front wipers quit and the rear go all the time, 2002 ford explorer 4 door


possibly a malfunctioning multifunction switch, turn signals and such, recommend dealer repair this situation as it involves removing the steering wheel to repair if it has failed.
the other could be broken and shorted wires, again dealer as there are a ton of wires and you would need a wiring diagram to follow to get correct wires for repair.

Dec 22, 2010 | 2002 Ford Explorer

1 Answer

Why does my horn start to hook for no reason


usually caused by button on steering wheel breaking or the wire grounding out somewhere in the column. You have to remove the steering wheel with a puller to see what's wrong. If you need instructions, please let us know.

Oct 04, 2010 | 2002 Ford Explorer

1 Answer

How to remove steering wheel /air bag to get at cruise control switches.


On the back side of the steering wheel. there will be two small hole's at each end of the wheel, remove those bolt's, remove air bag and disconnect it.

Jul 02, 2010 | 2002 Ford Explorer Sport Trac

1 Answer

2002 explorer horn inop


In most cases this problem is caused by the rotating ribbon circuit contact under the steering wheel having a broken filament, the part is known as a clock spring contact, u will need to properly disarm the airbag and remove the steering wheel to access the part. WARNING: Failure to disarm the airbag system can result in an unexpected Airbag deployment and possible serious personnel injury disconnect the battery 30 minutes prior to start of work.

Mar 29, 2010 | 2002 Ford Explorer

2 Answers

Free fuse box diagram for ford explorer 2002 XLT


Heres the definitions of the fuse numbers:
graphic.aspx?mod=reptiff&module_id=1&session_id=%7b812b1a44-e9f7-498d-9233-3843c35aa6d4%7d&image_guid=00323000&print_bw=0& graphic.aspx?mod=reptiff&module_id=1&session_id=%7b812b1a44-e9f7-498d-9233-3843c35aa6d4%7d&image_guid=00323003&print_bw=0&

Feb 27, 2010 | 2002 Ford Explorer

1 Answer

2002 ford explore steering wheel is locked and my key wont turn


try turning the steering wheel hard as u turn the key

Oct 01, 2009 | 2002 Ford Explorer

1 Answer

Location turn signal flasher 1998 ford explorer


You find the flasher on the steering column. You have to remove the cover located between the steering wheel and instrument panel. There you find the flasher.
Before replacing the flasher check the wirings to the flasher.

Feb 24, 2009 | 2002 Ford Explorer Sport Trac

1 Answer

2002 Ford Explorer wont shift into park


hello megervin i had this problem be very careful there is a very delicate part that will brake made of aluminum this connects the shifter to the steering colar you try to force it and it will break try to remove the cover from under and around the steering wheel there is a linch pin that may be your problem if it breaks you can get one at the junk yard but BEWARE THIS IS A PART OF THE STEERING COLAR THEY MIGHT NOT SELL IT TO YOU THEY WILL TELL YOU YOU NEED THE WHOLE THING TAKE CAUTION LOL

Feb 13, 2009 | 2000 Ford Explorer

Not finding what you are looking for?
2002 Ford Explorer Logo

Related Topics:

353 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...