Question about 1990 Chevrolet S-10 Blazer

Open Question

How to replace window guides for 1990 s10 blazer

Window guides replacement

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: 1991 chevy s10 blazer

Check the fuse under the dash. Did you replace the inline fuel filter? If not, you could loosen the line going into the filter then turn the key to the on position. The pump should run for about 2 seconds then the relay should kick off. Turn off the key for approx. 5 seconds then cycle key back on and the pump should cycle again. If you get a 2 second burst of fuel each time then the pump is cycling. Install a new fuel filter and check the grounded wire by the tank. Hope this helps. :)

Posted on Nov 03, 2008

Ad
emissionwiz
  • 76164 Answers

SOURCE: replace thermostat 1994 s10 blazer

follow the upper radiator hose to the engine, under the nipple that the hose attaches to on the engine is the thermostat, 2 bolts and maybe a bracket VERY EASY TO DO.

Posted on Feb 10, 2009

  • 82 Answers

SOURCE: 1999 Chevy S10 Blazer 4x4. Replacing rear pad's,& Bleeding Breaks

have one person in the blazer pumping the brake pedal and then hold to the floor, crack the bleeder then tighten, release pedal, repeat till all air is out one side at a time, if this does not work then your ABS unit is bad witch if u follow your lines from your master cylinder u will find a black box with a motor on it, or the master cylinder itself is bad, it also can cause u to have no pedal, replace the master cylinder first, most likely cheaper.

Posted on Mar 11, 2009

rockitman187
  • 2559 Answers

SOURCE: S10 blazer speed sensor where's location for replacement

On the rear axle.

Posted on May 06, 2009

  • 272 Answers

SOURCE: My Liftgate wont stay open

Buy them here or your local autozone or napa real easy install.

http://www.am-autoparts.com/AM/Hood-Hatch-Lift-Supports/Chevrolet/S10Blazer/-/AM-19070848/?utm_source=google_base&utm_medium=cpc&utm_campaign=new_google_base_feed

Posted on May 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace my starter?


Open hood.
Disconnect negative (-) batter cable
Locate the starter (under vehicle).
Remove electrical connections. (be sure to remember/take a picture/ make a drawing/ or mark which wires go to what posts)
Remove mounting bolts.
Remove starter, replace with new starter
Install mounting bolts
Install electrical connections

Jan 06, 2010 | 1990 Chevrolet S-10 Blazer

1 Answer

1990 chevy s10 blazer 4wd. Xmsn whines.


if this happens only in the morning after you start for the first time its the clutch on the fanblade needs replacing

Dec 02, 2009 | 1990 Chevrolet S 10 4WD

1 Answer

Passenger side door window fall to one side when opening


you need to replace your window guides,real common on s10,your local parts store carries them

Mar 28, 2009 | 1990 Chevrolet S-10 Blazer

1 Answer

Gear ratio


There are two different ratios for a S10 Blazer,a 3.42(GU6) and a 3.08(GU4).Look in your glove box for a GM option codes.Look for a GU6 or GU4 code for the type of ratio you have.Hope this helps.

Mar 13, 2009 | 1990 Chevrolet S-10 Blazer

2 Answers

Replace thermostat 1994 s10 blazer


follow the upper radiator hose to the engine, under the nipple that the hose attaches to on the engine is the thermostat, 2 bolts and maybe a bracket VERY EASY TO DO.

Feb 10, 2009 | 1994 Chevrolet S-10 Blazer

2 Answers

1991 Chevy Blazer S10 window motor installation


http://www.a1electric.com/s10motor.htm. This link has pictures and step-by-step instructions. I found it and have both sides to replace. Hope this helps.

Aug 08, 2008 | 1991 Chevrolet S-10 Blazer

Not finding what you are looking for?
1990 Chevrolet S-10 Blazer Logo

Related Topics:

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...