Question about 2002 Buick LeSabre

1 Answer

2002 buick lesabre driver side regulator motor removal

How to remove the left front window regulator and motor removal and install

Posted by on

  • bob collins
    bob collins May 11, 2010

    Are you still trying to do this?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,990 Answers

You will need to Drill out the Rivets that Hold them Right Now and Use Screws to Reinstall.

Posted on Jan 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

I need instructions on install/uninstall right rear power window on a 2002 Buick Lesabre.


First you need to remove the inner door panel, it will be held on by screws and clips.

Jul 21, 2008 | Buick LeSabre Cars & Trucks

Tip

How To Install Replace Rear Power Window Regulator Buick LeSabre 00-05...


How To Install Replace Rear Power Window Regulator Buick LeSabre 00-05 1AAuto.com


on May 08, 2012 | 2000 Buick LeSabre

1 Answer

Driver side front door window will not move. Some sound, but no movement. How to Replace Window motor regulator on this 2000 Buick LaSabre Limited driver's door with multiple controls: Locks, speakers,...


First the door panel must be removed,then you can tell what part is broken.It will probably be the window trac assy.To replace that you must drill out the 3/16 rivets that hold it in and then replacethem with 1/4 -20 bolts on re-assembly.

Aug 05, 2010 | 2000 Buick LeSabre

1 Answer

The front drivers side window on my 2002 buick lesabre has fallen down inside the door. What has happened? How do I make the repair?


Your window regulator has failed. It is a fairly easy repair if you have some mechanical abilities. Simply remove interior door trim, there are mostly clips that hold this on but possibly a few screws/bolts. Under the trim is a water barrier that is attached with a tar looking adhesive, remove this as well but save it to re-install later. You'll have to pull the glass up inside the door to a point where you can get to the bolts on the clamps that hold it in the regulator, I like to use some duct tape to secure it in this position. DO NOT let it drop down inside the window again for this can break it. You are now ready to remove the old regulator.

Loosen the bolts that clamp the glass, find and remove the bolts that hold the regulator inside the door, disconnect the electrical connector to the motor.

Once you are able to turn the old part to the proper position it should come right out, Install motor on new regulator if necessary and install inside door, clamp window, connect electric connector. Now it's time to remove the duct tape and try it out, if all is good install vapor barrier and trim.

If this helps please leave me feedback.

Apr 15, 2010 | 2002 Buick LeSabre

1 Answer

I need instructions on how to replace power window motor for the front driver side window of a 2002 Grand Cherokee


Power Window Motor: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the window regulator from the door.
3. Place the window regulator on a suitable work surface and remove the screws that secure the power window motor to the window regulator.
4. Remove the power window motor from the window regulator.
INSTALLATION
1. Position the power window motor onto the window regulator.
2. Install and tighten the screws that secure the power window motor to the window regulator. Tighten the screws to 9 Nm (80 in. lbs.).
3. Install the window regulator onto the door.
4. Reconnect the battery negative cable.

Oct 30, 2009 | 2002 Jeep Grand Cherokee

1 Answer

2002 Buick Lesabre drivers side window went down, but won't come back up. Can hear the electric motor working,but window dosen't move. Can't figure out how door panel comes off either.


A couple of things to add to tinyp's solution. For Buicks, the regulator is bolted in, not riveted, which makes removal easier. Also, you'd better get used to this, as I have replaced 3 out of 4 window regulators on my 2002 LeSabre.

Jun 28, 2009 | 2002 Buick LeSabre

1 Answer

2003 ford taurus drivers window will not go up.


you either need a motor or motor and window regulator assembly.
SECTION 501-05: Interior Trim and Ornamentation 2002 Taurus/Sable Workshop Manual
REMOVAL AND INSTALLATION Front Door Trim Panel Removal and Installation
  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
  1. Remove the front door trim panel screws.
  1. NOTE: To release the door trim panel two part pin-type retainers, first pull outward on the bottom of the door trim panel.
    Remove the front door trim panel.
    • Disconnect the electrical connectors.
c64985a.gif --------------------------------------
SECTION 501-11: Glass, Frames and Mechanisms 2002 Taurus/Sable Workshop Manual
REMOVAL AND INSTALLATION Front Door Window Regulator And Motor
Special Tool(s) s2h~us~en~file=st1132a.gif~gen~ref.gif Heavy Duty Riveter
501-D011 (D80L-23200-A) or equivalent
Removal and Installation
  1. Remove the front door window glass. For additional information, refer to Front Door Window Glass in this section.
  1. Disconnect the front door window regulator motor electrical connector.
  1. Remove the window regulator rivets.
-----------------------------
SECTION 501-11: Glass, Frames and Mechanisms 2002 Taurus/Sable Workshop Manual
REMOVAL AND INSTALLATION Door Window Regulator Motor Removal and Installation
  1. Close the window.
  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
  1. Remove the door trim panel. For additional information, refer to Section 501-05 .
  1. If equipped, remove the radio speaker.
  1. Position the watershield aside.
  1. Disconnect the door window regulator motor electrical connector.
  1. Remove the bolts and the door window regulator motor.
---------------------------------------------------

May 04, 2009 | Ford V6 Pony Cars & Trucks

1 Answer

Trying to replace drivers window lift motor. help!!


Tape and secure window, replace rivets with 1/4 nut and bolts.

Apr 28, 2009 | 1990 Buick LeSabre

4 Answers

The left rear door window fell off its track.


LeSabre window regulator cable is kinked...? Can the cable be changed out or unkinked without buying a new window regulator?

Mar 15, 2009 | 2002 Buick LeSabre

Not finding what you are looking for?
2002 Buick LeSabre Logo

Related Topics:

295 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...