Question about Nissan Pulsar

Open Question

How to remove 2006 nissan pulsar glove box - Pulsar Nissan Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Brian032472
  • 150 Answers

SOURCE: How to change the HEPA cabin filter in a 2006 Honda Civic

Open the glove box and there are push out tabs on the left and right side pop them out. Now watch it because you are about to dump the contents of your glove box on the floor. let the box hang freely from the lower hinge and look in the back. You will see a white panel that pulls out the panel has a tray attached with the filter element in it remove old element and replace with new 20ish bucks at the parts store lots more at the dealer. re-install filter tray and reverse your removal steps to re-install. Recommended approx 15k or annually

Posted on Nov 04, 2008

  • 30 Answers

SOURCE: replace cabin filter 2006 Jetta

as far as i am aware the pollen filter is below the glove box just remove the cover below glove box look up with a lighht and you should be able to see filter houseing

Posted on Aug 10, 2009

jlisagearhea
  • 412 Answers

SOURCE: Car maintainance for Nissan Pulsar Vector 1990

Yes, Yes, Yes, and Yes.....All that you want to do you can perform yourself and save quite a bit of money.You can actually find a VERY VERY descriptive online manual(which i have too) at alldata.com You pay a $20 fee and you get online manuals for five years for one vehicle.Definitely worth it.This makes auto work much easier.Any other questions get back to me...I'M HERE TO HELP!!!

Posted on Dec 04, 2009

  • 3600 Answers

SOURCE: vent door stuck and can't remove glove box

why can't you remove the glove box? You can get at the door from under the dash but it's a ***** to do. try lubing the vent cables unless it uses the vacuum motor, if it uses the vac. motor it will be hard to get to without the glove box being out.

Posted on Jan 05, 2010

Testimonial: "Thanks! I just don't know how to remove the glovebox."

roniecon
  • 6826 Answers

SOURCE: strange noise coming from behind glove box

The adjustment on the linkage for a vent door,was off,and you corrected it.

Posted on Feb 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How do i find nissan rogue blower motor


Behind glove box , Remove glove box first

Mar 05, 2015 | 2010 Nissan Rogue

1 Answer

Where is the cabin filter on a 2011 Nissan Murano?


Ok, there can be two ways to do this. On some Nissans you can drop the glove box out without actually removing anything by collapsing the side stops in slightly. This should allow the glove box to "drop" back enough to get straight to the small door for the filter.
Failing that, remove the 3 screws running underneath the glove box and 4 along the top, (with the door open), 1 in each corner and 2 through the latch. With these out you can pull the lower dash trim/glove box assembly as one piece giving you a direct shot at the filter door.
Good luck.

Feb 01, 2015 | 2011 Nissan Murano

1 Answer

How to replace the cabin microfilter


Hello, I'm sending you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.12eb879.gif63a72f6.gif
Thanks

Jul 27, 2010 | 2005 Nissan Quest

2 Answers

Blower heater unit in micra k12


hi did you get the resistor fixed if not you need to remove the glove box by removing the screws that can be seen then there are two plastic lugs that need to be pulled out sideways to enable you to remove the glove box then you will see the resistor card on the side of the motor thats on the new shape micra k12

Mar 03, 2010 | 2006 Nissan Z

1 Answer

Where is pollen filter,nissan pathfinder 2006?


open the glove box and press on one side to get it open completely
remove the screw on the cover
remove the air filter
make sure you put the new one in with the right dirrection of air flow

Mar 01, 2010 | 2006 Nissan Pathfinder

1 Answer

I need to replace my Nissan Quest 2007 in cabin micro filter


I'm going to send you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.12eb879.gif63a72f6.gif

Oct 10, 2009 | 2007 Nissan Quest 3.5 Minivan

2 Answers

1991 Nissan Pulsar - stereo security code...??


most times all codes are a basic number like(12345 or 11111) something in this order give it a try this might work i hope this helps you out have a great day :)

Nov 21, 2008 | 1990 Nissan Pulsar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...