Question about Audi A4
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
IF YOUR ENGINE WON T TURN OVER AFTER YOU FITTED A NEW STARTER MOTOR..I WOULD START WITH THE BATTERY MYBE DEFECTIVE NOT HOLDING FULL CHARGE....THEN CHECK WIRING.....GET BACK TO ME IF YOU NEED MORE HELP !!
Posted on Mar 17, 2009
this is info i pulled but not sure exactly what engine you have...here are a couple though
REMOVAL & INSTALLATION
Fig. After the negative battery cable is disconnected, remove the wire terminals from the starter solenoid
Fig. Remove the lower starter mounting bolts . . .
Fig. . . . followed by the upper bolt, then remove the starter from the transaxle housing
Fig. Lower starter bolt locations-1994 2.0L, 2.0L ABA
Fig. Remove the upper starter bolts
Fig. Mark the location and length of each starter bolt
Fig. When the solenoid is energized the starter drive is pushed out and meshes with the flywheel to crank the engine
The engine must be supported on 1990-97 Passat models as the starter mounting bolts also support the engine-to-transmission mounting surface. If necessary, label the small wires before disconnecting them.
On 1990-97 Passat models:
Release the number 50 electrical connector from the starter.
Remove the starter mounting bolts, while supporting the weight of the starter.
On vehicles with a manual transaxle, there is a bushing where the starter shaft fits into the bell housing. If the shaft or bushing is worn or if the starter has been jamming, the bushing should be replaced. There is a special bushing removal tool available but a small inside bearing removal tool is usually sufficient.
Install the starter into the transaxle.
Posted on Jul 09, 2009
SOURCE: Audi a4 ABS light on
ensure the ecu connection is good the plug for those sometimes need a good amount of pressure to put on abs light i would check the sensors next to your brake caliper to ensure its not broken or disconnect it or if you dont feel like checking it buy new ones and replace them
Posted on Nov 03, 2009
The blower motor is located behind the glovebox.
You will need to remove the glovebox and you will see the blower motor at the top right side. Remove the screws holding it, disconnect the electrical connector and remove it from the car. It is a tight squeeze, be patient.
Posted on Jan 31, 2010
Tips for a great answer:
Nov 10, 2016 | 1997 Audi A4
Sep 03, 2011 | 1999 Audi A4
Aug 20, 2010 | 1997 Audi A4
Jul 11, 2010 | 2004 Audi A4
Jun 04, 2010 | 2000 Audi A4
Dec 19, 2009 | 1998 Audi A4
Sep 17, 2009 | 2000 Audi A4
Sep 17, 2009 | 1997 Audi A4
Mar 15, 2009 | 1998 Audi A4
Dec 10, 2017 | Audi Cars & Trucks
18 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: