Question about 1995 Toyota Corolla
Is a 95 corolla 1.8 a free floating or interference engine?
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The 2001 Camry 2.2 has a timing belt.
Recommended change interval is 90,000 miles.
There is no good reason for putting the replacement off, as the belt may be stretched slightly when it nears the rec replace interval, and your mileage may suffer because the engine is not in proper "time".
If the belt jumps time or breaks, it will NOT damage the valves.
Posted on Sep 20, 2008
malibluert: YOUR IN LUCK! This series engine is simple and the references aren't hard to find. READY???????
IF you are just trying to reset the belt at the top and have not remover the crank pulley, bring the crank around to Top dead center on the # 1 cylinder,. It will read Zero degrees on the timing mark scale.
Up top, look at the cam gear closely You will see that there are 5 spokes which support the actual gear. Look closer and you will see that one of these spokes has a small hole in it about 3/4th of the way towards the outside of the gear. Position the gear to where that hole is at 12:00 PM. NOW, if you look thorough the hole, you should should see a small notch that the hole should be centered on. If not, move the gear until you can look through the hole and the notch falls dead center. At that point in time, you have the crank ant camshaft in perfect time with each other.
When you put the belt on, make sure that the side which is slack is the tensioner side. You should be able to slip the belt on, matching the teeth with the teeth on the gears to where one side is fairly tight and you can not roll the cam counter clockwise.
IF you are replacing the belt, you have the crank pulley off and you position the woodruff key straight up at 12:00 PM and the procedures are all the same other than that. when you set the tension. A good rule of thumb is to find the longest span of belt, and with your thumb and forefinger twist the belt. if it twists to 45 degrees toward the block, it's perfect. Any more or less, needs to be reset.
I hope my answer suffices. A picture wouldn't be any more clear.
Let me know how you did.
NOTE: This engine does NOT bend valves when a timing belt fails.
Posted on May 06, 2009
Your 2003 corolla has a timming chain with no maintenance interval.
It is a good idea to replace your serpentene belt if it has not been replaced. Your motor is an interferance motor.
Posted on Sep 13, 2009
Testimonial: "Thanks, I will have the belt replaced when I have all the fluids changed next week. The car has 7 years on the road with no problems."
Tips for a great answer:
Mar 08, 2015 | 1996 Toyota Corolla
Nov 12, 2013 | 1995 Honda Accord
Jan 31, 2013 | Cars & Trucks
Dec 17, 2010 | Isuzu Rodeo Cars & Trucks
Sep 08, 2010 | 2002 Mitsubishi Galant
Feb 11, 2010 | 1992 Honda Accord
Feb 09, 2010 | 2002 Kia Rio
Nov 21, 2009 | 1995 Nissan Pathfinder
Sep 13, 2009 | 2003 Toyota Corolla
207 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: