Question about Ford F-250

Open Question

I have 2007 fiat doblo 1.3 turbo diesel when you start it up it only fires on 3 cylinders when you hit the turbo it fires on all 4 cylinders plus I am only getting 35 miles to the gallon any thoughts please.

Posted by on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 608 Answers

SOURCE: fiat doblo 1.9 diesel year 2007. engine stop when low fuel tank

There is a possibility that your fuel transfer pump has quit and fuel is getting to your engine by gravity only. Have your tranfer pump flow rate tested. Also renew your primary fuel filter.

Posted on Mar 23, 2010

Testimonial: "i will check the fuel pump. i guess i will hear the pump start when i turn on the ignition. But - the engine also have stopped downhill(reg gravidity)"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rav 4 turbo diesel 1 2 3 cylinders are all working when you take off connector when running no 4 nothing happens


There is a fault with no 4 cylinder. Could be: Faulty new injector, faulty ECM not firing injector, low compression on that cylinder. I'm assuming its a newer common rail model - I suggest getting the injector swapped to another cylinder and see if the problem moves. IE: swap no 2 and 4 injectors - if the problem moves to no 2 then the injector will need to be replaced.

Jan 31, 2015 | Toyota RAV4 Cars & Trucks

1 Answer

How do I set tappets of a 2.5 diesel turbo mazda


you haven't mentioned if it is a 4 cyl or not. However bring no 1 cylinder up to tdc and watch the tappets of the next cylinder to fire. when that cylinders rockers are in valve overlap situation ( exhaust starting to close and inlet starting to open) then that will be maximum clearance on no 1 cylinder and is when you set the tappets turning the engine until the next cylinder is at TDC watch for the next cylinder again to be in valve overlap and repeat as for no 1 cylinder

Dec 25, 2014 | Mazda Cars & Trucks

1 Answer

Fiat Palio 1.2 firing order


didnt change them 1 by one, you bad boy.

id get the real engine name and google that or buy the FSM book.
at FIAT.

1.2 F.I.R.E engine.
comes in 2 favors
  • 8v SMPI VVT (2007 - current)
  • 16v SMPI (1998 - 2009)
most non boxer engines, are 1,3,4,2 (but this is pcm job not you )
google shows
IT'S WASTED SPARK SYSTEM !
google hit #1
It's cast into the cylinder head. Look across from the passenger side of the car- you'll see 2314 just above the coils.

sounds like this engine is with a COIL pack, You never said.
and with a twin pack , all 4 bangers are wasted spark.
so 2nd 3 fire on one coil (in series) and 1and 4 fire in tandom.
but the PCM sets order. not you,
it only needs to have to pack wired right.
and is clearly marked on most better made coil packs
did you look first.?

---------------------------------------------------------------------------
one more google poster , no FSM. shows
coil towards the front of the car is cylinder 2 and 3
coil towards the back of the car cylinder 1 and 4
as shown below

make sure you have the plugs to the coils the right way round thou i

4 ----[o]4
1 ----------------[o]1
2 ------------[o]2
3 --------[o]3

-----------------------------------------------------------------
me.....
when the PCM fires coil 1/4 , it better be wired to 1 and4 or
it will not run. (ir shakes like a wet dog)
simple as can be.

yes, the front cylinder is #1
now where is front. you say?, that be, on the crank pulley end.
not the clutch.side.

if still confused a drawing is easy to make.
1sparkfront, to 1 coil
2 spark to coil 2
3 spark to coil 3
4 spark to coil 4. rear cylinder is 4.
1,2,3,4 front to rear.

Jul 15, 2014 | 2008 Fiat Palio 1.2

1 Answer

Cannot locate alarm on 03 plate,1.9 jtd model,can't switch of


post the symptoms. "cant switch off what, exactly"?
the FSM covers the tests, ever heard of the FSM. (buy it at the dealer)
or alldata.com1.9JTD,
i get to decode JTD ,thanks for not posting maker , model
Is this a FIAT"? why must i guess.?
uniJet Turbo Diesel,
Some PSA Peugeot Citroen diesel engines are also rebadged JTD units.
Applications:

pick one, and state country?
some (most?) alarms vary by country (LAWS dictate that)

Jun 14, 2014 | Cars & Trucks

1 Answer

Doblo diesel 2007 diesel 1300


jack car up support it ,disconnect battery cable+,locate starter 2 bolts holds it to block,remove them ,wire from the battery will be connected to starter turn starter until it releases from block lower it slowly take wrench5/16 or 10mm and disconnectfrom starter,put backwards

Dec 03, 2013 | 2007 Fiat X1/9

1 Answer

Fiat doblo 54 1.9 non turbo starts up. up and down at idle


Check for leaking intake manifold or vacuum hoses.

Oct 28, 2012 | Fiat Doblo Cars & Trucks

2 Answers

I have 2006 fiat doblo van diesel which wont start after along time standing how can i reset it


check all connectors, fuse and check smo hose and pipe for clogging(air&fuel lines)

Jun 19, 2010 | 2006 Fiat X1/9

1 Answer

Firing order for 92 plymouth laser


For the 1992 Plymouth Laser:
I do not know if you have the 1.8L SOHC or 2.0L DOHC (or Turbo) In-Line 4-Cylinder Engine; however I have included both below.

For the 1.8L SOHC In-Line 4-Cylinder:
Firing Order:
1-3-4-2
Cylinders:
..........(back)...........
|...1....2....3....4...|
.........(front)
Distributor:
.....(back)
..(+)
..............1
2
.................3
...4
..............(+)
.....(front)

For the 2.0L DOHC (AND TURBO) In-Line 4-Cylinder
Firing Order:
1-3-4-2
Cylinders:
...........(back)..........
|...1....2....3....4...|
..........(front)
Ignition Connections:
(back)
...3
...2
...1
...4
(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

May 07, 2010 | 1992 Plymouth Laser

1 Answer

Fiat doblo 1.9 diesel year 2007. engine stop when low fuel tank


There is a possibility that your fuel transfer pump has quit and fuel is getting to your engine by gravity only. Have your tranfer pump flow rate tested. Also renew your primary fuel filter.

Mar 18, 2010 | 2007 Fiat X1/9

1 Answer

Loss of clutch


Call the Fiat dealer and get the parts department. Tell them whats happening and ask if they offer a stronger plunger. If they dont, call a high performance auto parts store and ask if they have a racing clutch master cylinder. If they do, go look at it and see if its the same plastic plunger. It should be a heavy duty plunger.

Sep 03, 2009 | 2006 Fiat 124

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...