Question about 2004 Ford Freestar

1 Answer

MY 2004 F0RD FREESTAR WONT START IT HAS FULL BATERY BUT DOESNT EVEN CLICK WHEN I TURN THE KEY

EVERYTHING WORKS BUT WHEN I TURN THE KEY IT WONT CLICK OR TURN

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 35,601 Answers

Could be starter failure

Posted on Jan 10, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: 1998 ford contour start up, alternator? battery?

Sounds to me like you drained your donor battery to the point where you can't jumpstart your car anymore. If you jump a car and it runs for a little bit but then dies that means your alternator is toast. If it was a bad ground, you would see sparks or a fire... Your battery only starts the car, once it is running your alternator supplies the electrical system and charges your battery back up. If you need more in depth help in replacing the alternator go to www.contour.org and get on the forums.

Posted on Oct 27, 2008

  • 12 Answers

SOURCE: have power but when i turn key i get nothing. no click,no starter???

I had a similiar problem, I had a bad sensor at the back of the engine, it was connected by 2 hoses to the EGR pick up tube.
I unplugged the sensor and the car started, I drove it to the parts store and replaced the part and it ran great after.

Posted on Apr 29, 2009

  • 636 Answers

SOURCE: cruise control doesnt wok

any fluctuation on the speedometer ? could be the speed servo senser. Servo is located usually on the drivers side strut tower. Hope this helps.

Posted on Jul 28, 2009

  • 32 Answers

SOURCE: 2005 ford freestar wont start

Check the battery. If the battery is weak all you will hear is the starter soliniod clicking. Make sure that all of the cables have good clean tight connections.
Most Auto parts stores can test your battery to see what shape it is in.

Posted on Sep 19, 2009

kel1guy2002
  • 3740 Answers

SOURCE: my 2004 v6 ford explorer won't start new batery

Here is the deal.. you disconnected the battery and the factory alarm module / keyless door entry is perventing engine start.
Open the drivers door with your key and then press and hold the alarm valet switch under the left side of the dash near the left side wall of the drivers' compartment and then turn on the ignition key.
Then start your vehicle.

If you still have the origanl vehicle manuals for the auto / radio / alarm and keyless entry follow the PROGRAMMING instructions in the alarm / keyless entry manual to start your vehicle.

Thanks for using Fixya.

Kelly

Posted on Apr 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why won't 2004 Ford Freestar start, but the dash lights up?


More than likely a key problem. Dont mess with any fuses. A bad keywhen turned wont make any noise. If you have a 2nd key please try that first. If that is your only key consult a locksmith to see if they can program another key. Dont throw away a bad key it may be able to be reused. Good luck.

Feb 25, 2015 | 2004 Ford Freestar

1 Answer

I replaced the starter in my 2004 ford freestar and it still wont start.whats wrong now


Bad relay under the hood on pass side above the radiator it's a black box there are relays in there and your main power one is bad but will act like you can turn the key and nothing ?? Correct look in there switch the relays around I guarantee it will start regards Chris

Jun 02, 2014 | 2004 Ford Freestar

1 Answer

96 f 150 f0rd starts when cold but not after it warms up


Doesn't want to turn over, or doesnt want to run even though it turns over? If it turns over but just wont "catch", then you most likely have a problem with your anti bleed back valve in you fuel injection system. The system isn't holding the proper fuel pressure for a warm start.

Jan 18, 2013 | 1996 Ford F150 Regular Cab

1 Answer

Ford freestar would not start replaced battery it lights up but still wont start


If you turn the ignition switch to START and hear a relay click but do not hear the starter run, chances are the starter has failed. I have had that experience with a Ford

Nov 13, 2012 | 2004 Ford Freestar

1 Answer

2004 f0rd freestar 3.9 engine it still runs slugish... i have changed 1. spark plugs 2. ignition wires 3. ignition coil 4. sprayed wire dry on harnesses and ignition wires and coil the van still...


O2 sensors get changed at 100,000 miles
Has that been done?

Has the TPS Sensor been tested with a scan tool
or oscilloscope?

Have you cleaned the MAF Sensor

All these items should be part of your preventative
maintenance,just as spark plugs

There is no need what so ever to change wires or coil,
unless they are tested & fail a test

Sep 20, 2011 | 2004 Ford Freestar

1 Answer

Drive 2007 grand prix. wont even turn over or click.lottsa batery. Everything works. Just wont start or turn over. When starts and I drive it, then stop and turn off,sometimes wont start. Half to sit a few...


SOUND LIKE ALTERNATOR NOT CHARGING BATTERY.CHECK BATTERY VOLTAGE SHOULD BE 12.6 VOLTS.MAY SURE BATTERY CABLES CLEAN AND TIGHT.WITH ENGINE RUNNING CHECK ALTERNATOR OUT PUT AT BATTERY.SHOULD BE 13.5 - 14.5 VOLTS WITH ENGINE RUNNING.IF ALTERNATOR FUSE GOOD AND ALTERNATOR BATTERY FEED WIRE AND VOLTAGE REGULATOR WIRES OKAY NOT DAMAGED.DRIVE BELT NOT SLIPPING OR BELT TENSIONER NOT DAMAGED.ALTERNATOR MORE LIKELY FAULTY.TURN OFF RADIO FIRST.BEFORE REMOVING NEGATIVE BATTERY CABLE TO KEEP FROM LOSING RADIO CODE.

Apr 10, 2011 | Pontiac Grand Prix Cars & Trucks

1 Answer

The motor wont turn over i have power to everything else. i turn the key and the motor doesnt even click or attemp to turn


possible starter issue, try to lightly tap starter with hammer, be very cautious when doing so, you will damage starter if you hit it to hard, after tapping starter start car if that does not work another simple possibility is the steerwheel lock, with ignition on off possition turn steering wheel, listen for click, then turn key to start.

Mar 21, 2011 | 1988 Ford Mustang

1 Answer

My wife drove her ford freestar thru three feet of water and now the car wont start or even turn over.


sounds like its hydrolocked. remove the spark plugs and see if it will turn over. if it does replace the plugs and change the oil

Jun 07, 2010 | 2004 Ford Freestar

2 Answers

My 2004 v6 ford explorer won't start new batery and new starter no luck wont even click ?


Did you check the start relay for voltage? Ohms reading?

If I remember correctly the circuit goes like this:
Key turns ignition switch which puts voltage to the start relay which engages the solenoid.
So if it isn't even clicking and your headlights seem to be working fine then it is either the ignition switch or the start solenoid coil.
On older Fords the start solenoid used to be remote mounted on a fender. I heard newer Ford vehicles had it integrated with the starter like GM does.
A quick visual inspection will tell you which and where you need to look.
You might check if there is a fuse for that as well.

Apr 01, 2010 | 2004 Ford Explorer

1 Answer

Batery is good new starter new starter relay wont start dash comes on when key is turned but wont turn over or even click its like there is no power to starter it all starter when i jumped my lawn mower i...


did you check main fuses under hood, and also check for brunt fusible links,(looks like wire but inside bruns like a fuse).if everything is good then next step is ignition switch. hope this helps.

Oct 12, 2009 | 1996 Dodge Neon

Not finding what you are looking for?
2004 Ford Freestar Logo

Related Topics:

257 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...