Question about 1986 Ford F 250

Open Question

1986 c6 transmission stuck in reverse - 1986 Ford F 250

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 750 Answers

SOURCE: ford c6 transmission not shifting???

you may have a block trans air vent which may explain the blown seal and may also fect shifting

Posted on Sep 09, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1986 f150 steering column


Just swap the gear indicators.

Mar 26, 2014 | 2005 Ford F-150 SuperCab

1 Answer

1995 ford f150 truck 302motor what trannsmission did ford install


Hi There,

It should be either a 4R70w or E4OD, check the trans code on the drivers door decal and compare it to this list.

Transmission codes from 1995 Manual M = manual 5 speed overdrive (Mazda?) E = Automatic E40D G = C6 auto U = 4R70W (4spd auto with overdrive) C = manual 5 speed close ratio (Z-F) W = 5 speed H.D. Overdrive Transmission codes start with "TR" then are followed by one of the letters above.

Oct 08, 2013 | 1986 Buick Electra

1 Answer

Where would i find the reverse switch for my 1990 f 150 5.8l auto and how do i tell if its a c6, it is a 3 speed thanks


It is usually mounted somewhere under the vehicle either on the transmission or the frame beside the transmission. If you follow the shifting rod to the transmission you should find it mounted somewhere near where the rod connects to the transmission.

Oct 28, 2010 | 1990 Ford F150

1 Answer

Ok my 1986 Fiero 2m4 wont come out of reverse it was hard 2 shift gears all day yesterday until about 4 o clock now the transmission shifter just moves around freely but like i said its stuck in reverse...


Manual or auto?

It's gotta be the cable/linkage. You just have to inspect them and see if something is worn or snapped. They get old and crusty and need to be replaced eventually. I had to replace my shift cable on my 86 se with the 5-speed getrag.

Hopefully it's not the actual tranny....?

Apr 17, 2010 | 1986 Pontiac Fiero

1 Answer

Water in trans in a c6


Water in transmission is a bad radiator and it needs to be replaced or you can by pass the radiator and buy a transmission cooler instead of running the transmission fluid through the radiator. The transmission cooler is built in to the radiator on the passenger side, the high line is on the top and the return will be on the bottom. Good luck and hope this helps.

Oct 31, 2009 | 1986 Ford F 250

1 Answer

Ford c6 transmission not shifting???


you may have a block trans air vent which may explain the blown seal and may also fect shifting

Sep 09, 2009 | Ford Econoline Cars & Trucks

1 Answer

Have c6 trans locks good in 1st and 2nd wont shift into 3rd


Tighten the band adjustment to 18 inch pounds it is a stud with a locking nut on the side of the transmission it is the one located toward the rear of the transmission not the one towards the front that is the 1st/reverse band adjust replace the modulator if problem persists sometimes they stick

Sep 04, 2009 | Ford F-250 Cars & Trucks

1 Answer

In my 1986 Dodge Ramcharger the transmission No reverse


Pull the bottom pan and check the Rear (Reverse) Band.

May 11, 2009 | 1986 Dodge Ramcharger

1 Answer

C 6 transmission


Forward drive in the C6 requires both the forward clutch AND the low/reverse, one-way clutch, or intermedaite band to engage. Since you have reverse but no forward, the forward clutch is most likely the problem, since it is needed only for forward speeds and does not affect reverse. Sounds like a trans rebuild.

Jul 14, 2008 | 1988 Ford F 250

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...