Question about Cars & Trucks

Open Question

The 20 amp keeps blowing when i start my jeep

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

insanegtp
  • 112 Answers

SOURCE: 20 amp fuse in the box under hood that keeps blowing

Does it only do this when the heat or A/c is on full blast.. ( I had a few of my customers with this problem and they needed a new blower motor..)

Posted on Jan 26, 2009

raffaiel
  • 209 Answers

SOURCE: keeps blowing #11 fuse and car quits rumming

there's a grounded wiring on it that's why it keep on blowing your fuse check the wiring.

Posted on Apr 17, 2009

  • 43 Answers

SOURCE: blowing fuses jeep wont start

use a circuit breaker or paper clip with pliers so you do not burn yourself use paper clip as fuse unplug engine controll sensors 1 at a time and check if problem is gone after each one is unplugged an engine controll sensor is most likely shorting out if you have a map sensor try that first then move on to other components tps,fuel pump ect. till you find wich is fauly causeing short this should help you just be carefull with paperclip am saying to do this instead of blowing expensive fuses

Posted on Aug 26, 2009

csmock132
  • 4669 Answers

SOURCE: gages dont work, 20 amp fuse under hood keeps

Is it the ecm fuse. Check the o2 sensor wires. On this model sometimes they rub on the rear driveshaft and blow fuses.

Posted on Jul 25, 2010

  • 1 Answer

SOURCE: what could make my sebring keep blowing the 20 amp

The starter is drawing too much current. I had the same problem on my 2001 and it needed a new starter.

Posted on Nov 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 jeep grand Cherokee keeps blowing 20 amp fuse under the hood cranks but no start


A fuse that keeps blowing means you have a short. Inspect the wiring that goes to the fuel pump. It can also mean there that the pump is defective.

Jan 27, 2016 | Jeep Cars & Trucks

1 Answer

94 Jeep Grand Cherokee 4x4 with the 4.0 Keeps blowing the fuse that controls the fuse box inside the jeep, its blowing a 40 amp fuse. I believe there is a short. but i don't where to look.


Get yourself a set of factory wiring diagrams,
otherwise your wasting your time

You have no idea what you working on, without
reference material

Helm.Com

Jun 20, 2012 | 1994 Jeep Grand Cherokee

2 Answers

All turn signals on my jeep cheroke laredo are not working. Is the problem a bad fuse??


COULD BE BLOW FUSE.FAULTY TURN SIGNAL SWITCH OR FAULTY TURN SIGNAL FLASHERS WHICH IS LOCATED FUSE / RELAY BOX JUST LEFT OF THE STEERING COLUMN.

Dec 05, 2010 | 2003 Jeep Grand Cherokee

1 Answer

1997 GC Jeep, 4.0 L . Keeps blowing fuel pump fuses. Told that 20 amp was recommended.


You should always replace fuses with the same rated fuse as the one removed. Most likely if it keeps blowing the same fuse something in that circuit is directly shorted out.What fuse is it that keeps popping?

Oct 17, 2010 | 1997 Jeep Grand Cherokee

1 Answer

Gages dont work, 20 amp fuse under hood keeps blowing. turn key motor turns but dont start


Is it the ecm fuse. Check the o2 sensor wires. On this model sometimes they rub on the rear driveshaft and blow fuses.

Jul 25, 2010 | 1996 Jeep Grand Cherokee

2 Answers

I need a diagram for the under hood fuse box. More importantly the specific 20 amp fuse labeled F21. What is it for. I have a 1998 jeep wrangler 4.0 4wd.


Are you sure that this is for 20AMP, according with the repair manual, the position 20 in the Power Distribution Center if for Power Motor ABS Pump, and is 10AMP.

Verify it..

Mar 17, 2010 | 1998 Jeep Wrangler

1 Answer

1995 jeep grand cherokee wont start


IF THE FUSE BLOWS IMMEDIATELY, THE VEHICLE HAS A SHORT IN THAT CIRCUIT. CAR WON'T RUN WITH A SHORTED ECM. CHECK THE WIRING FIRST FOR A BARE OR PINCHED WIRE.

Aug 25, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Keeps blowing #11 fuse and car quits rumming


there's a grounded wiring on it that's why it keep on blowing your fuse check the wiring.

Apr 17, 2009 | 1998 Jeep Cherokee

1 Answer

96 jeep cherokee, replace cps and the engine control fuse


The guy at the garage today, said he went out and put a fuse in it and it started right up. Thats all he did for now. I going to have a closer look on the weekend. But, as before when I went 1/2 mile it would burn the fuse again. We will have to see if it does again, I espect it will. Any idea?

Mar 26, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...