Question about 2005 Hyundai Getz 1.3
Clutch fitted after previous one burnt out vibration started then, replaced new clutch with another new one and vibration still there. Good quality clutch. Tried new exhaust flexi pipe as old one was noisey when tapped. noise/vibration still there. May try new flywheel? Noise will not come on when stationary or if ease off acceleration when driving... only comes on on acceleration at those speeds... help please!!!!
Did you replace the clutch plate as well as the clutch ? as not doing so it can be warped from the heat of old one burning out. also did you check the flywheel as any imperfections in the plate can cause clutch wobble.
Posted on Jul 21, 2017
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
sounds like your CV joints are worn out. If the clicking noise gets worse when turning then its a definite possibility. Also check the CV joint boots for splits as this can quickly wear them out. The dust mixes with the grease to form a grinding paste.
Posted on Jun 10, 2009
That's a hub bearing. Replace the one that's doing it. I'm assuming this 'roar' is coming from the front, NOT the rear.
Posted on Jun 28, 2009
Since you did not say what type of transmission you have i will suspect the clutch is slipping if it's a manual.
If it's an automatic, it could be several things. Low fluid level...clogged filter, fluid needs to be changed..transmission serviced...weak pump, bands/clutch packs worn...etc
Good luck..i hope this helps, please rate me a fixya.
Posted on Jul 29, 2009
Hello mpolci...The 2003 Tiburon was sold to the public with a defective clutch, it failed due to warpage and bad pressure plate... among other things. There are MANY class action lawsuits. Did you resurface or replace the flywheel when the clutch was replaced? Did you go with an aftermarket clutch kit, or factory? Also the slave cylinder on the 03 was known to have a defective valve.
You can try checking the levels and bleeding the system and if you still have problems, then it could be a release bearing, a loose clutch pad, or a broken pressure plate spring....If the clutch is still under warranty, i would return it to the installer.
Good luck, i hope this helps...please rate me a fixya.
Posted on Aug 01, 2009
Tips for a great answer:
Mar 14, 2015 | 2006 Peugeot 207 1.4
Mar 14, 2015 | Cars & Trucks
Mar 24, 2014 | 2004 Mitsubishi Eclipse
Jun 04, 2017 | Cars & Trucks
May 03, 2011 | Toyota Corolla Cars & Trucks
Mar 21, 2010 | 2000 Lexus RX 300
Jan 04, 2010 | 1994 Honda Accord
Apr 07, 2009 | 2002 Dodge Neon
Feb 17, 2009 | 2000 Hyundai Elantra
Jun 15, 2008 | 2001 Ford Mustang
Feb 05, 2014 | 2005 Hyundai Getz 1.3
106 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: