Question about 1997 Ford F150 Regular Cab

Open Question

Is there a fuse for power steering pump on a 97f150 4.6l

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power steering keeps going out on my 2007 hhr. had the fuse replaced once already and its out again! i have been told there is no power steering pump, is that true?


yes it's true they do not have a power steering pump
they have electric power steering
i'm not sure about the HHR but the G5 and the COBALT have a MESSAGE come up on the RADIO or the DIC service power steering
my guess would be you have a short that's why the fuse blew
poss. POWER STEERING MOTOR shorted internal
you should have the vehicle scanned for a fault code in the steering system
hope this helps

Mar 08, 2010 | 2006 Chevrolet HHR

2 Answers

2007 S40 WONT START ''POWER STEERING FAILURE'' CAME ON


The power steering is actually ELECTRIC steering on this car Most common and basically only failure is 2 30 amp fuses in under hood fuse block Only other thing is mechanical and would set a trouble code and sat power steering on your dash. FYI. Jump Starting your car from the +- Terminals found near the FUSE box under the hood, will Blow the Fuses for the Power Steering. Always Jump start your car from the Battery Terminals in the Trunk

Locate the power steering pump and hoses on your vehicle. The power steering pump is located at the front of your engine, near the top of the motor. It will have a black fill cap on it that is labeled "power steering fluid."
1)Clean the outside of the pressurized power steering pump hoses and the power steering pump with clean shop rags to remove any oil deposits. Check the exterior of the lines to identify any signs of steering fluid leakage.
2)Start the motor and turn your steering wheel back and forth several times to cause the pressure in the steering pump to build up. Turn the engine off and recheck the hoses for fluid leaks. Examine the power steering pump for any signs of cracks or damage. If your power steering pump is damaged you need to replace it with a new pump by removing the bolts that hold the pump onto the bracket, taking the pump belt off the pulley and disconnecting the hoses. Replace the power steering pump by reattaching the hoses with a screw clamp and attaching the pump to the bracket. Place the belt around the pump pulley and apply pressure by pulling back on the pump and tightening the belt by using a socket wrench to tighten the bolt on the bracket. You can find a power steering pump for your vehicle at your local automotive.
3)Check the fittings and clamps for any signs of wear or leakage and tighten any loose clamps with a screwdriver. Inspect the hose leading from the power steering pump back into the firewall that leads to the steering wheel. If you find that a leak has developed in the power steering hose that leads to the steering column, consult a mechanic or take your vehicle to a local service center and have an inspection done.
4)Remove damaged power steering hoses by taking the cap off of the power steering pump and then unscrewing the clamp on the hose. Recover draining power steering fluid by placing a clean container below the hose or power steering pump when you loosen the hoses and allow the fluid to drain into the container.
5)Repair power steering hoses where the damaged area is close to the end of the hose by trimming off the affected area with a utility or sharp knife and reattaching the hose with a screw clamp by tightening the clamp with a screwdriver. For damage that is in the middle of the hose or near a section that can't be repaired, replace the hose with a power steering hose that can be purchased from any automotive supply store in your area or online at an automotive supply website, such as the ones listed below in the resources section, and connect the new hose to the power steering pump with a screw clamp.
6)Fill the power steering pump to the proper level with power steering fluid and replace the cap. Start the vehicle motor to test the system. Once you have verified that the power steering system is working properly, shut off the engine.
This will help. Thanks please keep updated.please do rate the solution positively .thank you for using fixya

Feb 26, 2010 | 2007 Volvo S40 2.4i Sedan

2 Answers

Lost power steering and brakes on 96 Astro


Hello altgraph1: My name is Roger and I can help. The power steering and the brakes are directly connected. If the power steering pump fails you will also loose the brake assist. This vehicle does not have a vacuum booster you have a hydro-boost brake system. This unit uses the power steering pressure to assist the stopping of the vehicle. You will need special tools to determine if the power steering pump failed or if the hydro-boost system failed. Most likely the power steering pump failed. How ever to be sure it should be tested first. Should you need further help please just ask. Please rate the answer you received. Thank You for using Fix Ya. Roger

Oct 28, 2009 | 1996 Chevrolet Astro

2 Answers

Electric power steering quit is there a fuse on 2007 chevy equinox


The Chevy Equinox has an 80 Amp mega fuse that tends to fail and cause all sort of power steering and Stabilitrak issues. Before I messed with the belts or power steering pumps, I would check the fuse first.

Jun 25, 2009 | 2007 Chevrolet Equinox LS New Cars

2 Answers

No power at fuel pump chev.S-10 looking for fuel pump relay and fuse


The fuel pump relay is located Under hood, driver side, upper firewall, mounted in relay block.

The fuse is located under the instrument panel to the left of the steering column. The fuse block should be visible from underneath the steering column, near the pedal bracket. If the panel is not visible, check for a removable compartment door or trim panel which may be used on later models to hide the block.



Jun 03, 2009 | 1992 Chevrolet S-10

1 Answer

Power steering comes and goes


Check the big EPS Fuse under the hood,power supplied from underhood fuse panel.

May 31, 2009 | 2002 Saturn VUE

1 Answer

No power to power steering


Power steering is powered by a pump run off the fan belt. If you have no power steering then your low or out of power steering fluid or the pump needs to be replaced.

Oct 06, 2008 | 2002 Ford ZX2

Not finding what you are looking for?
1997 Ford F150 Regular Cab Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...