Question about Mazda 323

1 Answer

1989 mazda 323

I have no power to the coil

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Find a replacment the car,it is old but parts are still kept in stock or can be ordered

Posted on Jan 10, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 726 Answers

SOURCE: Mazda 323 station wagon

hi i dont no what area your in or were abouts but u should check all your local wreckers if no luck you can also try the trading post or even ebay hope this helps at all

Posted on Jul 01, 2008

  • 1 Answer

SOURCE: Where do i add transmission fluid?

through the speedometer gear behind the motor on top of the tranny there's a 10mm bolt holding it in the just pull straight up at the base and then ad fluid there.

Posted on Jan 30, 2009

SOURCE: on a 1989 mazda 323 how do I get the timing belt

Correct - please refer to the thread " how to change cam belt" posted on "fiat 124".....

Posted on Jul 17, 2009

sawdust46694
  • 398 Answers

SOURCE: i replaced the ignition coil of my mazda 323 sedan

timming check pull # 1 plug hold your thumb or better yet a compression tester in the # 1 plug hole . and watch the rotor go around. look at the cap and wire to see where # 1 is.
I locate #1 plug and wire before I pull the dist cap. When it pushes out air it must be pointing to # 1.... hope this helps you

Posted on Aug 10, 2009

  • 100 Answers

SOURCE: 1989 mazda astina 323 5 spd manual clutch fluid??

Check the brake fluid resovoir, on the side there could be a hose coming off it part way down the side sharing the brake fluid to the clutch master cylinder

Posted on Sep 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Mazda Claire 1989. It is gutless uphill. I would like to improve the performance and power. What would you suggest i datrt doing?


If you're looking for more than a good tune-up will provide, google Mazda and find an enthusiasts forum for your 323. Guys do mods to everything now. They should help steer you in the right direction.

Oct 30, 2011 | 1989 Mazda 323

1 Answer

Is there a supercharge for 1989 mazda 323 & how do i fit it


I've never seen a supercharger add-on for the 323. There was a 323GTX model for that year that came stock with a turbo and intercooler. If anyone would know about spuerchargers for that year it would be HKS.

Aug 26, 2011 | 1989 Mazda 323

1 Answer

Turned off then wouldnt start ,took ignition apart cleaned up ,no spark to plugs cap,rotor ,wires good power to coil and module


If there is no spark to the plugs, but good cap, rotor and wires; then if the there is good power to coil and module, then the module or coil must be bad.

Aug 01, 2010 | 1989 Mazda 323

1 Answer

1989 323 engine turns over but no spark


Theres more than one reason. The timing belt could have stripped and the dist. and the cam arent turning. Power to the coil could have failed ingtion fuse blown. Power to the engine control computer could have failed and the check engine light is'nt on with the key on but not running. Pulling codes with a scanner may find other problems like no crank sense or no ingtion power while cranking. Did the car stop running while driving or did'nt it just not start? The engine was cold when you last checked for spark?

Sep 04, 2009 | 1987 Mazda 323 4-Door

1 Answer

On a 1989 mazda 323 how do I get the timing belt off the bottom pulley? DO I HAVE TO REMOVE THE PULLLEY?


Correct - please refer to the thread " how to change cam belt" posted on "fiat 124".....

Jul 17, 2009 | 1989 Mazda 323

1 Answer

My 1989 mazda 323 wont start


Hi there
You may need to do a few more things: * Change Spark Plugs * Check HT Leads * Check Battery Voltage * Fuel Filter * Get a mechanic to check your Carb settings.
As i say this could be either one thing or the other but could be a combo of these.

I have the same car and i've worked on it alot so theres a few things you need to check out.
But if you repost on here please give me more details: ie, ill the starter crank,

May 17, 2009 | 1989 Mazda 323

2 Answers

1989 mazda astina 323 5 spd manual clutch fluid??


open your bonnet check to see @ gearbox if the-res is cable, or a cylinder, the cable is Usualy visible on the top of the gearbox if theres a cable theres no clutch flu-ed needed. Note that your gearbox uses oil. Usualy on older models like 1989 the use a clutch cable no flu-ed needed

Jan 03, 2009 | 1989 Mazda 323

3 Answers

My 89 mazda 323 turns over but wont start


Last week my 323 89' Mazda stop working as I was driving it in middle of the street, I pushed to the side. it would not start, the starter sounded ok, but the car just didnt start, I checked the fuses, gas pump, and all seemed to be ok, finally with the help of a friend we found out that the ignition rotor at the distributor wasnt working we then replace it with a new one from autozone , is about 5 dollars, now it works just fine, big problem easy solution.

Victor

Dec 01, 2008 | 1989 Mazda 323

1 Answer

Alternator for a 1989 masda 323 or ford laser ke


deseo saber las especificaciones tecnicas de la bateria a utilizar en el automovil mzada 323 lx 1.3 , station, año 1989.

Jul 15, 2008 | 1989 Mazda 323

1 Answer

Mazda 323 station wagon


hi i dont no what area your in or were abouts but u should check all your local wreckers if no luck you can also try the trading post or even ebay hope this helps at all

Jul 01, 2008 | 1989 Mazda 323

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...