Question about 2008 Mitsubishi Lancer GTS CVT Sedan

Open Question

I Have A 2008 Mitsubishi Lancer GTS with this codes on. B210D & B223D & B1206. what are this codes? I replaced pasinger sit and the computer and the above drivers side head the air bag and we tryed to turn it of and it comes right back on HELP please????

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 6 Answers

SOURCE: Lancer IPod connect cord

I own a 2007 Eclipse.
You can purchase the cord from the dealership, with the instructions for the I-Pod cord. Not hard to install on the Eclipse, takes about 30 minutes to install. This is the only known place to get this I-Pod connector.

Posted on Feb 18, 2009

Ad
  • 333 Answers

SOURCE: I have problem on airbag codes in mitsubishi lancer

Your first code is for low system voltage. If your battery has needed a jumpstart lately or replacement, this code will be set.

The second two codes are in relation to your rh side airbag (B1C2D) and curtain bag (B1B22) not being visible to the srs ecu. Has the car been apart for any reason, possible leaving harnesses unplugged? Was it in an accident recently and maybe the bags are missing? Were components removed for accessory installations (stereo, subwoofers, etc)?
The connector for the curtain bag is in the passenger side rear most pillar. The connector for the side airbag is under the passenger seat.

A weak battery can sometimes throw other miscellaneous codes like these, but it is not likely. If you clear the codes, the B1C2D and B1B22 should come right back.
If they do, and both bags are installed correctly, You can bypass them with a 3 ohm (three ohm) resistor and clear the code again. If the codes set again, there is a problem with the wiring leading up to the squib units. If the codes do not set again, there is a problem with the squib units.

Posted on Sep 10, 2009

  • 9 Answers

SOURCE: Which is the tensioner pulley on the 2008

Its usually the one with the 3/8" square hole in it.

Posted on Feb 20, 2010

Testimonial: "Perfect. Thank you!"

  • 8 Answers

SOURCE: I have a 2008 Mitsubishi Lancer GTS. (Not an EVO)

Check your owners manual or if premium fuel is required, it is usually posted near the gas gauge " use premium fuel only ".

Posted on Aug 21, 2010

  • 2 Answers

SOURCE: 2008 lancer evo codes c121a,c1219,c1290,u0428,b210d

hello i have a 2010 lancer a code c121a keeps coming up ive changed the angle senor but no luck

Posted on Mar 29, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Mitsubishi lancer radio from loud squealing noise


What is causing that irritating noise? ' DSMtuners

www.dsmtuners.com > ... > Articles: Miscellaneous
Jun 1, 2009 - 2 posts - ‎1 author Check the ECU power relay in the console, under the radio. ... You hear a loud clicking type noise from under the hood when you try to start the car. .... You hear a squealing, grinding, or rubbing noise in the lower timing belt .... The Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, Mitsubishi Galant VR-4, ... LOUD squeak when turning steering wheel (Video Inside)
22 posts
Mar 5, 2011
Why does my alternator belt squeal so much on initial ...
25 posts
May 14, 2010
More results from www.dsmtuners.com

Lancer Troubleshooting [Archive] - evolutionm.net

www.evolutionm.net/forums/mitsubishi-evolution-forums/f-203.html
NEED RADIO HELP! ... Help not start Lancer GT 2012 EngineOverheating STOP SAFELY warning on ... AC ISSUES 2011 Mitsubishi Lancer ES · 2008 Lancer GTS no start please ... 2011 lancer no sound · Driver/Passenger side floor squeaky? ... plastic piece of rear shelf rattles a lot · Very loud noise on Lancer ES 2008 ...

Dec 03, 2015 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

Airbag codes B1206 B1204 B223D are on 2006 dodge magnum srt8


B1204 communication w/occupant classification module passenger airbag indicator circuit low

B1206 passenger airbag indicator circuit open

B223D occupant classification module DTC present

You either have a bad passenger airbag or the sensor that tells computer it is present

Sep 17, 2015 | Dodge Cars & Trucks

1 Answer

Could it be the booster


check your push rod going from the pedal to the booster a quick way is to pull the vaccum hose and see if they release the vaccum not being released can cause sticky problems also check your vaccum hose also

May 26, 2014 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

How do I replace a tension pulley on a 2008 Mitsubishi lancer GTS


Remove drive belt. Remove bolt and belt tensioner assembly. Reverse procedure to install

Mar 23, 2012 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

2008 lancer evo codes c121a,c1219,c1290,u0428,b210d


hello i have a 2010 lancer a code c121a keeps coming up ive changed the angle senor but no luck

Mar 25, 2011 | Mitsubishi Lancer Evolution Cars & Trucks

1 Answer

I am trying to change the serpentine belt on my 2008 lancer gts. Thank you so Much!! Hollie


First, you need to have the diagram for how the belt is routed when you replace it.

Serpentine routing diagram...

9c37528.jpg
Here is a link to a video on how to replace the serpentine belt. I hope it helps!

http://www.wonderhowto.com/how-to-inspect-replace-cars-serpentine-belt-267229/

Feb 20, 2010 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

Service the brakes


yes and you can go to autozone to get the parts and a step by step brake service manual with illustrations

Jun 09, 2009 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

Lancer IPod connect cord


I own a 2007 Eclipse.
You can purchase the cord from the dealership, with the instructions for the I-Pod cord. Not hard to install on the Eclipse, takes about 30 minutes to install. This is the only known place to get this I-Pod connector.

Jan 21, 2009 | 2008 Mitsubishi Lancer GTS CVT Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...