Question about Cars & Trucks

Open Question

Wiring diagram for omcan sp200a

Start stop switch

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 chef Equinox brake light wiring diagram


http://bbbind.com/free_tsb.html free wiring diagrams !
Stop Lamps
The 15A BRAKE fuse located in the fuse block - underhood, supplies battery positive voltage to the normally open stop lamp switch. When the driver presses the brake pedal, the switch contacts close and battery positive voltage is supplied to both left and right stop lamp assemblies, the center high mounted stop lamp (CHMSL), the powertrain control module (PCM), and the throttle actuator control (TAC) module. The stop lamps are grounded at G401 and G403. The CHMSL is grounded at G301.

Jul 23, 2016 | 2005 Chevrolet Equinox LT

1 Answer

I need to wire stop and turn to the same light using a two elamut bulb


Most ambitious, but can't imagine why you would do this. However, none of my business I suppose. You could use wiring diagram from any earlier vehicle which used combination bulbs, but basically the trick is that you now have to have brake light circuit run through the turn signal switch, such that when the brake lights are on, the turn switch interrupts the circuit and flashes the correct turn lamps. Doing this may require modifying you turn signal switch, or replacing it with an earlier type. This may not be easy, unless you by a aftermarket turn switch intended for trucks or cars which either never had turn signals, or had a switch fail which is no longer available (think hot rod). Check out the wiring for say a 1964 chevy to get the idea. These wiring diagrams should be in the shop manual for any older cars, but you can also join a ho rod forum and ask there.

Dec 19, 2014 | Cars & Trucks

3 Answers

2002 Jeep Liberty starter "clacks" about every 2-3 minutes even when the motor is shut off and key is out of the ignition.


Does your vehicle have a remote start? Its possible that the remote start is malfunctioning. I had a vehicle with similar issues, and I didn't even know it had a remote start. (The previous owner had one, but had never told me about it, or given me the remote for it.) If you have a remote start, it should be located under the dash, next to the steering column, or firewall, or under the drivers seat. Disconnect the wiring harness from the remote start if you have one.
If you are sure you have no remote start, or if the problem continues after disconnecting it, then follow these steps.
1. Locate the small diameter wire going to the starter solenoid. The starter solenoid will be on the starter itself. This wire will be much smaller than the large wire that comes directly from the battery. This wire is is likely fastened with a round crimp connector and a philips head screw. Or it may be a clip on plug.DISCONNECT THIS WIRE. If the "clacking problem" continues with the key off, when the wire is disconnected, then you can be sure that the starter has a problem. If the problem stops (Of course it won't start either) Then proceed to step 2.
2. At this point you may want to take it to a professional who has the wiring diagrams to properly troubleshoot. But if you are up to it, Hook the disconnected wire back up to the starter, and locate the wiring harness coming from the key switch and disconnect it. If the "clacking" stops, replace the key switch. If it doesn't, then you have a short, or wire harness problem. At this point you probably need a wiring diagram and professional troubleshooting experience to proceed further.

Dec 09, 2014 | 2002 Jeep Liberty

1 Answer

Do you have a starting wiring diagram for a 1999 600 yamaha grizzly?


I hope that you have checked the dead mans switch (emergency stop) is switched on and is working. This is the switch that you can switch off the engine as you roll over or need to shut off the engine quick

Dec 06, 2013 | Cars & Trucks

1 Answer

Starter Motor Runs before crank position.


It is very likely either your ignition cylinder is not aligned or that your ignition switch is bad.

Nov 30, 2013 | Cars & Trucks

1 Answer

Wire diagram for chevy 3500 van


When you say charging,do you mean amp reading or volt reading?Amps should rise when first started then drop.Volts should stay close to constant.The small wire going to the alternator to power the regulator in the alternator is just switched power.If the volts fall under 14 after ten minutes you may need to try a replacement alternator.

Apr 28, 2017 | Chevrolet Express Cars & Trucks

2 Answers

Need a wiring diagram for a chevy s10. brake


your power starts at the brake light fuse,check with a test light,then proceed to stop light switch on brake pedal under dash,one wire will be hot when when you check it with your test light, the other won't be until you press down the brake pedal then the power flows through to the second wire,if no power to second wire replace switch,if you have power remove tail light bulbs and check for power in side socket.

Nov 24, 2009 | 1997 Chevrolet S-10 Pickup

2 Answers

What colour wire is the stoplight feed that feeds the stop lights


I'm assuming you have a trailer towing package.
Below is the wiring diagram. It appears the dark blue is your stop lamp wire you may be looking for.
Let me know if anything is different.
Regards,
moz-screenshot-6.jpg

0900c1528024882e.gif

Apr 06, 2009 | 2007 Chevrolet Uplander LS Minivan

1 Answer

Left rear blinker and break light stopped working 84 eldorado


See if you can locate a wiring diagram for your vehicle. I have a 92 Seville and the wiring for the brakes and blinkers runs through the turn signal switch. The switch generally goes bad just from everyday use. They lose connection and you get intermittent problems (much like yours). Consult a wiring diagram, if they do run through the switch then I would recommend replacing that. Start there. Cheers.

Mar 12, 2009 | 1984 Cadillac Eldorado

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...