Question about 2004 Chevrolet Suburban

Open Question

WHERE IS THE FUSE LOCATED FOR THE LIFTGATE ON MY SUBURBAN?

THE LIFTGATE FUSE IS NOT LABELED ON THE FUSE PANEL.

Posted by on

  • yadayada
    yadayada May 11, 2010

    what part of the liftgate, motor?

×

6 Suggested Answers

5LTRBTR
  • 165 Answers

SOURCE: Cannot locate heated seat fuse on fuse panel

http://www.diblasifamily.org/jetta/fusecard.jpg 99-05 mk4/a4 body style just click the link

Posted on Jan 13, 2009

  • 145 Answers

SOURCE: 97 Suburban dome lights

It is not going to be a fuse, It is going to be your dome light switch on the dash or one of your door switchs is bad. I would start with drivers door, (make sure the other doors are closed) you can open the door and flick the switch in and out a few time. Push it in and let it snap out. (keeping a eye on the lights) If that doesnt work disconnect the door switchs one at a time. Dont let the wire touch a ground because that is what turns the light on. Make sure the dome switch on the light itself is not turned on. It is possible but not likely that a wire has come off of one of the door switches and grounded itself.

Posted on Nov 03, 2008

MrScary66613
  • 1990 Answers

SOURCE: fuse panel

The easiest Way to find this Fuse is to Get a Flashlight and Hold it Behind or Under the Fuses in the Panel to see if they are Blown. It is there.

Posted on Jan 22, 2009

motor1258
  • 6674 Answers

SOURCE: 1998 plymouth grand voyager cruise control relay/fuse location?

Check under hood in box marked fuses & relay, on drivers side and look under cover of it for I.D.

Posted on Apr 11, 2009

  • 1 Answer

SOURCE: Fuse labeled ACR & Power assist trunk '90 Firebird

I had the same thing happen...the clamp bearings were shattered in the bottom receiver.

Posted on Dec 27, 2009

Consistant
  • 61 Answers

SOURCE: 2006 suburban - liftgate and

The lights and the electronic tail-gate lock cylinder are on differient electrical circuits, most likely, your problem is in the rear hatch wiring harness. See attached description: C406 - C901120487861You will find the connector just inside the rear liftgate, in the headliner. This will be the connector that handles these items. It is common for them to become abraided and wear the wires through.

Posted on Mar 29, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the manual liftgate sensor located 2009 Equinox


The liftgate can be opened by operating the switch on the instrument panel. Battery voltage is supplied to the liftgate actuator through the body control module (BCM). The BCM will pulse the liftgate actuator when a release input is received through the key fob, or the instrument panel switch.
Not sure what your talking about . There is no sensor. there is a relay in the I/P fuse box LIFTGATE PCB relay . an a lift gate actuator motor inside the door . An there is a door ajar switch ,which is part of the latch mechanism. Do you have light lit on the instrument cluster - a picture of a little car with a door open , an maybe a chime sounding ?

Not

Aug 01, 2015 | 2009 Chevrolet Equinox

1 Answer

How do i replace the park assist module in a 2011 chevy traverse???/


Have you checked the fuse? If so, the module is located behind the left rear trim panel. Remove the panel to access. Below is a diagram of the trim panel and location of the module in BLUE>
Preliminary Procedures
  1. Move the rear seat to the full forward position.
  2. Remove the rear number?2 seat . Refer to 3rd Row Seat Removal and Installation.
  3. Remove the rear quarter upper trim panel. Refer to Quarter Upper Trim Panel Replacement.
  4. Disconnect the liftgate actuator rod from the liftgate. Refer to Liftgate Actuator Rod Replacement.
  5. Disconnect the rear seat number 2 shoulder belt anchor bolt. Refer to Rear Seat Number 2 Retractor Side Belt Replacement.
  6. Remove the liftgate door sill plate. Refer to Liftgate Door Sill Plate Replacement.



woauitf41mzpgaaaabjru5erkjggg==

Nov 16, 2014 | 2011 Chevrolet Traverse

2 Answers

WHERE IS THE FUSE FOR REAR WINDOW DEFROSTER WHAT NUMBER FUSE IS IT IN THE 2007 ENVOY


Does the indicator light come on when you turn the defroster on? Have you checked to see where the wires come in on the rear window to see if they might have gotten disconnected. It usually happens right at the point where the wire connects to the grid.

Oct 16, 2013 | GMC Envoy Cars & Trucks

1 Answer

2008 suburban Stuck Lift Gate Lock


I have a 2008 Suburban with the power liftgate disabled. I have had the power latch stop working, and the BCM report that the rear access open when it is closed (both gate and glass). Somehow the liftgate module thinks the gate is open, so I cannot open the gate at all, and the latch and rear wiper will not work. To reset the control module I pulled the liftgate fuse (#20) in the instrument panel fuse box, turned the car on, off, reinstalled fuse, turned car on, unlocked doors using drivers side switch, and the power latch will function again - at least for a while.

Jun 05, 2013 | 2008 Chevrolet Suburban

1 Answer

2006 suburban - liftgate and high tail light quit working and I can't find out which fuse could be bad. All other locks work.


The lights and the electronic tail-gate lock cylinder are on differient electrical circuits, most likely, your problem is in the rear hatch wiring harness. See attached description: C406 - C901120487861You will find the connector just inside the rear liftgate, in the headliner. This will be the connector that handles these items. It is common for them to become abraided and wear the wires through.

Mar 29, 2011 | 2006 Chevrolet Suburban

2 Answers

Where is fuse for cigarette lighter in my 94 suburban


Woohoo Just Found The Answer. Its in the fuse box located under the headlamp switch labeled "T/G REL" and it's a 25 amp fuse!

Nov 27, 2010 | 1990 Chevrolet Suburban

1 Answer

What fuse runs the rar window defogger? I cant find one labeled for that in either fuse box


The rear defogger is controlled by the Liftgate Module and the fuse for that is located in the fuse panel under the rear seat at location #3 (LGM# 2)

Nov 11, 2010 | 2003 Chevrolet TrailBlazer

1 Answer

Fuse labeled ACR & Power assist trunk '90 Firebird


I had the same thing happen...the clamp bearings were shattered in the bottom receiver.

Nov 06, 2009 | 1990 Pontiac Firebird

1 Answer

2007 CHEVY SUBURBAN- TAIL GATE WILL NOT LATCH


Try changing the liftgate latch. If you have power liftgate, that is the usual fault by experience. There is also possibility for the other associated components to fail, but they are more costly. You can go for these repair while the gate is not yet stuck closed, so you can easily remove the trim panel. However, I still suggest a preliminary check up on the circuits. The fuses, switches, modules, codes, etc. If the liftgate seems to be operational, except for the proper closing and initial opening, its most likely the latch. I just hope we get lucky on that. Okay, there? goodluck. : )

Oct 18, 2009 | 2007 Chevrolet Suburban Three-Quarter-Ton...

1 Answer

Have a 2002 chevy suburban, liftgate window will not open


Sounds like you have a wiring problem to your liftgate. Check the wires where they come out of the body, and go into the liftgate. If they are good, check fuses, or possibly a module.

May 25, 2009 | 2003 Chevrolet Suburban 1500

Not finding what you are looking for?
2004 Chevrolet Suburban Logo

Related Topics:

300 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...