Question about 2007 Mercury Mountaineer

Open Question

I have 2007 Mercury Mountaineer and the tire sensor fault light just came on? What do I do? How do I preform the tire sensor test?

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 202 Answers

SOURCE: In 97 mercury mountaineer, how to turn off "check engine" light

Go to the local parts store, have them check the codes (they will do this for free usually). It will tell you what sensor needs to be checked/replaced. Once the part is replaced, it will clear on its own. They can also reset the code, but it will come back if the trouble persists.

Posted on May 27, 2009

  • 659 Answers

SOURCE: lowering/raising the spare tire

there should be a crank handle under the hood and an access hole just above rear bumper

Posted on Nov 24, 2008

  • 783 Answers

SOURCE: cant get spare tire off

The metal sleeve on the end of the cable,you turn it sideways and push it thru the hole in the wheel. If it is stuck to the wheel just pick up on the wheel then tap the sleeve with a hammer.

Posted on Feb 07, 2009

  • 67 Answers

SOURCE: need to replace my dpfe sensor on my 1999 mercury mountaineer. Where is it, i would like to change it myself

the sensor is on the rear of your engine next to the firewall on the 5.0 looking at the egr valve just to the right of it, has two small bolts holding it on and holding the stamped steel bracket for its up against

Posted on Jun 04, 2009

  • 2049 Answers

SOURCE: how do I go about getting an update to my GPS maps

You can buy it directly from Navteq by following this link to your gps unit...

Posted on Oct 12, 2009

Testimonial: "Exactly what I needed and got a response quickly. Thank you so much! I spent hours searching Ford's web site - got an answer from you in minutes!"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2008 Mountaineer, Tire Monitor Fault light is on. How can I fix it and the Tire Sensor Fault light is on. These lights are driving me crazy.

check the air pressure in tires if good need to check as to which tps sensor has failed order a new one and replaced usually a tire shop will charge a frw bucks to replace

Jun 18, 2017 | Cars & Trucks

1 Answer

2002 mercury mountaineer

one simple thing it could be is that with all wheel drive's it's critical that the owner keep all the same model and size tire on all four corner's and this is the tough one they gotta have the same (and correct) air pressure in them, the sensors for the power split for AWD does not cope well with these simple things not all the same and will cause what i have Knick named " Chuckwaggoning" as it feels as your car is now a wooden wagon on the oregon trail if you have it . other than that ck for fault codes in ecm with code checker it might tell you a wheel sensor is faulted .

Jul 06, 2014 | 2002 Mercury Mountaineer

1 Answer

Engine code p191 2003 mercury sable 3.0

P0191 is fuel rail pressure sensor or circuit low input. This indicates that fuel pressure is too low or the sensor is faulty or the circuit is at fault The fuel pressure should be tested to see if it is spec.and circuit test preformed the location of this sensor and testing needed to make an accurate repair requires some degree of skill and someone that is comfortable doing this type of diagnostic repair


Jan 04, 2013 | Mercury Sable Cars & Trucks

1 Answer

2006 Murcery Mountaineer tire senor fault light

I have a 2006 mercury mountaineer and I bought tires for my car and the tire pressure sensor light is still on when I start my truck,what should I do next.

Feb 07, 2012 | 2006 Mercury Mountaineer

1 Answer

The exclaimation mark is coming on and says the tire pressure sensor fault.

if you have hit a curb or rock in the roadway this can damage the pressure sensor. you will have to take the vehilce to the dealership for this problem

Jul 26, 2011 | 2004 Mercury Mountaineer

3 Answers

Hi i have a 04 mountaineer just got it i turned the ignion on and a low tire presure pop up what should i do

have the tires checked out. or have the computerized valve stems checked out. aluminum rims are known to leak.

Feb 13, 2010 | 2004 Mercury Mountaineer

1 Answer

Can we use snow tires on it and if so what kind and size. for a 2007 mercury mountineer

Hello. Yes, snow tires will give you the best possible traction in winter driving conditions, better that all season. The size tire depends upon the size of your rim so go to a tire store and shop around. They will tell you what size your vehicle requires. As far as kind goes, I prefer Michelin but any brand name snow tire will work fine.
Kindly rate my answer as useful. Thank you.

Feb 09, 2010 | 2007 Mercury Mountaineer

1 Answer

Abs light comes on


Feb 11, 2009 | 2003 Mercury Mountaineer

Not finding what you are looking for?
2007 Mercury Mountaineer Logo

Related Topics:

644 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

78267 Answers


Level 3 Expert

5655 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides