- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
turn on your 4way flashers ,and go under dash and feel fore the clicking next to the fuse box they are on a separate system but the flashers are all located in the same place also look in the owners manual
Check turn signal fuse, if fuse is good, check turn signal flasher, this is identical to hazard flasher, I believe on the 1997 it is located under the dash near the center console. The turn signal and hazard flashers are the same part number so try switching places with them and see if the turn signals work. If turn signals work after switching them you need a flasher.
your turn signal flasher has gone bad look in your owner`s manuel to locate where it`s @ if no owner`s man. your local part`s store should be able to help find it`s location and the correct style you need
The way the system works is:
The fuse supplies 12 volts to the flasher unit then leaves the flasher and goes to the turn-signal switch in the steering column.
When you set the turn-signal switch to turn right or left, the switch sends that 12 volts to the front and rear bulbs. The voltage goes through the bulb, lighting the bulb and goes to ground.
If any of these components are not good than the lights will not work.
Check the fuse and make sure it is good, the fuse will be located under the hood at the fuse center.
Let me know if you have a test light and we can proceed from there.
If you mean the flasher, which makes the turn signals and hazards to blink, then...
It's a combo flasher which operates both the turn signals and the hazard lights. To access the combo flasher with ease remove the drivers knee bolster and then remove the brake release cable end from the handles notch, then disconnect the harness from the trunk release switch. Next there will be a reinforcement panel, remove that as well. Finally locate and replace the combo flasher from behind this panel. It is a black box that has a harness connected to it with a pink wire, a black and yellow wire, a red wire, a dark blue and pink wire, and finally a black wire. To help locate the flasher either turn the turn signal on or apply the hazards and listen for its location.
Turn signal flasher module is behind dash left of steering column near chime module. I have a 94 Seville and I had that same problem you need a Turn Signal Flasher Moduel, I forgot the proper term for it but I had to get mine replaced too. When I hit the signals to turn the side light would come on but the signal light wouldn't. Its a little box you get from Cadillac it only cost like $20 - $25 and you get it installed and trust. It'll work again. I just got mine done this week and my car now has turn signals again.