Question about 2005 Ford Crown Victoria

1 Answer

2005 Crown Vic (non Police Interceptor) will not start in temps less than 50 degrees. Engine will turn over but will not fire. Mechanic can't determine the problem, but said fuel pressure is good, new fuel filter, etc. 2005's were C/V's have drive by wire (no accelerator cable).

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Ford Master
  • 783 Answers

There is a TSB 08-18-02 that may correct this concern. It has a new calibration for PCM and may require the throttle body to be replaced.

Posted on Jan 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my 2007 Crown Victoria Police Interceptor vibrate when I get to 40 miles an hour and then die off back to normal by the time it reaches 50


Ford Crown Victoria Questions - what would cause a whole ...

www.cargurus.com > Questions > Ford > Crown Victoria
CarGuruswhat would cause a whole car vibration when going between 48 and 65 mph, even ... Asked by Dfranz Aug 29, 2013 at 11:53 AM about the 2001 Ford Crown Victoria Police Interceptor ... You have an open diff by turning one wheel the driveshaft should turn before the .... 2007 Ford Crown Victoria Police Interceptor For Sale.

Nov 03, 2015 | Cars & Trucks

1 Answer

How do I get the instrument panel out of a 2008 crown Vic police interceptor


If you bought a former police car, take it to a Ford dealer or reputable mechanic, because there are things under the dash you don't want to mess around with and short something out.

Jun 02, 2014 | Cars & Trucks

1 Answer

I have two questions 2001 ford Crown Vic LS, Codes read: (p0720 output speed sensor circuit), & (p1131 lack of heated oxygen sensor bank 1 sensor 1 switch indicates lean)........Keep in mined that I...


The PCM is programed for the LS engine parameters and now that you have changed engines the signal from the new engine are out of parameters> Either see if you can get the PCM reprogrammed at a dealership or purchase a new PCM and program the chip with the police engine interceptor to the vehicle> you may also return to the place where you got the engine and purchase the PCM for the police vehicle.

Mar 22, 2012 | 2001 Ford Crown Victoria

1 Answer

2000 crown vic police interceptor bypass a/c clutch pulley


you can get a A/C Delete kit for a Ford 4.6 liter. the 4.6 v-8 accessory drive system is all the same. You may also be able to run a line of string around the pullys, take it to your local auto parts store and they can match it up. I recomend the kit,

Oct 05, 2009 | 2000 Ford Crown Victoria

1 Answer

99 crown vic police interceptor steering wheel??


i have ran into 2 issues in these vehicles---if it binds while sitting still also, check the steering shaft, i have found the u-joints in the shaft tighten up and binds dangerously tight---if they are free, sounds like you may have a steering box issue or restriction in a line---hope this was helpful!!

Jul 07, 2009 | 1999 Ford Crown Victoria

1 Answer

2005 Crown Vic will not start in cold weather


Perhaps it's a electronic sensor on the transmission not sensing the car is in park, or the linkage from the tree to the trans needs adjustment to the correct position so the sensor reads correctly.

Jan 21, 2009 | 2005 Ford Crown Victoria

1 Answer

2005 Crown Vic Police Interceptor: Starts then stalls


Have you checked the fuel filter. Fuel pump will pressure up, but fuel filter could be clogged and not work without the pressure of the fuel pump.

Nov 27, 2008 | 2005 Ford Crown Victoria

2 Answers

Ford Crown Vic p0300 random cylinder misfire


take a look at the EGR valve it could be either vacum controlled or electronic either way what seems to be the problem is that the valve is stuck in the open position until the engine warms up you can gently tap the egr valve with a small hammer or a screw driver and you can see that it runs smooth, now if the egr valve is vacum controlled replace the valve. if it is electronoc controlled replace the valve and the module for the egr valve.

Nov 02, 2008 | 2000 Ford Crown Victoria

Not finding what you are looking for?
2005 Ford Crown Victoria Logo

246 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

63574 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...