Question about 1999 Dodge Ram 2500 4WD

1 Answer

1997 doge ram 2500 cranks but no spark

I replaced the crank sensor and still have no spark when the key iis on for bulb check there is no check engine light

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,118 Answers

Did you chk. ignition madual?

Posted on Jan 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 dodge ram 1500 4x4 360 engine starts when cold turn it off after it reaches operating temp will crank wont start no voltage to coil inlet and outlet


run fault codes and check for ambient air temp/water temp/cam/crank position servos/sensors faults. Something that is controlled by temperature that is connected to the cpu is telling it not to start as it is out of parameters.

Sep 21, 2013 | 2004 Dodge Ram 2500

1 Answer

1996 dodge 2500 v10 8.0 no spark and no fuel pump. Ran fine 3 days ago


Check the fuel pump fuse and relay, if it's OK, you have a bad fuel pump. About the no spark, could be many things
Ignition coil, distributor (if so equipment) , main shaft position sensor, computer problem
Good Luck

Mar 24, 2013 | 1997 Dodge Ram 2500 Club Cab

1 Answer

97 dodge ram van 5.9 litter cranks over and over but no start no spark


First thing to check is the ASD relay and voltage at the coil.

Aug 25, 2012 | 1997 Dodge Ram 2500 Club Cab

1 Answer

Truck quit running, is getting fuel, spark, timing is dead on, local shop said it may be crank pos sensor or cam pos sensor,where are they located/


Very possible. I would check the sensor with a meter. I would say it most likely the crank shaft sensor. Some are located behind the pulley area and some are located at the back of the engine where the transmission meets the engine. Good Luck

Mar 04, 2011 | 1994 Dodge Ram 2500

1 Answer

1999 Dodge Ram 2500 P/U 5.9L Gas V8 Standard cab Auto transmission 4x4 @ 38K miles. Started and ran January 10,2010 but will not start anymore. Tried Starting fluid down the throat of the carb - nothing....


This could be a number of things...
Crank sensor, cam sensor, coil, PCM, spark control module, ect.
Start with the sparkplugs, make sure they are firing if not work your way back from there spark pligs, wires, coil, control module, cank and cam sensors, PCM this is what i would do if this rolled into my shop.

Jul 18, 2010 | 1999 Dodge Ram 2500 4WD

1 Answer

1997 Dodge Ram 1500 5.2 liter won't start


I WOULD SAY IT IS THE COMPUTER {BRAIN} THAT IS WHAT SENDS THE FIREING ORDER AND VOLTAGE AND SETS THE TIMEING SPECK I WOULD SAY CHECK THE COMP

May 21, 2009 | 1997 Dodge Ram 1500 Club Cab

3 Answers

Dodge ram turns over but won't start


The crankshaft position sensor may have been damaged during the tranny swap. It is on the top right side of the block at the rear of the engine.

May 01, 2009 | 1997 Dodge Ram

1 Answer

1988 Doge Ram will not turn over.


check your starter relay in the power distribution center. if you are not getting any crank. with a test light or dvom you can check the small signal wire on your starter solenoid when the key is in the crank position there should be power on this wire. it sounds like you are not getting signal to the starter from the ignition switch

Apr 16, 2009 | 1988 Dodge Ram 50

Not finding what you are looking for?
Cars & Trucks Logo

281 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...