Question about 1999 Nissan Pathfinder

Open Question

Immobiliser problem Nissan terrano 2.7 diesel 3 door(1998 Salomo

On recent occasions - but not every time - when car is locked/unlocked with immobiliser the engine will not start. Ignition lights come on but when key is turned in ignition the starter motor is not active and engine doesn't turn over

When car is locked/unlocke dwith key only the car starts perfectly everytime but of course alarm goes off until key inserted in ignition

Any suggestions for a fix

Posted by on

5 Suggested Answers

jdwills
  • 15 Answers

SOURCE: nissan terrano headlight

check out
http://www.sferamydlo.com.pl/Zbyszek/Nissan/R20/el.pdf


Bulb Replacement
The headlamp is a semi-sealed beam type which uses a replacable
halogen bulb. The bulb can be replaced from the engine compartment
side without removing the headlamp body.
I Grasp only the plastic base when handling the bulb. Never
touch the glass envelope.
1. Disconnect the battery cable.
2. Disconnect the harness connector from the back side of the
bulb.
3. Pull off the rubber cap.
4. Press end of the retaining pin together to release bulb.
5. Remove the headlamp bulb. Do not shake or rotate the bulb
when removing it.
6. Install the new bulb in reverse order of removal.

Posted on Nov 11, 2008

emissionwiz
  • 63681 Answers

SOURCE: loud diesel knock nissan terrano II head just replaced.

This sounds like an injection pump issue or a dripping fuel injector, just because the injectors where serviced doesn't mean it still can't be an issue.

Posted on Nov 25, 2008

  • 158 Answers

SOURCE: Terrano overheating

this problem can be caused caused by the following 1 radiator blocked internaly and needs servicing 2 thermostat jammed closed 3 radiator cap u/s the radiator may look fine but blocked @ the bottom where you cant see it.
good luck Lindz

Posted on Mar 28, 2009

TheComforter
  • 18 Answers

SOURCE: 91 nissan terrano wont start

First things first; 1) check Terminals and make sure tight & clean 2) Make sure the batteries good 3) Make sure connection from battery to starter is secured 4) Make sure its not the starter clicking if it is change it. 5) Make sure starter relay is good located with all fuses!

Posted on Jun 16, 2009

  • 1596 Answers

SOURCE: after changing .battery on key fob unable to

Be SURE the BATTERY is NOY in BACKWARDS this is Common

Posted on Aug 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

New battery,lights come on when I turn the key,as well as the fuel pump.then nothing no sound.i just rode it an hour aga


First of all, check the cleanliness and security of the battery cables - particularly the black earth lead where it connects to the engine/bodywork.

You have a fob for the vehicle? It may be because you changed the battery that the system - the immobiliser - is not recognising the key.

Put the key into the ignition and turn on. Then press the LOCK button on your fob a couple of times. Wait 1 minute.

Then press the unlock button on the fob a couple of times. Wait 1 minute.

Turn off ignition.
Turn ignition back on and press the unlock button on the fob and hopefully, the engine will start because the key is recognised

Feb 28, 2016 | Cars & Trucks

Tip

I removed the battery and now the car won't start


'I disconnected the car battery/changed the car battery and now my car won't start'

Another common question on Fixya.
You've done nothing wrong. It's simply that the immobiliser doesn't recognise the key.

Put the key into the ignition. Turn the ignition on. Press the LOCK button twice on your remote. Wait 1 minute.

Turn the ignition off and press the UNLOCK button on the remote a couple of times. This will disarm the immobiliser.

The key should be recognised and your vehicle will start.

on Feb 19, 2016 | Cars & Trucks

1 Answer

The immobiliser in my 2004 Kia Rio doesn't disengage when I try and turn on the ignition. I have try combinations of locking with central locking unlocking with key until the ignition will turn over. Very...


2004 kia rio's sold in the us do not have a factory installed immobiliser. you may have another issue, if it is an automatic transmission I would check the neutral safety switch, the next time is does not start, put the car in neutral and see if it starts, if it does you may have a bad switch.

Jan 14, 2011 | Kia Rio Cars & Trucks

1 Answer

Hi, We have a renault megane dynamique cabriolet. The distributor belt went recently so we replaced the engine for a used renault megane dynamique hard top. Worked fine to begin with, then suddenly one day...


To check to see if the immobiliser is causing the car not to start there is a small red LED in the centre of the instrument panel normally with the Car locked the LED light should be flashing everyone second this is normal behaviour, Now with the key in the ignition and ignition on normally the led light will go out giving the immobiliser authorisation to start if in this procedure the LED light is flashing rapidly then there is a problem with most likely the key if you have a second key I suggest you test it,

Mar 17, 2010 | 2003 Renault 181

3 Answers

Flat battery caused immobiliser problems


1-insert and remove key from ignition two times

2-close and open driver door two times

3-insert and remove key once from ign.

4-close and open drvr door twice

5-insert key into ign.,then close driver door

6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.

7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.

8-press lock/unlock together and hold for a second

9-release,and press lock on remote,the door locks will cycle confirming program.continue to do other remotes you have,steps 8 and 9.if only one in possession,you are done. To end mode open door or insert key into ignition.

You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works

Aug 10, 2009 | Renault Sport Cars & Trucks

3 Answers

Non starting Terrano


not unless you are a skilled electrical engineer. the immobiliser is within the computer.

Aug 09, 2009 | 1993 Nissan Pathfinder

2 Answers

Movano van


i have just bought a v reg vauxhall movano when i put the key in the ignition the immobiliser light goes out but the engine wont start any ideas

Feb 27, 2009 | 1999 Oldsmobile Intrigue

1 Answer

Immobiliser wont go off , wont unlock the doors.


There is a way to override the code, however you need the code number. The only other way is to sit in car with door shut, play with the central locking button on dash, locking and unlocking. While doing this occassionally turn the ignition on and off. If you do it long enough, you may find the immobiliser light goes out, if it does, quickly start the car.

TL

Jan 13, 2009 | 2000 Renault Sportwagon

3 Answers

97 Toyota 4Runner starting problem


Could be the engine management system or the immobiliser?
Sian

Oct 19, 2008 | 1997 Toyota 4Runner

Not finding what you are looking for?
1999 Nissan Pathfinder Logo

Related Topics:

803 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21986 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...