Question about 1993 Mazda 323

Open Question

1993 Mazda 323 1.6L 5 speed manual,stalls whilst driving.

Had immobiliser switch replaced in July last year for same problem.Don't know where it is?Would like to save $70.00 fitting a $5 part!The help would be appreciated greatly:)

Posted by on

5 Suggested Answers

chiquititas
  • 1010 Answers

SOURCE: Need wiring harness for 1993 626 with 2.0/5 speed manual

If i were you i would advising with a dealer or mechanic.

Posted on Jun 17, 2008

  • 2 Answers

SOURCE: 2002 Mazda Protege 5: I

I would check the sway bar linkages, they are usually the first to go, and they are only $40. Its an easy 'do it yourself' project, remove the old one with torches or a grinder (with a small cutting wheel). You can also use a vise grip and sockets but it takes longer.

You can't tell these are damaged until you remove the part. I change mine every 100 000km or so.

Posted on Dec 12, 2008

husni_g2002
  • 112 Answers

SOURCE: radiator fan dosn't work

ground the wire sensor and see if fan work if not change the relay, first check fues.

Posted on Jan 17, 2009

  • 14036 Answers

SOURCE: 1993 mazda 323 no start condition

sound like timing problems. check timing belt or needs changing.

Posted on Apr 09, 2009

  • 334 Answers

SOURCE: Need confirmation that 5 Speed Transmission out 1993 Mazda Protege SOHC 1.8 liter Will Bolt up to the Same L-4 Block Engine /Mounts in the 1990 Mazda Protege LX 1.8 liter DOHC

try calling a junkyard and see if they will tell you the enterchange ok good luck

Posted on Apr 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gear speeds


you may have a bearing in the trans that has failed allowing the main shaft to sag

Jul 20, 2013 | 1993 Mazda Protege

1 Answer

Per diagnostic codes i have replaced CTS and MAF on 1993 Mazda 626 2.5 6cyl, now it stalls and quits at a stop, does this have to do with clearing the codes after the work is done, does the computer need...


u followed the pin point tests for these codes you had? did you disconnect the battery after you installed new parts? sounds like u have not fixed the problem, you do have a repair manual correct? did you check the intake air hose for cracks on the bottom which will cause a stall? did you clean the idle speed control valve and the throttle valve, they can also cause this stall, never adjust the the hard stop screw, it will chnage nothing and cause all kinds of other problems, it is not the problem, most likely the intake is sludged up clean it and then disconnect battery for 5 minuter, driv about 50 miles and problem should clear up, if it doesn't you have other issues, recheck for codes.

Oct 19, 2009 | 1993 Mazda 626

2 Answers

Miata has 61000 miles want replace timing belt to be on safe side


California has a law that Mazda guarantees the timing belt will last 105,000. I drove my 1999 Miata that long before I replaced it. Mazda ia a non interactive motor which means that if the belt breaks the car stalls and won't go anywhere. No damage to engine if it breaks.

Mar 31, 2009 | 1999 Mazda MX-5 Miata

1 Answer

MY 1993 dodge dynasty will drive forward for about a block and slip out of gear, you can then pull over stop the car and put it in park and then start the car again and it will go another block. It will...


You are going to need to have the trans pulled again. There aren't any electrical problems that can cause no reverse. Also it sounds like the 2/4 clutch is burnt and when it slips it puts it in limp and 2nd is gone. Hopefully the shop that did it in July will help you with a warranty.

Mar 24, 2009 | 1993 Dodge Dynasty

1 Answer

'04 Mazda3 had very low engine speed during idling


I have encountered this problem also, try changing your battery. My battery lasted almost 4 year till it was the cause the shot my alternator.

Dec 10, 2008 | 2004 Mazda 3

1 Answer

Engine won't turn over


see if the fuel pump primes the car when u put the key forward listen towards the gas tank do you hear a buzzing sound? if not u need to replace the fuel pump..
replacing the spark plugs on the motor is not fun at all i bet u guys had a real good time doing that haha..

Jul 01, 2008 | 1993 Mazda MX-6

Not finding what you are looking for?
1993 Mazda 323 Logo

Related Topics:

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...