Question about Cars & Trucks

Open Question

Ford ikon loses power when reaching the hilltop and there's a petrol smell

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 77 Answers

SOURCE: 2000 F-250 7.3 diesel, cuts out runs rough no power

Well, you have to let diesels warm up before you drive them so the engine gets warm and it may not sound right at first because if its not warm the compression gets off and doesnt fire right. If you try to give it too much gas before its warm, extra diesel will get in the cylinders and misfire. Then when it does fire, there is a lot of extra fuel in it so that causes the smoke and smell. You should always let it warm up for a bit before driving when you havent driven it for a while.

Posted on Oct 20, 2008

Ad
  • 2 Answers

SOURCE: lose power while driving

Hi. I had the same problem on my 2004 Dodge Ram 3500 Cummins. I went to the dealer and they did a bunch of diagnostics and they replaced my fuel pump. At the same time they put in a retrofit kit that moved the fuel pump to the inside of the gas tank. I have not had the problem since. The cost was about $1,200, but my 100,000 mile drivetrain warranty covered it and I had to pay the $100 deductible.

Posted on Dec 27, 2008

jonbrown725
  • 73 Answers

SOURCE: 1994 ford ranger extended cab 6 cyl fuel injected 2 wheel drive automatic

This year of ranger had a few flaws, In one case, a break power booster was robbing the vacumm, you can test this by plugging it off and seeing the differance, but you will have limited brakes. This model year had a problem with a vacuum leak on the manifold. You can check these in many ways, but please don't use starting fluid. The rear of the manifold usually on the drivers side where it seals to the block.
Also, in 2 other cases a cracked head has gave me the same problem. It is caused from a loss of vacuum.

Posted on Jan 15, 2009

tneubauer
  • 437 Answers

SOURCE: I have a Ford F250 Extended cab that started Running Rough

P0301 = Misfire cylinder #1P0303 = Misfire cylinder #2
P0171 = System too lean cylinder #1
Are you sure on the P1151 code? I am thinking this may be a P0151 which is O2 sensor related.
This looks like you have a fuel system related misfire. I would do a fuel injection cleaning service and then clear codes and see if the codes regenerate.

Posted on Jun 06, 2009

  • 30 Answers

SOURCE: 01 ford ranger 4x4 4.0V6-- rough idle like it

I agree. Try replacing the spark plugs, install new spark plug wires, change the air filter, change the fuel filter, and test the battery and alternator. Run a bottle of fuel system cleaner and water remover through it. To replace the spark plugs you'll most likely have to go through the wheel wells cause of their hard accessibility from the top. The fuel filter is located on the inside of the frame on the driver's side. Hope this helps. God bless

Posted on Oct 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Ford Ikon 1.6 petrol is cranking, but not starting what could be the cause? and what need to be checked. please help


check for your fire (spark) from the coils, you have to have spark, fuel and air for an engine to run, if you have fire make sure you have fuel pressure

Oct 03, 2017 | Ford Cars & Trucks

1 Answer

My ford icon 1.6i only accelerate at 2000 rpm and idel between. 0.900/1000rpm and use accessive fuel..pullaway is weak??


Problem with my Ford Ikon 1.6? ' Yahoo Answers

https://answers.yahoo.com/question/index?qid...
Jun 10, 2012 - The same problem presist on slow speed also. ... Still the problem presist on sudden acceleration and when we strart up in signals. .... Ford ikon 2002 clx 1.6i starting problems start quick on running can it be the starter?

Ford Ikon fuel consumption, miles per gallon or litres/ km ...

www.cfcr.eu/ford-ikon-fuel-consumption-miles-per-gallon-or-litres-km
Ford Ikon fuel consumption, miles per gallon or litres/ km ... How much fuelconsumed Ford Ikon 1.6 i, liters / 100 km or miles per gallon. Ford Ikon 1.6i it is a ...

Oct 24, 2015 | Ford Cars & Trucks

1 Answer

Ford ikon 1.3 petrol firing oudar cheking pliz help


Are you ashing for Ford Ikon 1.3 gas engine firing order ?? Year ?? VIN # ??

May 28, 2015 | Ford IKON Cars & Trucks

1 Answer

My ford ikon flair 1.3 petrol shows black smoke from its silencer during starting and running at low gears?


black smoke is an indication of excessive fuel
it can be from excessive fuel pressure faulty injectors and sensor problems
run the fault codes to find where the fault is and repair the items or replace

Apr 14, 2015 | Ford Cars & Trucks

1 Answer

Free download ford ikon 1.3 clxi service manual


Hi,

I have a Ford ikon 2004 1.6 and I am looking for the user manual.....anyone?

Mar 18, 2012 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...