Question about 1987 Lincoln Town Car
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The inertia switch should be located in the trunk, on the right-hand side, behind the feltlike trim material.
Posted on Jul 09, 2009
I will make an assumption here, we know what the root word means. This code was extracted from the computer by? What this is telling you one of 2 things: The Bank 2 oxygen sensor down stream of the catalytic converter (there are 2 converters, one for each bank of cylinders on the 4.6ltr engine) is bad and/or that the Bank 2 catalytic converter is no longer doing the job it was designed to do. Simply, Catalysts wear out. They are good for approx 100,000 miles (as required by Federal Law). Again, I assume that the reason the intake manifold was replaced was because it had a crack in one, or more, of the runners? (part that feeds the head of a manifold). It may have taken a while to find this as being the cause of why the car running incorrectly, maybe rough. This means, that during the time the car was being driven with the problem, the amount of unburned, or not within spec exhaust gases, coming off the side of the engine affected by the intake issue was higher than normal. This out of balance level of exhaust gases were being dumped into the converter on that side of the engine, thus causing the converter to have to run hotter, work harder, or even at the time the gas was being processed through, causing deposits to be formed in the converter, thus shortening it's life span. The Bank 1 side of the engine, apparently, did not have the issue and it's catalytic converter's life was not affected. I hope this makes sense to you.
Posted on Aug 19, 2009
It looks like you changed everything involving the hot water. When the engine is warm, you should be getting hot water going through the heater core. By holding each hose from the heater core you should feel heat from both hoses. I did not see a new thermostat listed.
You need to also have the ductwork under the dash moving correctly. If you find that the water lines from the heater core are both hot, then you need the (doors) or flaps in the ductwork to route the heat inside. I do not see that anything was looked at under the dash.
Posted on Dec 16, 2009
the enginr oil pressure switch runs the fuel pump till the oil pressure is up to the normal operating range. When the pressure is up the relay kicks in and takes over the power to the pump. The oil pressure switch my be at fault if you can no hear the pump running when you turn the key on
Posted on Jan 31, 2010
Tips for a great answer:
Feb 21, 2016 | 2005 Lincoln Town Car
Feb 08, 2016 | Lincoln Cars & Trucks
May 30, 2011 | 1987 Lincoln Town Car
Nov 27, 2010 | 2000 Lincoln Town Car
Aug 04, 2010 | 1994 Lincoln Town Car
Apr 23, 2010 | 1987 Lincoln Town Car
Dec 02, 2009 | 1997 Lincoln Town Car
Jul 12, 2009 | 1997 Lincoln Town Car
May 14, 2009 | 1987 Lincoln Town Car
Jul 06, 2013 | 1987 Lincoln Town Car
37 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: