Question about Jeep Grand Cherokee

Open Question

Where is the thermostat on a 2003 jeep grand cherokee

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
ZJLimited
  • 17970 Answers

SOURCE: how do I change the

Check this info, is in spanish, but the images can help you:

Jeep-WJ-2002-Cherokee-Service-Manual-PDF-07-Refrigeration System (page 4/ubication - page 35 and next)

Jeep-WJ-2002-Cherokee-Service-Manual-PDF-07A-Refrigeration System (page 26 and next)

Good luck!!!

Posted on Nov 05, 2008

Ad
  • 1118 Answers

SOURCE: how do I change the

follow top radiator hose from radiator to engine wear hose ends, it will be clamped to whats called the gooseneck, thermostat is under that. you will have to drain coolant, not all, maybe 1 half gal. before you remove it. 2 bolts new gasget new thermostat, just remember spring on new thermostat goes in engine.

Posted on Feb 01, 2009

mcgyver468
  • 710 Answers

SOURCE: 2003 Jeep Vacuum Diagram

THERE SHOULD BE A EVAP/VACUUM DIAGRAM UNDER THE HOOD ON A WHITE STICKER. SOMETIMES THEY ARE ON THE BOTTOM SIDE OF THE HOOD ITSELF. I HOPE THIS HELPS. PLEASE KEEP ME POSTED THANKS FOR USING FIX-YA AND FOR AN HONEST RATING/COMMENT. GOOD LUCK

Posted on Aug 29, 2009

  • 32 Answers

SOURCE: need to replace crank sensor on 2003 jeep grand cherokee

its easy, its underneath the passenger side located halfway up the transmission bell housing unplug, u will need to use a 1/4inch drive ratchet and socket to loosen the bolt and simply remove and reinstall with the new one

Posted on Oct 05, 2009

riceski
  • 1851 Answers

SOURCE: my jeep grand cherokee started overheating at idle

try the water pump - first - make sure the radiator is really full - take the cap off cold and fill - if it looks full - start and run 8 minutes or so - then fill it up - look at ur fan belt - is it tight - tight is about how much pressure u use to make a firm hand shake with little movement - any movement over about an inch is loose - when the jeep warms up the belt can slip and not even make a noise - - new materials don't always squeal. - then be sure ur water pump is ok - they go slowing - the fins wear down - one more thing is the radiator - u don't say how many miles or what maintenance schedules you have or not so that's it for now

Posted on Dec 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Could you tell me where the coolant temperature sensor is located at on an inline 6, 4.0L 2003 Jeep Grand Cherokee Laredo?


zjlimited_1234.jpg

Fig. The coolant temperature sensor is installed in the thermostat housing (click image for zoom).
  1. Partially drain cooling system until coolant level is below cylinder head.
  2. Disconnect coolant temperature sensor wire connector.
  3. Remove sensor from thermostat housing.
Hope helps (remember to rate ths answer).

May 12, 2011 | 2003 Jeep Grand Cherokee

1 Answer

I'm trying to locate the thermostat on my 2000 jeep grand cherokee


  1. On 2000 Jeep Grand Cherokee 4.7L V8
  2. Remove lower radiator hose clamp and lower radiator hose at thermostat housing.
  3. Remove thermostat housing mounting bolts, thermostat housing and thermostat.

2000 Jeep Grand Cherokee 4.0l v6
Note:on the In-line 6 4.0L model the thermostat housing is mounted at the top of the engine block next to the water pump.

Nov 14, 2010 | 2000 Jeep Grand Cherokee

2 Answers

2003 Jeep Cherokee overheats when idling


usually its the fan itself, bearings likely got muddy... I have had that on a Cherokee and a liberty.

Aug 16, 2009 | 2003 Jeep Grand Cherokee

1 Answer

2003 Jeep Grand Cherokee check engine light stays


go to autozone they will check codes for free

Jul 23, 2009 | 2003 Jeep Grand Cherokee

1 Answer

OVER HEATING ISSUE!!! 2003 JEEP GRAND CHEROKEE


Since you added coolant, now it is time to check the fans. If the fans do come on, than your thermostat needs to be replaced, Should be done every 4 years anyways.

Jun 03, 2009 | 2003 Jeep Grand Cherokee

2 Answers

Normal coolant temp for 2003 Jeep Grand Cherokee city/highway V6


Your Jeep should have a 192 or 195 degree thermostat. Do u have to add coolant once in a while? If there is no coolant loss, no overheating problem, u shouldn't have to worry about it, it could be the temp. sending unit is not accurate. If it concerns u it would probably be worth it to remove the thermostat, check the temp rating on it(it should be stamped on it). Replace w/ a new one, and see what it indicates for temp then. Good luck, let me know what u find Curt

Mar 13, 2009 | 2003 Jeep Grand Cherokee

1 Answer

Heater not working


Depending on what package the Jeep came with, you could have a broken or disconnected vacuum line to the heater doors.
If it's electronic, there could be a blend door accuator not working.
There could be a bad heater control valve or just a engine thermostat that's staying open all the time.

Oct 14, 2008 | 2003 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...