Question about 1992 Honda Prelude

1 Answer

Does a honda prelude have main crank shells

My friend has a honda prelude and when he goes over 3000 revs it starts knocking at the bottom,any ideas please

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 404 Answers

Hello,
The engine described has Crank shells but is is more likely to be the big end (Con Rod) shell or shells worn.
If the vehicle is driven with this fault it may throw a leg out the bed i.e. Snap the con rod sending the other half through the crankcase there by completely totalling the bottom half of the engine.
Paul 'W'
Onyer~EDson(:0) {#><
Please remember to politely rate my effort.

Posted on Jan 21, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I put my 1989 Honda Prelude engine (auto) into a 1988 shell with manual transmission, and now my revs stay high only when driving and changing gears. Was wondering if it is a vacuum hose issue and how


may need to swap the computer also.. manual computer is different..but yes.. be looking into any vacuum leaks..block off any open ports you find..

Dec 09, 2013 | 1989 Honda Prelude

1 Answer

1994 cavalier 2.2 oil light on-car shuts off when gets warm


blew something in lower end --oil pump damaged --no oil or low level --check oil pressure then do compression test as well --since knocking noise is usually called rod knock

Sep 03, 2017 | 1994 Chevrolet Cavalier

1 Answer

My 01 honda prelude wont start. It will not crank everything is on there is no dimming, I just need to know what the problem is? Its an automatic


Honda has a lot of problems with main relays. Provided you have good voltage in the battery you can try to see if it will start in neutral, if it does the saftey switch could be defective. Another possibilty is the starter. If you can hold the key in the crank position while someone taps on the starter it may start. If it does then replace the starter.

Aug 25, 2011 | 2001 Honda Prelude

1 Answer

My B21 is nocking like crazy what could it be?


Wow, you have the rare 2.1. Could be: bottom end (rod bearings), main bearings, piston slap from a scarred cylinder wall (worn rings from massive overheating or no oil). If it were valves it would be ticking, if you have knocking it's serious. If you heard it and didn't run the car anymore you could have got away with changing the bearings. Sounds like your crank is shot and will need turned if you decide to have the engine rebuilt.

Jun 07, 2010 | 1991 Honda Prelude

2 Answers

Honda Prelude 1992, doesn' start!


Sounds like a crank postion sensor. Is this only when the car is hot/reached operating temperature

Aug 07, 2009 | 1992 Honda Prelude

2 Answers

Knocking noise from engine 1995 honda prelude


This may also be a warped flywheel.

Jun 15, 2009 | 1995 Honda Prelude

1 Answer

90 Honda Prelude misses sometimes


Maybe the crank speed sensor is faulty - would confuse ECU and show wierd rev counter results. Any engine check-light (MIL) or stored error codes?

Jun 09, 2009 | 1986 Honda Prelude

1 Answer

1988 Honda Prelude won't start


Not really enough info! Does it crank over asnd not start??? Frankster016

Oct 19, 2008 | 1988 Honda Prelude

1 Answer

Starting problem


Had similar problem with a Gemini. Try releasing the petrol filler cap before starting to equalise fuel tank/fuel line pressures.

Jun 15, 2008 | 1989 Honda Prelude

Not finding what you are looking for?
1992 Honda Prelude Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...