Question about Toyota T100

Open Question

Toyota tazz alternator not charging - T100 Toyota Cars & Trucks

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Toyota 2002 Tazz Manual

http://www.motorbooks.co.za/details.php?prod_id=4879

Posted on Jul 25, 2010

SOURCE: Toyota 2002 Tazz Manual

my tazz gooi een van die vonkproppe nat met olie. wat ek ek doen om die probleem op te los?

Posted on Jan 22, 2013

cpsnyman
  • 1 Answer

SOURCE: Toyota Tazz window winder

Toyota Tazz driver side window refused to wind properly. Problem was that winder mechanism and window separated - old glue. Found some input from Ben on this forum. Some pointers after doing the job today.
Step 1 - remove the arm rest - two screws
Step 2 - remove the screw holding the door opener handle.
Step 3 - remove the C-clip holding the winder handle. The clip is round but the ends are slightly bent outward - to fit back easily. Use a large screwdriver to force a small opening (thus moving the panel slightly inward). I took a piece of thin solid wire and bent it into a loop. This looped wire I hooked around the one end of the clip and pulled in the opposite direction towards the inside of the car. The open end is towards the part of the handle you wind. Make sure the top of the handle faces towards the interior of the car (door is open wide). The clip shot off (as Ben warned) but landed in the car.
Step 4 - the door handle (square) must be slid forward and outward towards you. Will now be loose but is held by the rod going to the lock.
Step 5 - loosen all clips carefully by pulling the panel forward - large screwdriver works.
Step 6 - lift up the panel - and push the door handle holder through the hole in the panel. The panel will now be free.
Step 7 - the window can be removed in this case where window and mechanism seperated by simply pulling the window upwards and outwards.
Step 8 - I used a small grinder and removed most of the glue - but not all.
Step 9 - put the window back into the door making sure it is correctly aligned in the side-sliders.
Step 10 - I used an epoxy 2-part glue (Pratley) and placed some glue in the holders. Position the window and mechanism correctly (using glue I left as marker). Note that only 2 holes in door panel can be used to see or fit glue.
Step 11 - Mix more glue and apply front and back. Now place some grease in the mechanism rail (horizontal) and wind window to the top. Leave to dry.
Step 12 - replace all in reverse. Clip pushes on easily - I used a small long-nose pliers.

Cheers,
Chris Snyman

Posted on Feb 03, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How many intake valves does a toyota tazz 2e engine 2004 model have


earlier 2Es have one inlet one exhaust
after the east west front wheel drive were introduced
most 2E toyota engines have three valves per cyl
two inlets and one exhaust

if you need the correct information on your 2004 2e engine
,,,,undo the rocker cover

e397a648-22cf-4373-b847-0ca46d719837.jpg

Jun 28, 2016 | Toyota Cars & Trucks

1 Answer

Too heavy on fuel


there is no carb. in modern cars, unless...
2005 Toyota Tazz 130
what country are you in, cabs ended in 2006 in far from USA countries.
so that you? in S.Africa or some small Island in the Pacific running JDM cars?
quote, this you?
A facelifted version of the sixth-generation five-door hatchback was made in South Africa as an entry-level model called the Toyota Tazz from 1996 until July 5, 2006. The Tazz was offered as 130, and 160i. It was also sold as a panel van called the Carri. [4]
end quote.

why not post photo of engine.
or get the FSM on this car, factory service manual, at Toyota.
it covers all THAT.
if not a carb, you cant tune it, like a carb , you fix it.

my first idea> give it a tuneup, new spark plugs, filters.

Jan 23, 2014 | 2005 Toyota Tazz 130

1 Answer

Replacing rubber track on front windows


where can i find the rubber for the outer frame of the front door of a toyota tazz and at what price?

Jan 18, 2014 | Toyota Tazz Cars & Trucks

1 Answer

Toyota Tazz 2003 model


My left steering arm of my 2003 Toyota tazz 1300 is loose inside the steering rack how do i fix it. Please can u help

Jan 07, 2014 | Toyota Tazz Cars & Trucks

1 Answer

TAZZ SOMETIMES DOES NOT WANT START


Sounds like you need to get your battery fully charged on a battery charger and then tested at a garage. Driving will put some charge in your battery but not fully charge it. After your battery has been flat it is less likely to fully recharge and the alternator is designed to keep the battery topped up rather than fully charge it. Jon

Dec 09, 2013 | Toyota Cars & Trucks

1 Answer

Toyota tazz wiring diagram


You need to ask to Dealer toyota about this change. They will guide better to any solution or answer. Or go to the website in USA, and get support via ONLINE chat.
God bless you

Jul 17, 2013 | Cars & Trucks

1 Answer

Toyota tazz 1300 carb adjustment


can a toyota tazz 2006 automatically adjust tappets

Feb 16, 2012 | 2005 Toyota Tazz 130

1 Answer

Hi my toyota has probelms starting in the morning, my headlight beam strenght varies between weak and strong throughout the day, and this moning my hazard lights came on and would not go off and would not...


Sounds like the starter battery can't hold the charge from the alternator. A 1 hour highway drive should charge the battery enough - if it's the same the next morning it's up for replacement. Assuming there are no lights, radio or other devices on in the car during the night.

If the battery has been recently replaced - the alternator might not supply enough current anymore. In this case alternator brushes might need replacement or the voltage regulator has died. Usually the battery indicator lights up in this case. The battery indicator light can be checked by turning the ignition key one notch so all lights in the dash light up. If the battery indicator doesn't light the lightbulb might be dead.

Jul 01, 2011 | Toyota Corolla Cars & Trucks

3 Answers

Toyota 2002 Tazz Manual


http://www.motorbooks.co.za/details.php?prod_id=4879

Aug 28, 2009 | 2002 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

289 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...